四角状纳米ZnO的制备及其场发射性能

利用热蒸发法制备出了新颖的四角状ZnO纳米棒. 研究了四角状纳米ZnO的场发射特性. 场发射测试表明四角状ZnO纳米棒具有较好的场发射特性, 开启电场为2.9 V/μm, 阈值电场为5.4 V/μm. 这一结果表明四角状ZnO纳米棒是一种性能优良的冷阴极电子发射源.     

热蒸发法原位生长-维氧化锌纳米材料及其场发射特性研究

利用磁控溅射在ITO电极上沉积氧化锌薄膜,以氧化锌薄膜为种子层,采用热蒸发法合成ZnO一维纳米材料,利用XRD和SEM方法对氧化锌一维纳米材料的微观结构进行分析,测试其场发射性能.结果显示,氧化锌纳米材料为钉子状结构,每个氧化锌纳米钉由几微米大的钉帽和细棒组成,垂直于基底生长.场发射性能研究表明它具有较低的开启场强,高的发射电流和好的稳定性,是一种优良的冷阴极电子发射源.     

激光烧蚀对碳纳米管薄膜场发射性能的影响

采用丝网印刷工艺制作了碳纳米管(CNTs)薄膜阴极.经适当能量激光烧蚀后,相互粘连的CNTs随表面粘附有机物的蒸发而分散开,管间隙增加、屏蔽效应减小,使得场发射性能大幅度提高,开启场强降低、场倍增因子β增大.Raman光谱分析表明,随激光能量增加,CNTs表面缺陷增多,成为新的场发射点,对其β增大的贡献加强.相对于两电极结构,三电极中平栅极结构场发射性能经激光烧蚀有更显著的改善.这说明激光烧蚀是提高CNTs场发射性能的有效方法. 关键词： 碳纳米管薄膜 场发射 激光烧蚀 Raman光谱     

Probing Field Emission from Boron Carbide Nanowires

High density boron carbide nanowires are grown by an improved carbon thermal reduction technique. Transmission electron microscopy and electron energy lose spectroscopy of the sample show that the synthesized nanowires are B4 C with good crystallization. The field emission measurement for an individual boron nanowire is performed by using a Pt tip installed in the focused ion beam system. A field emission current with enhancement factor of 10^6 is observed and the evolution process during emission is also carefully studied. Furthermore, a two-step field emission with stable emission current density is found from the high-density nanowire film. Our results together suggest that boron carbide nanowires are promising candidates for electron emission nanodevices.     

碳纳米管阴极的短脉冲爆炸场发射与等离子体膨胀

采用碳纳米管制备了一种强流电子束发射阴极,并对碳纳米管阴极在双脉冲条件下的强流发射性能进行了研究.在双脉冲条件下获得了245 A/cm²的强发射电流密度,阴极的开启时间约为40 ns.采用高速分幅相机和CCD相机对强流电子束在空间和时间的分布进行了研究.研究表明连续脉冲实验时,离子体及其膨胀对发射电子束的强度和分布影响很大,双脉冲时脉冲间隔时间内等离子体的膨胀速率约为8.17 cm/μs.等离子体形成时没有优先位置,电子束发射的局部增强位置是随机的.结果表明碳纳米管阴极可以作为强流阴 关键词： 碳纳米管 爆炸场发射 等离子体膨胀 强流电子束     

硅基AAO模板内电化学沉积ZnO纳米线及其光电性能研究

本文利用二次阳极氧化法在p型低阻〈100〉晶向的硅衬底上制备了AAO/Si,以硅基AAO为辅助模板,采用电化学沉积的方法以Zn(NO3).6H2O和HMT(C6H12N4)为原料,在80℃的水浴槽中制备了ZnO纳米线结构。采用SEM,XRD和拉曼光谱等手段对ZnO/AAO/Si复合结构进行表征。SEM图表明ZnO纳米线已成功组装到AAO/Si模板里,直径约45 nm,长度约为600 nm。XRD和拉曼光谱表明ZnO具有六角纤锌矿多晶结构。光致发光(PL)谱图表明ZnO/AAO/Si复合结构在565 nm附近有较宽黄绿发射峰,在395 nm附近有微弱的紫外发射峰。场发射测试结果表明,ZnO纳米线的场增强因子的β值为2490,场增强因子很高,具有广泛的应用前景。     

用场发射显微镜研究单壁碳纳米管场发射

利用场发射显微镜在小于4.0×10-7Pa压强条件下研究了单壁碳纳米管微束在不同温度加热除气后的场发射变化,得出随着除气温度的升高,碳纳米管逸出功经历了从大到小再变大的变化过程.在清洁态(1000℃除气)对应有最小的逸出功,此时场发射图像显示出一定的细致结构.继续升高温度,碳纳米管发生塌缩.     

磁场辅助热处理金属化碳纳米管场发射性能

利用化学镀方法对多壁碳纳米管(multi-walled carbon nanotubes,MWNTs)表面金属化镀镍(MWNTs/Ni),采用丝网印刷制备MWNTs/Ni场发射阴极,并在磁场辅助下热处理所得阴极,研究磁场辅助热处理对MWNTs/Ni阴极的场发射性能的影响,经300mT磁场辅助热处理的MWNTs/Ni的场发射阴极开启场强约为0.80V·μm~(-1),场增强因子β约为16068,对单根MWNTs/Ni在磁场中的受力情况进行建模分析,实验结果表明:磁场辅助热处理有助于提高MWNTs/Ni在阴极表面的直立分布,提高了MWNTs/Ni的场发射性能。     

Electron field emission from single-walled carbon nanotube nonwoven

Field emission from single-walled carbon nanotube (SWNT) nonwoven has been investigated under high vacuum with different vacuum gaps. A low turn-on electric field of 1.05\,V/$\mu $m is required to reach an emission current density of 10 $\mu $A/cm$^{2}$. An emission current density of 10 mA/cm$^{2}$ is obtained at an operating electric field of 1.88\,V/$\mu $m. No current saturation is found even at an emission current of 5\,mA. With the vacuum gap increasing from 1 to 10 mm, the turn-on field decreases monotonically from 1.21 to 0.68\,V/$\mu $m, while the field amplification is augmented. The good field-emission behaviour is ascribed to the combined effects of the intrinsic field emission of SWNT and the waved topography of the nonwoven.     

Effect of Electrochemical Treatment in a Lithium Chloride Solution on Field Emission from Carbon Nanotubes

Carbon nanotubes （CNTs） are electrochemically treated in a lithium chloride solution at a concentration 0. 1 mol/L The field emission properties of the CNTs are investigated at different temperatures before and after the electrochemical treatment. After treatment, the turn-on voltage to produce field emission current of 10μA decreases from 4.2kV to 2. 7kV and the field emission current increases distinctly, but the stability falls off. Based on the Fowler-Nordheim plot, the values of the work function for the CNTs are calculated, which reveals that work function decreases after the electrochemical treatment. These results are attributed to the decrease of the work function of the carbon nanotubes.