煤直接液化油中混合酚的分离研究

利用分子筛择形特点，对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物，采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变，分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响，以获得高性能固相吸附剂，并将其应用于180-190℃馏分段混合酚分离。结果表明，当分子筛硅铝比为25、粒径为3-5 μm时，分子筛的孔口结构调节效果最优；当正硅酸乙酯的最小用量为0.2 mL/g时，固相吸附剂的吸附量为0.03 g/g，对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化，导致对甲酚选择性的提高。进一步采用HZSM-5（1）吸附剂对真实煤直接液化油混合酚的分离中发现，苯酚和对甲酚的选择性均达到100%。     

上海黄浦江两支流河流甲烷含量研究

甲烷是一种重要的温室气体,虽然目前大气中含量远小于二氧化碳,但排放增长率却大于后者.研究区域为上海市黄浦江支流苏州河和淀浦河,通过实验数据对比城郊春夏的甲烷排放的差异,探讨甲烷产生的机制及其与环境因子的关系,这将有助于研究河流甲烷排放对于环境变化的影响.研究结果认为河流甲烷主要来源于水中沉积物,其产生与水质、温度等因素相关;同时甲烷摩尔浓度与硝酸根离子质量体积比存在负相关性,与铵根离子质量体积比和有机碳质量分数存在正相关性.     

铸造工艺仿真设计前处理及过程处理应用技术

以应用ProCAST和MAGMAsoft 2款软件为例，针对铸造工艺仿真设计前处理和过程处理每个环节的主要内容与使用方法进行了较为详细地归纳、分析和总结。提出了处理过程的技术路线，并系统地介绍了每项应用内容的操作平台与使用步骤，从而为高效地应用铸造工艺仿真设计提供理论和技术支持。     

Formation of low-temperature deformation-induced segregations of nickel in Fe–Ni-based austenitic alloys

ABSTRACT

The authors present the results of an investigation in Fe–Ni-Cr austenitic alloys of the low-temperature deformation-induced segregations of nickel that form in the micro regions being (i) located close to grain- and subgrain boundaries and (ii) characteristic of the concentration and magnetic inhomogeneities indicated by the appearance of a dark diffraction contrast at the electron diffraction patterns taken from these regions typical (at the same time) of an enhanced value of Curie temperature. The observed effects were connected with the micro distortions caused by the local change of lattice parameter because of an increase in nickel concentration, as well as in the result of a magnetostriction dilatation. Using methods of the X-ray energy dispersive spectroscopy (XEDS) and atomic-probe body-section radiography (tomography – APT) has made it possible to determine the borders of those regions of austenite that were characteristic of an enhanced concentration of nickel in the fields of the localisation of a deformation-induced segregation of nickel in the vicinity of grain (subgrain) boundaries of austenitic alloys of the types Fe–13Cr–30Ni and Fe–37Ni–3Ti.     

Response surface methodology toward the optimization of high-energy carotenoid extraction from Aristeus antennatus shrimp

High-energy assisted extraction techniques, like ultrasound assisted extraction (UAE) and microwave assisted extraction (MAE), are widely applied over the last years for the recovery of bioactive compounds such as carotenoids, antioxidants and phenols from foods, animals and herbal natural sources. Especially for the case of xanthophylls, the main carotenoid group of crustaceans, they can be extracted in a rapid and quantitative way with the use of UAE and MAE.     

Studies on metabolites and metabolic pathways of bulleyaconitine A in rat liver microsomes using LC‐MSn combined with specific inhibitors

Bulleyaconitine A (BLA) from Aconitum bulleyanum plants is usually used as anti‐inflammatory drug in some Asian countries. It has a variety of bioactivities, and at the same time some toxicities. Since the bioactivities and toxicities of BLA are closely related to its metabolism, the metabolites and the metabolic pathways of BLA in rat liver microsomes were investigated by HPLC–MSⁿ. In this research, the 12 metabolites of BLA were identified according to the results of HPLC‐MSⁿ data and the relevant literature. The results showed that there are multiple metabolites of BLA in rat liver microsomes, including demethylation, deacetylation, dehydrogenation deacetylation and hydroxylation. The major metabolic pathways of BLA in rat liver microsomes were clarified by HPLC‐MS combined with specific inhibitors of CYP450 isoforms. As a result, CYP3A and 2C were found to be the principal CYP isoforms contributing to the metabolism of BLA. Moreover, CYP2D6 and 2E1 are also more important CYP isoforms for the metabolism of BLA. While CYP1A2 only affected the formation rate of M11, its effect on the metabolism of BLA is very small. Copyright © 2014 John Wiley & Sons, Ltd.     

工程实践中的体系与系统

 介绍了国际上通行的体系概念，通过实例阐述了常见的体系类型，从多个维度描述了系统与体系的区别，根据实践总结，提出体系与系统的核心界定准则，并结合工程实践进行了详细描述。     

考虑外委的露天矿剥岩计划的优化研究

针对“剥岩高峰”对矿山生产带来的不利影响，研究了设备配置更新策略与露天开采外委剥离的优化问题.基于铲运设备的运营成本与生产能力随设备役龄变化的关系，建立了决策单台设备退役时间的动态经济寿命计算模型，并根据此模型给出了具体的设备配置算法步骤.设置一系列不同的矿山自剥离量与外委剥离量的分界水平，计算各分界水平条件下的外委单价可行区间，然后在区间内确定外委商谈价格并分析得出与之对应的总成本净现值最低的外委方案.实例计算证明，采用该方法减少设备投资的成本要高于外委岩石剥离成本.