高质量CdTe量子点的水相快速合成

系统考察了水相合成CdTe量子点的主要影响因素, 通过改变无水乙醇-水体系的体积, 提高NaHTe的合成质量, 并调整反应温度, 改变反应的初始pH值, 在水相中快速合成了量子产率高、粒径分布范围窄的CdTe量子点, 实现了对量子点发光性质的调控, 在最佳条件(无水乙醇3 mL, 水1 mL, 反应初始pH 8.0, 反应温度40 ℃)下, 最高量子产率达68%. 量子点胶体溶液在回流过程中有时产生白色沉淀, 放置7 d后, 未过滤白色沉淀的量子点比过滤后的量子点荧光强度提高15%, 白色沉淀还有减小粒径分布的作用.     

高量子产率水溶性CdTe量子点的制备与表征

以巯基乙酸(HSCH2 COOH,TGA)为稳定剂,在水相中合成高量子产率CdTe量子点(QDs),产率达68%.用紫外.可见分光光度计、荧光分光光度计、红外光谱仪、透射电子显微镜等对制备的样品进行表征.结果表明:CdTe Ods紫外吸收峰及荧光发射峰均随回流时间延长而红移,即粒径在不断增大;荧光发射峰窄而对称,表明QDs分散性好、大小较均一,半峰宽随回流时间延长而逐渐变宽,表明粒径在增大的同时粒径分布范围也变宽;从TEM及紫外.可见光谱推算,可知其粒径约为3 nm;红外光谱图说明作为稳定剂的巯基乙酸对QDs表面起到修饰作用.     

CdTe/CdS量子点的Ⅰ-Ⅱ型结构转变与荧光性质

制备了壳层厚度可以精确控制的CdTe/CdS核壳量子点, 利用紫外-可见吸收光谱、光致发光光谱、透射电镜和时间分辨光谱等技术, 分析了CdS壳层厚度对CdTe量子点的荧光量子产率和光谱结构的影响规律. 发现了不同于CdSe/CdS, CdSe/ZnS, CdTe/ZnS等核壳量子点的荧光峰展宽、大幅度红移以及荧光寿命大幅度增加现象. 根据能带的位置关系, 随着CdS厚度的增加, CdTe从Ⅰ型结构逐渐过渡到Ⅱ型核壳结构. 对于Ⅱ型CdTe/CdS核壳量子点, 不仅存在CdTe核区导带电子与价带空穴间的直接复合, 还存在CdS壳层导带电子与CdTe核价带空穴界面处的间接复合, 发光机制的变化导致荧光峰的展宽、明显红移和荧光寿命的增加. 当壳层过厚时, 壳层表面新引入的缺陷会阻碍荧光寿命和量子产率的进一步提高.     

Size-dependent electrochemiluminescence behavior of water-soluble CdTe quantum dots and selective sensing of l-cysteine

Water-soluble CdTe quantum dots (QDs) with five sizes (2.25, 2.50, 2.77, 3.12, and 3.26 nm) were synthesized with the hydrothermal method. The electrochemiluminescence (ECL) of CdTe QDs was investigated in detail in air-saturated solution without adding foreign oxidant. It was found that the ECL of CdTe QDs displayed a size-dependent property. With the increasing in the particle size of the CdTe QDs, the ECL intensity was gradually increased, in addition, both ECL peak potentials and ECL onset potentials of CdTe QDs were shifted positively. Influences of some factors on the ECL intensity were investigated. Under the optimal conditions, the ECL intensity had a linear relationship with the concentration of l-cysteine (l-Cys) in the range from 1.3 × 10⁻⁶ to 3.5 × 10⁻⁵ mol L⁻¹ (R² 0.996) with a detection limit of 8.7 × 10⁻⁷ mol L⁻¹ (S/N = 3). The proposed method was applied to the determination of l-Cys in real samples with satisfactory results. Compared with previous reports, it has better selectivity for the determination of l-Cys.     

