Polysaccharide‐Based Oleogels Prepared with an Emulsion‐Templated Approach

The preparation and characterization of oleogels structured by using a combination of a surface‐active and a non‐surface‐active polysaccharide through an emulsion‐templated approach is reported. Specifically, the oleogels were prepared by first formulating a concentrated oil‐in‐water emulsion, stabilized with a combination of cellulose derivatives and xanthan gum, followed by the selective evaporation of the continuous water phase to drive the network formation, resulting in an oleogel with a unique microstructure and interesting rheological properties, including a high gel strength, G′>4000 Pa, shear sensitivity, good thixotropic recovery, and good thermostability.     

Interconnected sandwich structure carbon/Si-SiO2/carbon nanospheres composite as high performance anode material for lithium-ion batteries

In the present work,an interconnected sandwich carbon/Si-SiO2/carbon nanospheres composite was prepared by template method and carbon thermal vapor deposition（TVD）.The carbon conductive layer can not only efficiently improve the electronic conductivity of Si-based anode,but also play a key role in alleviating the negative effect from huge volume expansion over discharge/charge of Si-based anode.The resulting material delivered a reversible capacity of 1094 mAh/g,and exhibited excellent cycling stability.It kept a reversible capacity of 1050 mAh/g over 200 cycles with a capacity retention of 96%.     

基于MCM-41硬模板的镍铁磁性纳米管的合成及其磁性研究

以Si-MCM-41为硬模板,利用介孔材料的吸附作用,将Fe3+和Ni 2+按一定比例定量吸附组装到介孔材料的孔壁上;然后通过程序升温在900℃条件下高温焙烧,并经氢氟酸处理,得到直径大约为3.0nm的中空铁氧体纳米管.分别利用傅立叶变换红外光谱仪、扫描电镜、透射电镜、X射线衍射仪分析了合成材料的结构、组成、形貌;采用振动样品磁强计测定了其磁性能.结果表明,合成的镍铁氧体纳米管具有良好的管状形貌,其结构与分子筛MCM-41的结构相似,并具有良好的磁学性能.这说明MCM-41分子筛孔道结构具有可复制性,本研究可望为制备具有适当长径比的一维纳米磁性材料打下良好基础.     

T-symmetric 40-nucleus silver clusters assembled by hetero-anions

We report two anion-templated Ag₄₀ clusters, [Ag₄₀(E)₄(SO₄){S₂P(OEt)₂}₂₄](PF₆)₆ (E = S, 1 ; Se, 2 ). The anionic templates were generated in situ from the decomposition of dithiophosphate (dtp) ligands. The extrusion of sulfur undergoes disproportionation reactions to generate sulfide and sulfate anions, which provide the source of templates in the subsequent cluster assembly reactions. Two Ag₄₀ clusters display high similarity in their structures. The sulfide (selenide) anions and the central sulfate anion reveal a six-coordinate and a rare dodecametallic dodecaconnective pattern, respectively. Four near-equivalent [Ag₁₀(E){S₂P(OEt)₂}₆]²⁺ motifs were assembled via the connection of central sulfate anion to construct Ag₄₀ clusters. The cluster cation, [Ag₄₀(E)₄(SO₄){S₂P(OEt)₂}₂₄]⁶⁺, displayed in T symmetry, is unprecedented in anion-templated silver clusters.     

Highly Sensitive Electrochemiluminescent Insecticide Sensor Based on ZnO Nanocrystals Anchored Nickel Foam for Determination of Imidacloprid in Real Samples

