FAFFA加速的PO-MM研究复杂金属载体上线天线电磁特性

本文提出了一种快速远场近似(FAFFA)加速的混合物理光学矩量法(POMM),利用FAFFA加速计算矩阵方程中的矩阵矢量积,明显提高了计算效率.对物体表面上的远场组之间的耦合作用推导出了一组简洁的计算公式,并分析了计算复杂度.复杂金属组合体上线天线输入导纳、互导纳和方向性图的计算结果与文献结果一致.利用该方法分析计算了一个舰船模型上线天线的电磁特性.数值结果表明了这种方法的正确性和工程应用中的有效性.     

Headspace SPME–GC Method for Acetone Analysis and its Biomedical Application

A new method for extraction and analysis of acetone in human urine based on headspace solid phase microextraction using a mixture of activated carbon and zeolite as sorbents in a PVC matrix coated on a silver wire and its application to the determination of ketone bodies is described. Unlike commercial fibers, which are coated on fused silica, the coating adheres strongly to the silver wire and is thermally stable up to 250 °C. After optimization of coating composition and microextraction conditions the fiber was used for the analysis of acetone in human urine.     

微结构量子器件

微结构量子器件是八十年代中期伴随着微结构物理的发展而出现的一种新的半导体器件,这种器件以量子力学原理工作,具有常规“经典”器件无法比拟的优异特性。本文在简要介绍了微结构系统电子状态的基础上,较详细地描述了量子谐振隧道器件以及量子线和量子点激光器的基本原理、特点及其应用前景。     

火花激发原子发射光谱分析不锈钢线材

火花激发原子发射光谱法应用于直径小于8mm的不锈钢线材的分析，对此类试样应用了一种特制的夹具，用块状标准样品制作工作曲线。由于线状试样和块状标准样品之间的形状差异所产生的系统不确定度借采用同类型标样作校正，对共存元素的相互干扰也采用了相应的校正方法。其它分析条件，包括严格的制样工序，氩气的纯度要求及其流量控制，以及光源的最佳条件等，作了深入的试验。按所提出的方法测定了不锈钢线材试样中碳、硅、锰、磷、硫、铬、镍及钛等8个元素。经校正后的结果与化学法测得结果相符。     

纳米多孔双金属氧化物在镍钛合金纤维上的原位生长及其对多环芳烃的选择性固相微萃取

采用阳极氧化法在镍钛合金(NiTi)纤维上原位生长了双金属氧化物纳米孔(NiTiONPs)涂层,通过扫描电镜(SEM)和能谱(EDS)考察了电解质组成和电压对形貌的影响。将NiTiONPs涂层的NiTi纤维与高效液相色谱-紫外检测器联用,研究了4种典型芳香分析物的萃取性能。结果表明,富含TiO2的NiTiONPs涂层对多环芳烃(PAHs)具有良好的萃取效率,尤其对苯并[a]芘的萃取选择性优于市售聚二甲基硅氧烷纤维和聚丙烯酸酯纤维。在优化条件下,PAHs的线性范围为0.05~200μg/L,相关系数均大于0.999,检出限为0.012~0.134μg/L。对单支纤维日内和日间分析的相对标准偏差(RSDs)分别为4.0%~5.5%和6.0%~6.8%,使用分批组装的5支纤维分析的RSDs为6.4%~7.6%。实际水样分析的加标回收率为84.5%~111.5%。所制备NiTi纤维至少可重复使用250次以上,重现性好。     

聚乙烯醇缩丁醛膜涂丝酶电极构造方法的研究

本文以三月桂胺为中性载体制成聚乙烯醇缩丁醛膜涂丝pH电极,再以该pH电极为换能器,采用三种共价交联固定化酶方法制成涂丝乙酰胆碱酯酶电极。该酶电极能用于测定0.1～10mmol/L浓度范围内的乙酰胆碱,响应时间在3～6min之内,寿命可达两个多月。     

Characterization of the organization in shear layers via the Proper Orthogonal Decomposition

Experiments are performed in an incompressible plane turbulent mixing layer, using various hot wire rake configurations. From these experiments, the Proper Orthogonal Decomposition is applied for kernels where the space-time correlation tensor is evaluated over different spatial meshes and velocity components configurations. The resulting decompositions are then discussed in terms of characterization of the organization of the flow for various scalar or vectorial approaches of the POD. An incrtial range law is evidenced. The instantaneous contribution of the first modes of the POD to the organization of the flow is analyzed. A dynamical behavior for the organization of the flow is observed from the correlation between the first two modes contribution.     

Uncertainty of the Thermal Conductivity Measurement Using the Transient Hot Wire Method

This work deals with uncertainty analysis of the thermal conductivity measurement using the transient hot wire method. The characterization is made from a sample of low-density, polyethylene BRALEN SA 200-22. The utilized experimental data are obtained from the test measurements performed on the air at room temperature. The sources of measurement errors are analyzed and the uncertainty of the measured value of the thermal conductivity is evaluated. The analysis shows that in the present case the uncertainty of the thermal conductivity measurement is about ±3.3% for 68% confidence level.This revised version was published online in November 2005 with corrections to the Cover Date.