硫脲修饰法制备高发光性能CdTe量子点

通过巯基水解制备了具有优异荧光特性的碲化镉量子点. 详细研究前驱体镉离子与巯基丙酸(MPA)摩尔比、镉离子浓度等制备条件对大尺寸、高量子产率的亲水性碲化镉量子点光学性能的影响. 在不同的水热生长时间下, 可制备出荧光发射峰位于485-660 nm范围内的不同尺寸的碲化镉水溶性量子点, 荧光发射峰半高宽控制在40-75 nm之间, 量子点的最高量子产率(QY)达到了45%. 并利用硫脲缓慢水解和光解释放自由硫离子, 修饰碲化镉表面, 检测修饰后的量子点在12天内光学性能的变化情况. 通过考察硫脲用量对量子点修饰效果, 发现当n(CdTe)/n(thiourea)=1:4(量子点浓度以镉离子浓度计)时, 硫脲对发射峰为505 nm的碲化镉量子点修饰效果最为理想, 量子点荧光强度加强了5倍, 量子产率达到68.3%.     

Synthesis of cysteamine-coated CdTe quantum dots and its application in mercury (II) detection

High-quality cysteamine-coated CdTe quantum dots (CA-CdTe QDs) were successfully synthesized in aqueous phase by a facile one-pot method. Through hydroxylamine hydrochloride-promoted kinetic growth strategy, water-soluble CA-CdTe QDs could be obtained conveniently in a conical flask by a stepwise addition of raw materials. The photoluminescence quantum yield (PL QY) of the obtained QDs reached 9.2% at the emission peak of 520 nm. The optical property and the morphology of the QDs were characterized by UV–vis absorption spectra, photoluminescence spectra (PL) and transmission electron microscopy (TEM) respectively. Furthermore, the fluorescence of the resultant QDs was quenched by copper (II) (Cu²⁺) and mercury (II) (Hg²⁺) meanwhile. It is worthy of note that to separately detect Hg²⁺, cyanide ion could be used to eliminate the interference of Cu²⁺. Under the optimal conditions, the response was linearly proportional to the logarithm of Hg²⁺ concentration over the range of 0.08–3.33 μM with a limit of detection (LOD) of 0.07 μM.     

光谱法研究核壳量子点CdTe/CdS与牛血清白蛋白的相互作用

应用荧光光谱、圆二色光谱和紫外吸收光谱等技术研究核壳量子点CdTe/CdS与牛血清白蛋白(BSA)相互作用的结果表明,CdTe/CdS对BSA的荧光猝灭机理为静态猝灭。根据不同温度下量子点对BSA的荧光猝灭作用计算了结合常数、热力学参数,证明了量子点与BSA相互作用力主要是范德华力或氢键作用力。探讨了量子点对BSA构象的影响。     

Stable structure and effects of sulfur in CdTe/CdS heterojunctions

Structural and electronic properties of S in the CdTe/CdS(0001) interface are studied using the density functional theory. The interstitial S atom may induce the inversion of the surface Cd atoms and sublayer Te atoms of the Cd‐terminated surface, while S atoms may adsorb at the top sites, substitute Te atoms or accumulate at the voids inside the Te‐terminated (111) CdTe surface. Isovalent substituting S for Te in the CdTe(111)/CdS(0001) heterojunctions can reduce the strain arising from lattice mismatch and cause a reduction of interface states, so it may be better for solar cells. Copyright © 2011 John Wiley & Sons, Ltd.     

Conjugations between Cysteamine-Stabilized CdTe Quantum Dots and Single Stranded DNA

Abstract

Cysteamine-stabilized CdTe quantum dots were used to directly conjugate with single stranded DNA through electrostatic attraction between positive amino function groups on the surface of CdTe quantum dots and negatively charged DNA. The conjugates exhibited different optical properties from that of CdTe quantum dots, for example, the fluorescence intensity was enhanced obviously with maximum emission peaks gradually red-shifting, and the conjugates were more stable. Under the optimum conditions, the fluorescence intensity was proportional to concentration of DNA over the range 0.16–0.48 µg/mL. This proposed method demonstrated a versatile tool for the fluorescence probing of target DNA and fluorescence labeling.     

P3HT与CdTe纳米枝晶p-n异质结敏化ZnO纳米管阵列的光电化学研究

采用电化学方法首先在ITO导电玻璃上制备了一维有序ZnO纳米管阵列,然后在ZnO纳米管阵列上采用电化学方法沉积纳米枝状CdTe,形成了纳米枝状CdTe包覆ZnO纳米管的CdTe@ZnO壳核式复合结构,最后在上述复合结构中旋涂一层P3HT薄膜形成P3HT包覆的P3HT@CdTe@ZnO复合薄膜. 以此复合薄膜为光活性层组装成半导体敏化太阳电池,研究了该类电池的光电转换性能,对该电池的工作原理进行初步研究,所得太阳电池能量转换效率最高达到1.38%.