变截面钢管混凝土格构柱轴压极限承载力

变截面钢管混凝土格构柱的轴压试验结果表明,随着试件高度的增大和柱肢坡度的减小,其极限荷载逐渐降低.基于上述规律,在等截面钢管混凝土格构柱计算框架的基础上,研究了变截面钢管混凝土格构柱轴压极限承载力的计算方法.提出变截面钢管混凝土格构柱等效长度的概念和等效长度法的计算公式,其承载力计算结果与试验结果吻合良好.最后在有限元数值分析验证的基础上,给出适合工程应用的四肢变截面钢管混凝土格构柱轴压极限承载力的实用算法,为钢管混凝土设计规程的进一步完善提供参考.     

High-temperature measurements of the rates of the reactions CH2O + Ar → Products and CH2O + O2 → Products

The two-channel thermal decomposition of formaldehyde [CH₂O], (1a) CH₂O + Ar → HCO + H + Ar, and (1b) CH₂O + Ar → H₂ + CO + Ar, was studied in shock tube experiments in the 2258-2687 K temperature range, at an average total pressure of 1.6 atm. OH radicals, generated on shock heating trioxane-O₂-Ar mixtures, were monitored behind the reflected shock front using narrow-linewidth laser absorption. 1,3,5 trioxane [C₃H₆O₃] was used as the CH₂O precursor in the current experiments. H-atoms formed upon CH₂O and HCO decomposition rapidly react with O₂ to produce OH via H + O₂ → O + OH. The recorded OH time-histories show dominant sensitivity to the formaldehyde decomposition pathways. The second-order reaction rate coefficients were inferred by matching measured and modeled OH profiles behind the reflected shock. Two-parameter fits for k_1a and k_1b, applicable in this temperature range, are:

     

紫外荧光硫分析仪用燃烧管的结构改进研究

对紫外荧光硫分析仪用石英燃烧管进行了结构改进,在原结构设计的基础上,增加了裂解氧预热管、挡板和氧气反吹口等。实验表明,相比于原结构设计的石英燃烧管进样量20μL和检出限0.2 mg/L,改进后的燃烧管进样量提高到了100μL,检出限达0.05 mg/L,线性范围为0.1～600 mg/L,相关系数大于0.999。采用改进后的燃烧管测定10.0 mg/L硫含量标准物质,其相对偏差为–1.5%～3.1%,测定结果的相对标准偏差为1.77%(n=10),两者均符合油品硫含量检测要求。改进后的燃烧管可替代市场上的其它国产石英燃烧管,进行油品中硫含量的测定。     

An improved sealed quartz‐tube method for the determination of hydrogen isotopes in water

Hydrogen stable isotope analysis has been a valuable tool in the fields of geochemistry and ecological research as well as many other research fields. The methods are mainly divided into the dual‐inlet method (off‐line method) and continuous flow method. The dual‐inlet method is complicated and inefficient, but it is still important because of its high precision and wide application range. Although the continuous flow method improves the experimental efficiency, the memory effect is noticeable and the accuracy is reduced. An improved sealed quartz‐tube method is proposed in this paper. The sample is sealed in a capillary tube and placed in a quartz tube containing chromium powder. It is then packaged, evacuated, reacted at a high temperature, and analyzed for hydrogen isotope ratio. Excellent data accuracy, good reproducibility (<1‰), and no memory effect occurred in the method. The process is relatively simple, and the experimental efficiency is greatly improved, which provides an effective method for the analysis of hydrogen isotopes in complex liquid samples.     

