Long-term study of an intermittent air sparged MBR for synthetic wastewater treatment

Membrane bioreactors (MBR) combine biological processes with membrane filtration. Advantages of MBR in municipal wastewater treatment include high effluent quality and reduced space requirements. Steady operation of membrane plants requires careful management of membrane fouling. Even though it might be impossible to prevent, fouling can be limited by techniques such as gas sparging. The injection of gas bubbles increases the shear stress and removes fouling material from the membrane surface. Most cited literature on air sparging refers to short-term experiments, often times in bench scale. The aim of this study was therefore long-term investigations in pilot plant scale of a 70 L reactor fed with glucose-based synthetic wastewater. The main focus was on enhancing permeate flux by air sparging. The results showed that using air sparging significantly increased the permeate flux was doubled even over several weeks. The findings were interpreted using the dimensionless fouling and shear stress number. The fouling resistance was found to decrease significantly with air injection ratios between 0.4 and 0.5. When air sparging was applied after a period without air sparging, the shear stress number doubled. This increase in shear led to a reduction of the fouling number by approximately 30%. During several weeks air sparging only a slow fouling number increase was. In contrast to that after air sparging was ceased, an exponential increase of the fouling number was observed.     

TiO_2-CeO_2催化剂湿式氧化苯酚的活性研究

采用共沉淀法制备了湿式氧化降解苯酚的TiO2-CeO2催化剂,测定了反应过程中不同反应时间的COD去除率,结果表明,当Ti、Ce摩尔比为3∶1时,在150℃、总压5MPa(其中氧分压4.5MPa)时,所制备的催化剂活性最高,反应90分钟COD去除率可以达到71%.对催化剂进行了比表面积、XRD和XPS测试,结果表明,高效的催化剂具有较多的活性位、催化剂粉末体系Ce的变价特性以及大量的表面吸附氧.     

The Extraction of Polycyclic Aromatic Hydrocarbons from Atmospheric Particulate Matter Samples by Accelerated Solvent Extraction (ASE)

Abstract

The Accelerated solvent extraction (ASE) of PAHs (23 2- to 6-ring species) spiked onto glass fibre filters (GFFs) was studied as a function of variable extraction solvents, pressure, temperature and extraction times. Acceptable recoveries (85% ± 15%) were obtained for certain combinations of conditions and a tentative method (1500 psi, 150°C, 70:30 hexane:acetone mixture, 7 min heat-up time, 5 min static extraction time, 60% flush volume, 2 static cycles was selected for further testing. However, this method did not prove as effective as the traditional Soxhlet method of extraction when these parameters were used to extract native PAHs from ambient atmospheric particulate matter collected on a GFF by Integrated Atmospheric Deposition Network (IADN) sampling protocols. The extraction recovery study for spiked GFFs was repeated using slightly different extraction conditions: 2000 psi, 100°C, 70:30 hexane:acetone, 5 min heat-up time, 5 min static extraction time, 150% flush volume, 3 static cycles. When this method was applied to the extraction of native PAHs from ambient atmospheric particulate matter collected on GFFs, the results showed equivalent or better recoveries to that of the Soxhlet method. The total time of extraction was 25 min requiring only 30 mL of solvent. This ASE method is presently used to quantitatively determine PAHs in IADN particle-phase samples.     

重度原油注空气低温氧化过程研究(英文)

低温氧化反应对现场燃烧(ISC)技术点火的成功有十分重要的影响.采用高压氧化管,研究了不同温度压力下,新疆克拉玛依重度原油的低温氧化过程.结果表明,温度和压力的变化对低温氧化反应的放热程度、持续时间以及气体产物有明显影响.适合油样低温氧化反应的温度和压力分别为150℃和10MPa.此外,采用纯组分替代原油族组分进行低温氧化实验,研究低温氧化反应对原油族组分(饱和烃、芳香烃、胶质、沥青质)含量的影响.结果表明,原油所含族组分中,芳香烃组分最易被氧化,其含量由氧化前的19.17%减少到12.38%(150℃)和9.51%(250℃).随着低温氧化过程的进行,结构复杂的族组分(胶质、沥青质)的含量明显增加.实验数据对油藏实施注空气技术,以及该技术现场实施条件的确定有十分重要的指导意义.     

Air‐assisted liquid–liquid extraction coupled with dispersive liquid–liquid microextraction and a drying step for extraction and preconcentration of some phthalate esters from edible oils prior to their determination by GC

In this work, a new, cheap, simple, fast, and low organic solvent consuming procedure is proposed for isolation, enrichment, and gas chromatographic determination of some phthalate esters in edible oils. The method is based on a combination of air‐assisted liquid–liquid extraction and dispersive liquid–liquid microextraction followed by a drying step under N₂ gas. Several experimental parameters affecting both extraction and preconcentration steps were investigated and optimized. Under the optimum conditions for the proposed method, wide linear ranges (0.05–800 μg/L) and low detection limits (0.007–0.023 μg/L) were observed. The ranges of enrichment factors and extraction recoveries were 68–340 and 14–68%, respectively. Eventually, the target analytes were successfully determined in different edible oils using the proposed method.     

