孔子与德行派弟子

孔子的德政观可以用"仁礼同构"来概括,孔子努力身体力行并且也是这样要求他的学生的。然而事实却并非如此,德行派弟子如颜渊看到了理论与现实的巨大差距,提出了自己的见解,深化了对这一问题的思考,在历史上产生了较重要的影响。了解这一差异有助于我们把握儒学的历史命运。     

氢化丁苯共聚物结构的核磁共振波谱表征Ⅱ.微观结构的定量计算

在氢化丁苯共聚物¹³C-NMR谱脂肪碳部分谱带归属的基础上,根据各谱带的主要来源,推导出六个二单元浓度的计算公式。计算出二单元、一单元的相对含量,各结构单元的数均序列长度、嵌段含量和其它结构参数。加氢前后的¹H-和¹³C-NMR谱的组成计算结果基本一致。初步探讨了作为粘度指数改进剂的氢化丁苯共聚物微观结构与性能的关系,为合成提供了依据。     

固体力学有限元体系的结构拓扑变化理论

本文是文[1]的继续.文[1]提出了杆件系统的结构拓扑变化理论和拓扑变化法本文将这一理论和方法推进到连续体有限元体系;且在此基础上揭示出有限元体系的一个新性质,称为基本位移之梯度的正交性定理,从而给出一套设计敏度的显式表达式,可直接用于计算.     

识别混凝土板内部缺陷的人工神经网络算法

以一维有缺陷混凝土板为研究对象，分别采用Leverberg-Marcluardt和径向基神经网络算法，对缺陷的深度与厚度进行识别，从而实现对混凝土板内部缺陷的三维重构，称为红外CT模拟．两类神经网络算法的识别结果表明：Leverberg-Marcluardt神经网络较径向基神经网络具有更好的收敛精度与计算效率．     

Diffusion Structural Analysis Study of Titania Films Deposited by Sol-Gel Technique on Silica Glass

The diffusion structural analysis (DSA) was used to characterize microstructure changes of hydrous titania gel films under in situ conditions of heating. TG and DTA were used in order to elucidate the processes controlling the formation of anatase film during heating of hydrous titania gel film. The annealing of porosity and near surface structure defects of the dehydrated titania films was indicated by DSA in the temperature range 255–700°C as the decrease of radon release rate. It was demonstrated that the annealing was enhanced on heating in oxygen in comparison with heating in argon. The DSA experimental results were compared with model curves describing the radon diffusion mobility and the annealing of radon diffusion paths.     

Structure and Structural Nonrigidity of Tetrachlorodibenzo-p-Dioxin Radical Cations

Ab initio calculations showed that the tetrachlorodibenzo-para-dioxin radical cations (TCDD RCs) with a planar structure have two steady states with asymmetric dioxin cycles. The activation barriers between these states are up to 2 kcal/mole, so that the RCs may be regarded as being structurally nonrigid within the dioxin cycle. The 2,3,7,8-TCDD RC is more stable than the 1,4,6,9-TCDD RC, the energy difference being 5.2 kcal/mole. The adiabatic ionization potential of 2,3,7,8-TCDD (7.54 eV) is 0.1 eV smaller than the corresponding potential of 1,4,6,9-TCDD. These factors account for the increased hemoproteide affinity and hence increased biological activity of 2,3,7,8-TCDD.     

高压下聚苯胺的结构和电性能研究

 以金刚石压腔高压装置为工具，用Ⅱ型金刚石作压砧兼红外窗口，对本征态聚苯胺进行了高压（0~8.4 GPa）就位红外光谱测试。结果表明：在4.8~5.2 GPa压力区间，代表醌环振动的吸收峰相对代表苯环振动的吸收峰变小，表明聚苯胺在此压力区间结构上发生了显著变化，且这种变化是不可逆的。聚苯胺的高压（0~14.5 GPa）电阻测量结果表明：当压力小于7.5 GPa时，电阻随压力升高而显著降低，据此认为聚苯胺为电子性导电物质；在7.5 GPa处电阻出现极小值，然后又缓慢升高，至10 GPa后基本不变。推测聚苯胺电阻极小值是由结构变化引起的。至于红外光谱与电阻测量结果反映聚苯胺结构变化的压力值不一致，可能是由于测试条件不同所致。     

Annealing behavior of gel‐spun polyethylene fibers at temperatures lower than needed for significant shrinkage

The annealing at 373 K of ultrastrong, gel‐spun polyethylene (PE) has been studied. At this temperature, the fibers show no significant shrinkage. Still, a significant decrease in the mechanical properties is observed. The fibers have been analyzed with differential scanning calorimetry (DSC), temperature‐modulated differential scanning calorimetry (TMDSC), atomic force microscopy (AFM), and small‐angle X‐ray scattering (SAXS). During the annealing, the glass transition of the intermediate phase is exceeded, as shown by DSC. When split for structure analysis by AFM, the annealed fibers undergo plastic deformation around the base fibrils instead of brittle fracture. The quasi‐isothermal TMDSC experiments are compared to the minor structural changes seen with SAXS and AFM. The loss of performance of the PE fibers at 373 K is suggested to be caused by the oriented intermediate phase, and not by major changes in the structure or morphology. The overall metastable, semicrystalline structure is shown by TMDSC to posses local regions that can melt reversibly. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 403–417, 2003     

Identifying Linking-Pin Organizations in Inter-Organizational Networks

Within the large literature on inter-organizational networks, there has been some discussion of linking-pin organizations and the role they play in integrating these networks. Based on this verbal specification of linking-pin organizations, we construct operational criteria and empirical methods for identifying these structurally important organizations in potentially large and complex inter-organizational networks. These methods are based on ideas drawn from blockmodeling, structural holes, centrality and centralization of networks, and identifying cut-points in networks. These methods are applied to a constructed example and then to real empirical inter-organizational networks. Implications and contrasts with other methods are discussed, together with some open problems.     

The detection of structural deformation errors in attitude determination

In the determination of the attitude parameters from a multi-antenna GPS array, one of the major assumptions is that the body frame is rigid at all times. If this assumption is not true then the derived attitude parameters will be in error. It is well known that in airborne platforms the wings often experience some displacement during flight, especially during periods of initializing maneouvres, such as taking off, landing,and banking. Often it is at these points in time that it is most critical to have the most precise attitude parameters.There are a number of techniques available for the detection of modeling errors.The CUSUM algorithm has successfully been implemented in the past to detect small persistent changes. In this paper the authors investigate different methods of generating the residuals, to be tested by the CUSUM algorithm, in an effort to determine which technique is best suited for the detection of structural deformation of an airborne platform. The methods investigated include monitoring the mean of the residuals generated from the difference between the known body frame coordinates, and those calculated from the derived attitude parameters. The generated residuals are then passed to a CUSUM algorithm to detect any small persistent changes. An alternative method involves transforming the generated residuals into the frequency domain through the use of the Fast Fourier Transform. The CUSUM algorithm is then used to detect any frequency changes. The final technique investigated involves transforming the generated residuals using the Haar wavelet. The wavelet coefficients are then monitored by the CUSUM algorithm in order to detect any significant change to the rigidity of the body frame.Detecting structural deformation, and quantifying the degree of deformation, during flight will ensure that these effects can be removed from the system, thus ensuring the most precise and reliable attitude parameter solutions. This paper, through a series ofsimulations, will assess the effectiveness of the above mentioned techniques for detecting structural deformation effects on a GPS multi-antenna array. These principles are then tested with experimental data.