火灾与撞击联合作用下钢管混凝土柱力学性能研究

为研究火灾高温与撞击联合作用下钢管混凝土柱的力学性能,基于ABAQUS建立了高温作用下考虑轴力影响的钢管混凝土柱侧向撞击有限元模型。首先,对高温与撞击联合作用下考虑轴力影响的钢管混凝土柱的破坏模式与受力全过程进行了分析,探讨了高温下钢管混凝土柱的抗撞性能与工作机理;其次,重点研究了受火时间、材料强度、含钢率以及撞击能量对抗撞性能的影响,并给出了相关设计建议。研究结果表明:高温与撞击联合作用下,钢管混凝土柱主要发生受弯破坏;受火15 min后,构件抗撞性能明显降低。轴压力对构件抗撞性能产生不利影响,轴压比从0增加到0.2,受火60 min构件抗撞性能下降了7.8%;混凝土强度对高温下钢管混凝土柱抗撞性能有显著影响,受火90 min后,混凝土强度由30 MPa增加到50 MPa,构件抗撞性能提高约85%;外钢管强度与含钢率对高温下抗撞性能影响不大。     

Theoretical investigation on submicron particle penetration through circular tubes inside a porous medium

The analytical infinite series solution of submicron particle transport in a circular tube bounded by a porous wall, such as a pinhole, is determined under the slip velocity boundary condition, and the solution is verified by using the experimental data in the previous studies for the specific cases. The results show that particle penetration rate increases with the increase of the porous parameter, the axial pressure drop, and the pinhole radius, whereas it decreases with increasing the pinhole length. The penetration rate of nano-particles are more sensitive to the variation of these parameters. However, the differences between the penetrations of particles ranging from 0.3 μm to 1 μm are not evident because the diffusion becomes weak gradually in this size range. In addition, a further comparison is performed between the analytical solution and the existing studies, and approximate expressions are presented for accurate calculation of particle penetration rate through pinholes appearing in porous materials including filter devices and masks.     

冷弯薄壁型钢中间加劲板件有效面积计算方法

基于超薄壁高强冷弯型钢槽形截面轴压构件承载力试验研究,参考美国冷成型钢结构构件设计规范、澳洲冷成型钢结构规范和北美冷成型钢结构构件设计规范的计算方法,并结合我国现行《冷弯薄壁型钢结构技术规范》的三类不同加劲板件的有效面积计算公式,对中间加劲板件有效面积的合理计算方法进行了探讨,提出了与我国现行规范有效面积计算方法相一致...     

钢管塔十字节点板强度理论与试验研究

针对一种适用于大型钢管塔的十字插板连接形式,阐述了其节点板的受力特点,对十字节点板的破坏模式及计算理论进行了系统分析.为考察节点板的受力性能、破坏模式及极限承载力,以榕江大跨越塔工程为背景,进行了2个大尺寸缩尺模型的静力试验.对试验模型进行了有限元非线性数值分析,试验结果与有限元分析结果一致性很好,两方面的分析结果均表明:该十字节点板构造合理、安全可靠,可用于实际工程.结合试验研究和有限元参数分析结果,提出了该十字节点板的破坏模式,给出了相应的计算理论和极限承载力计算公式,提出了用于实际工程的设计建议公式.     

空间薄壁梁完全拉格朗日格式几何刚度矩阵

根据Timoshenko梁理论和Vlasov薄壁杆件理论,通过设置单元内部节点,对弯曲转角和翘曲角采取独立插值的方法,建立了可以考虑剪切变形、弯扭耦合和二次剪应力影响的空间薄壁截面梁几何非线性有限元模型。以拉格朗日格式描述几何非线性应变推得几何刚度矩阵.算例表明所建立模型具有良好的精度,适用于空间薄壁结构的几何非线性有限元分析.     

高频脉管制冷机的研究进展(下)

介绍了斯特林脉管制冷机(高频脉管制冷机)国内外最新研究现状以及发展趋势。分析了由于高频脉管制冷机的效率可以达到甚至超过斯特林制冷机,从而在空间领域、红外传感器件和高温超导器件的冷却领域获得广泛应用。指出了线性压缩机是高频脉管制冷机的重要部件之一,提高线性压缩机的性能及机械寿命是提高高频脉管制冷机性能和寿命的一条重要途径。