空气稳定的氮杂蔻电子传输材料分子设计及三氮杂蔻衍生物迁移率计算

采用密度泛函理论研究氮功能化对蒄类化合物几何构型、电子结构及载流子传输性质的影响. 结果表明, 引入杂N原子可以线性降低前线轨道能级, 增强电子注入能力与空气稳定性, 且邻位掺杂较迫位和均匀掺杂调节效果更为显著. 其中, 十二氮杂蒄（12ac）具有新颖的“碗状”构型和高的电子亲和势（3.45 eV）, 是潜在的空气稳定电子传输材料构筑单元. 理论预测室温下2,6,10-三对甲氧基苯基-3,4,7,8,11,12-六甲氧基三氮杂蒄（3b）晶体的电子迁移率为0.242 cm2/V s, 预计是良好的电子传输材料, 值得进一步器件化研究.     

Nitration of Simple Aromatics with NO2 under Air Atmosphere in the Presence of Novel Brønsted Acidic Ionic Liquids

Abstract

Aromatics nitrate with NO₂/air catalyzed by novel Brønsted acidic ionic liquids (ILs) without any volatile chlorinated organic solvent under mild conditions. The ILs employed were caprolactam based, [Caprolactam]X (X^?=pTSO^?, BSO^?, BF₄ ^?, NO₃ ^?), which are of relatively lower cost and lower toxicity than traditional imidazolium‐based ILs. The nitration reactions were carried out at ?15 to ?0°C first, then at room temperature for a longer time with a little excessive NO₂ (ca. 1.4 eqv.) for moderate yield (for toluene). The IL could be reused four times.     

Sources and Time-Variations of Reactive Hydrocarbon Immissions in the Atmosphere of Different Industrial and Rural Areas

Abstract

The problem of determining the concentration changes of reactive hydrocarbon immissions as a function of time was solved by means of an automatic gas chromatograph which, without enrichment, could record ethylene and acetylene in ppb concentrations. At the same time various other pollutants were covered, so that by a mutual allocation of the individual components it was possible to identify certain emitter groups. The results clearly show that ethylene and acetylene primarily originate from the combustion processes of the automobiles, while the handling and storage of petroleum products and their processing do not exert any influence on the immission of the two components. By way of time series measurements during a summer week in 1976 with very intensive solar radiation it was possible to show indirect secondary photochemical reactions.     

Volatile organic compounds in an urban environment: a comparison among Belgium,Vietnam and Ethiopia

The effects of urban and indoor air pollution on human health are a major environmental concern for all, but not much has been researched in the developing world. Specifically, quantitative data on the occurrence of volatile organic compounds (VOCs) – main contributors to air pollution – in Asia and Africa are scarce compared to the availability of data in the developed world. This paper presents one of the first studies focusing on the analysis and occurrence of VOCs in Vietnam and Ethiopia, which constitutes part of the novelty of this work. A spectrum of 34 VOCs was measured at eight different urban sites in Ghent (Belgium), Hanoi (Vietnam), Jimma and Addis Ababa (Ethiopia) during three sampling campaigns from September 2008 to September 2010. Sampling was done in an active way by means of sorbent tubes filled with Tenax TA. The analysis was done by TD-GC-MS using internal standard calibration. Data were interpreted and compared in terms of (i) individual, subgroup and total VOCs concentration (TVOCs), (ii) indoor-to-outdoor (I/O) concentration ratios, (iii) source identification by diagnostic ratio and/or correlation coefficients, and (iv) ozone formation potential (OFP) at outdoor sites based on up-to-date maximum incremental reactivity (MIR). I/O concentration ratios varied between 0.2 and 30, with big differences noticed with respect to the type of VOC(s) considered and the type of outdoor sampling location. The highest TVOC concentrations were measured in street samples with maximum values of 54?µg/m³ in Ghent, 507?µg/m³ in Hanoi and 318?µg/m³ in Addis Ababa illustrating the large difference in ambient air quality levels. This is also reflected in the arithmetic mean OFP values (µg/m³) of 82, 1308 and 596 in Ghent, Hanoi and Addis Ababa, respectively. Results of this study could be helpful to support formulation of national policy with regard to ambient air quality.     

The Determination Of Sub Part-Per-Billion Levels Of Volatile Organic Compounds In Air By Pre-Concentration From Small Sample Volumes

Abstract

Trace level Volatile Organic Compounds (VOCs) in ambient air are normally determined according to EPA Method TO-14. This method describes the analysis in ambient air of 41 VOCs, ranging in boiling point from -29 to 215°C. It covers a concentration range from 0.2 to 20 parts per billion, volume/volume (ppb), and specifies sample enrichment of a 400 mL air sample on glass beads at -160°C. While this sample volume provides sub-ppb levels of VOC detection for target analytes when using a quadrupole mass spectrometer detector in SIM mode or when using GC detectors, the identification of non-target analytes may only be done in full scan mode for higher concentrations. Also with this sample volume a Nafion dryer is needed for water removal thereby lowering the recovery of polar VOCs.

Because of the very high sensitivity of the ion trap MS, relatively small air volumes (60 mL) are adequate to obtain the required or lower detection levels. An integrated air analysis system based on a GC-ion-trap MS has been investigated and is described. This system has a built-in cryogenic trap and necessary valving, internal standard gas sampling loop, and is controlled from the GC-MS workstation. The linearity, precision, and method detection levels obtainable with this system when using small volumes are reported. In addition, examples of the quantitative and qualitative analysis of ambient air samples are shown.