Methyl torsional potentials of rotational isomers of m-methylanisole studied by spectral hole-burning spectroscopy

Laser-induced fluorescence (LIF) excitation spectra of m-methylanisole in a supersonic jet were measured. Two series of progressions were observed in the spectrum, originating at 36048 and 36115 cm⁻¹, which were successfully assigned to the transitions to the methyl internal rotational vibronic levels of the two isomers, i.e. cis and trans isomers, with the aid of hole-burning spectrum measurements and quantum-chemical calculations. The progression for the trans isomer was observed up to the 6a₁ band, while only the 3a₁ band in addition to the 0a₁ and 1e bands was observed for the cis isomer. This finding can be explained by the conformational change upon the electronic excitation; the 60° rotation of the methyl torsional angle takes place for the trans isomer but not for the cis isomer.     

Factors affecting propagating fronts of addition polymerization: Velocity,front curvature,temperatue profile,conversion, and molecular weight distribution

Several properties of propagating fronts of addition polymerization were studied. A power function could be fit to the velocity dependence on initiator concentration, but not with the exponents predicted by current models or in agreement with other published work. Bubbles from the volatile by-products of initiator decomposition were found to affect the front velocity and curvature. The front velocity for triethylene glycol dimethacrylate polymerization was found to depend linearly on temperature over a moderate range. The conversion of methacrylic acid in fronts varied greatly with initiator type and concentration. Benzoyl peroxide produced much lower conversion than t-butyl peroxide, but fronts with tBPO propagated slower. A dual initiator system of BPO and tBPO produced rapidly propagating fronts with good conversion but the contribution of each initiator to the velocity was not additive. The possibility of chain branching was considered. The apparent molecular weight distributions were very broad, often trimodal, and found to depend on initiator type and concentration as well as the tube diameter. The temperature profiles were measured and found to be very sharp for BPO and broader for tBPO but both had front temperatures in excess of 200°C, indicating a high ceiling temperature. © 1995 John Wiley & Sons, Inc.     

SOI基光学电流传感器的设计与仿真

将光纤与微电子机械系统(MEMS)技术相结合,设计了一种新颖的检测50Hz高压交流电的光学电流传感器(OCS)。用ANSYS软件分析了器件的模态、动态响应与热膨胀特性,并通过Matlab软件模拟了器件的工作性能。模拟计算表明:ANSYS与理论公式得到的结果基本一致;传感器的量程为100~3600A,对于大电流下的灵敏度可达到0.02dB/A,温度变化±50K时传感器相应的测试误差为0.2%。     

Sloshing waves in a heated viscoelastic fluid layer in an excited rectangular tank

In this paper, we have investigated the motion of a heated viscoelastic fluid layer in a rectangular tank that is subjected to a horizontal periodic oscillation. The mathematical model of the current problem is communicated with the linearized Navier–Stokes equation of the viscoelastic fluid and heat equation together with the boundary conditions that are solved by means of Laplace transform. Time domain solutions are consequently computed by using Durbin's numerical inverse Laplace transform scheme. Various numerical results are provided and thereby illustrated graphically to show the effects of the physical parameters on the free-surface elevation time histories and heat distribution. The numerical applications revealed that increasing the Reynolds number as well as the relaxation time parameter leads to a wider range of variation of the free-surface elevation, especially for the short time history.     

Shock waves for the hyperbolic balance laws with discontinuous sources

In this paper, we are concerned with the behavior of shock waves in a 2 × 2 balance law with discontinuous source terms. We obtain the existence of a local shock wave solution of this problem and deduce that the discontinuous source terms create a weak discontinuity in this solution. Copyright © 2013 John Wiley & Sons, Ltd.     

Conductivity anomalies in Y–Ba–Cu–O at 40K and 100K under high quasihydrostatic pressures

Electrical resistance measurements at low temperatures and high quasihydrostatic pressures on superconducting and non-superconducting varieties of Y_0.8Ba_1.2Cu₂O₅ (obtained by annealing in oxygen and air respectively) show striking anomalies in the vicinity of 100K and 40K. Arguments are presented to show that these anomalies as also the occurrence of T 's in the oxide superconductors either in the vicinity of 100K or of 40K are connected with their layered structure containing planes of Cu-O otahedral complexes.     

A numerical analysis of a class of generalized Boussinesq‐type equations using continuous/discontinuous FEM

An improved class of Boussinesq systems of an arbitrary order using a wave surface elevation and velocity potential formulation is derived. Dissipative effects and wave generation due to a time‐dependent varying seabed are included. Thus, high‐order source functions are considered. For the reduction of the system order and maintenance of some dispersive characteristics of the higher‐order models, an extra O(μ²ⁿ⁺²) term (n ∈ ?) is included in the velocity potential expansion. We introduce a nonlocal continuous/discontinuous Galerkin FEM with inner penalty terms to calculate the numerical solutions of the improved fourth‐order models. The discretization of the spatial variables is made using continuous P₂ Lagrange elements. A predictor‐corrector scheme with an initialization given by an explicit Runge–Kutta method is also used for the time‐variable integration. Moreover, a CFL‐type condition is deduced for the linear problem with a constant bathymetry. To demonstrate the applicability of the model, we considered several test cases. Improved stability is achieved. Copyright © 2011 John Wiley & Sons, Ltd.     

Anisotropic sound and shock waves in dipolar Bose-Einstein condensate

We study the propagation of anisotropic sound and shock waves in dipolar Bose-Einstein condensate in three dimensions (3D) as well as in quasi-two (2D, disk shape) and quasi-one (1D, cigar shape) dimensions using the mean-field approach. In 3D, the propagation of sound and shock waves are distinct in directions parallel and perpendicular to dipole axis with the appearance of instability above a critical value corresponding to attraction. Similar instability appears in 1D and not in 2D. The numerical anisotropic Mach angle agrees with theoretical prediction. The numerical sound velocity in all cases agrees with that calculated from Bogoliubov theory. A movie of the anisotropic wave propagation in a dipolar condensate is made available as supplementary material.