大体积混凝土温度裂缝的防控措施

结合工程实例,分析大体积混凝土温度裂缝产生的原因及影响因素,总结了有效防止和控制混凝土表面裂缝和收缩裂缝的技术措施.     

温度对PSⅡCP4 7/D1/D2/Cytb559复合物荧光光谱特性的影响

采用激励光源为514.5 nm的分幅扫描单光子计数荧光光谱装置对经20℃、42℃和48℃不同温度处理后的反应中心复合物CP47/D₁/D₂/Cyt b559的荧光光谱特性进行了研究.经解析,获得不同温度处理后,CP47/D₁/D₂/Cyt b559复合物最大峰值未发生变化,均在682 nm,说明Chla670的能量都由Chla682接收,但损耗愈来愈小,在48℃时,损耗程度最小,而其荧光百分比未发生多大变化.振动副带～700 nm和～740 nm的中心波长都发生蓝移,在不同温度下分别为:20℃ 703 nm,749 nm;42℃ 697 nm,744 nm;48℃ 694 nm,740 nm.因此可以推测温度的升高,影响了CP47/D₁/D₂/Cyt b559色素蛋白的二级结构以及色素分子的空间位置,使最大峰值处的荧光强度逐渐降低,振动副带逐渐蓝移.42℃的温度已造成影响,48℃影响较大.     

Pyroelectricity and Spontaneous Polarization in [111] Oriented 0.955 Pb（Zn1/3Nb2/3）O3-0.045PbTiO3 Single Crystals

We report that the measurements of the pyroelectric current of the pre-poled [111]-oriented 0.955 Pb（Zn1/3Nb2/3） O3-0.045 PbTiO3 （PZN-4.5%PT） single crystals can shed some light on the phase transition and spontaneous polarization characters of this material in a similar way to measures of remanent polarization and dielectric properties. The pyroelectric current is measured and the corresponding spontaneous polarization is calculated as a function of temperature with various poling fields added during cooling the sample from 200℃ to room temperature. Critical electric field of 0.061 k V/cm is found to be essential to induce the intermediate ferroelectric orthorhombic phase between the ferroelectric rhombohedral and tetragonal phases. Below the critical field, the polarization increases almost linearly with the increase of poling field. At the critical field, the polarization at 30OC increases abruptly from 14μC/cm^2 for a poling field of O.06kV/cm to 29.5μC/cm^2 for a poling field of 0.061 kV/cm, and afterwards, increases slowly and saturates to 31 μC/cm^2 for poling fields beyond 0.55 kV/cm.     

Temperature-Dependent Dynamic Properties of LixMn2O4 in Monte Carlo Simulations

Monte Carlo (MC) simulations are used to simulate the voltage profile and the ionic conductivity s of Li ions in LixMn2O4 and its dependence on the lithium concentration x. The open circuit potential shows clearly the two plateaus in the charge/discharge curve, which agrees well with the experimental results. The two plateaus become more and more steep when the temperature is increased. The simulated ionic conductivity shows an M-shaped curve in the plot of ionic conductivity cr versus x when the simulation temperature is low. Interestingly,the minimum valley, which lies at the middle single-phase area near x=0.5, disappears gradually when the temperature increases to 453K.     

离子束增强沉积VO2多晶薄膜的温度系数

用改进的离子束增强沉积方法和恰当的退火从V2O5粉末直接制备了VO2多晶薄膜.实验测试表明，薄膜的取向单一、相变特性显著、结构致密、界面结合牢固、工艺性能良好，薄膜的电阻温度系数（TCR）最高可达4.23%/K.从成膜机理出发，较详细地讨论了离子束增强沉积 VO2多晶薄膜的TCR高于VOx薄膜的TCR的原因.分析认为，单一取向的VO2结构使薄膜晶粒具有较高的电导激活能，致密的薄膜结构减少了氧空位和晶界宽度，使离子束增强沉积 VO2多晶薄膜结构比其他方法制备的VOx薄膜更接近于单晶VO2是其具有高TCR的原 关键词： VO2多晶薄膜 离子束增强沉积 热电阻温度系数     

双阳极磁控注入枪束流特性的研究

 介绍了用于34GHz基波回旋速调管的双阳极磁控注入枪的结构特点，为了准确分析磁控注入枪的束流特性，建立了阴极表面理论模型，用新编制的程序模拟了电子轨迹。模拟和测量结果显示磁场对磁控注入枪的束流有影响，磁控注入枪的束流也与阴极温度和空间电荷效应有关系。     

合金铸铁激光处理的探讨——Ⅱ.激光辐照工艺参数的控制

用热传导方程控制激光辐照温度,建立了一种新回归方程以控制激光辐照硬化深度,选用卡尔丹公式列热传导方程及同归方程联立求解,可得到同时满足一定的硬化深度及表面最高温度双重要求的工艺参数,此种方法可作为激光硬化处理工艺参数的控制或预报,对本合金铸铁的激光硬化处理,其表面温度的下限应大于其熔点温度,即以表面产生微熔的快速冷凝处理为宜,并以选取低功率慢扫描为最佳。