In this work, a novel electrochemiluminescent (ECL) pesticide sensor based on zinc oxide nanocrystals decorated nickel foam is proposed for determination of imidacloprid for the first time. The silica film was used as a morphology‐controlling factor for modification of the electrode with zinc oxide nanocrystals. Zinc oxide was selected as luminescent material due to its cheapness, non‐toxicity, high thermal stability and excellent luminescence properties which truly adhered on the surface of nickel foam. The K₂S₂O₈ was used as strong co‐reactant for this purpose. The silica template plays an important role in controlling the size of ZnO nanocrystals. The Physical morphology of the ZnO/Ni‐foam electrode was performed by electrochemical impedance spectroscopy, Brunauer‐Emmett‐Teller (BET), X‐Ray diffraction analysis, field emission scanning electron microscopy, and energy‐dispersive X‐ray analysis. The ultra‐sensitive electrochemiluminescence method was successfully used for ultra‐trace determination of imidacloprid. The linear dynamic range and low detection limit were obtained 3×10^?14 ?8×10^?8 M and 4.4×10^?15 M, respectively. Also, the relative standard deviation for 15 repetitive optical signals was calculated 1.09 %.The present ECL sensor exhibited superior performance toward the accurate determination of imidacloprid with good reproducibility and stability.     

氢气泡模板法电沉积制备三维多孔铜薄膜

应用阴极析氢气泡模板法电沉积制备三维多孔铜薄膜,基础电解液组成为0.2 mol.dm-3CuSO4和1.5 mol.dm-3H2SO4.研究了电流密度(0.5~8.0 A.cm-2)、温度(20~70℃)、支持电解质(Na2SO4)以及添加剂HC l和聚乙二醇(PEG)等对薄膜的孔径大小和孔壁结构的影响.扫描电子显微镜(SEM)分析表明,降低镀液温度和添加Na2SO4、PEG都可降低孔径的大小,但对孔壁结构无影响.加入微量的氯离子可显著改变薄膜的孔壁结构,得到孔壁结构较为致密的三维多孔铜电极.循环伏安(CV)测试结果显示三维多孔铜薄膜电极在碱性条件下电氧化甲醇的电流密度比光滑铜电极提高了近20倍.     

Robust Amino-Functionalized Mesoporous Silica Hollow Spheres Templated by CO2 Bubbles

Hollow-structured mesoporous silica has wide applications in catalysis and drug delivery due to its high surface area, large hollow space, and short diffusion mesochannels. However, the synthesis of hollow structures usually requires sacrificial templates, leading to increased production costs and environmental problems. Here, for the first time, amino-functionalized mesoporous silica hollow spheres were synthesized by using CO₂ gaseous bubbles as templates. The assembly of anionic surfactants, co-structure directing agents, and inorganic silica precursors around CO₂ bubbles formed the mesoporous silica shells. The hollow silica spheres, 200–400 nm in size with 20–30 nm spherical shell thickness, had abundant amine groups on the surface of the mesopores, indicating excellent applications for CO₂ capture, Knoevenagel condensation reaction, and the controlled release of Drugs.     

多孔氧化铝模板催化制备定向碳纳米管阵列

Well-aligned open-ended multi-walled carbon nanotube (MWCNT) arrays were prepared via chemical vapor deposition (CVD) method in porous anodic aluminum oxide (AAO) templates without depositing any transition metals as catalyst. Effects of the CVD temperature and heat treatment were studied in detail.Well-aligned open-ended MWCNT arrays were obtained at the CVD temperature above 600 ℃; when CVD temperature is reduced to around 550 ℃, CNTs, CNFs and other structures existed at the same time; no CNTs or carbon nanofibres (CNFs) could be found as the CVD temperature is below 500 ℃, and only amorphous carbon in the porous AAO template was found. Experimental results showed that the AAO template is catalytic during the CVD process, and it has the following two effects: to catalyze thermal decomposition of acetylene and to catalyze conversion of carbon decomposed from acetylene into CNTs or CNFs. Heat treatment could improve the graphitization degree, but it might also introduce new defects.     

二苯基二甲氧基硅烷单体制备空心微胶囊的模板合成方法研究

制备了直径在700～1500 nm范围内的空心聚硅氧烷微球. 在O/W型聚二苯基硅氧烷微乳模板核上, 加入一定比例的二苯基二甲氧基硅烷(D型官能团)和甲基三甲氧基硅烷(T型官能团)的有机硅单体, 使之围绕在模板核表面聚合交联形成核壳结构的聚硅氧烷微胶囊, 利用合适溶剂溶解透析的方法去除模板核得到空心微胶囊. 通过TEM和AFM测定考察, 讨论了体系的各反应条件对空心微球的形态结构和大小分布的影响.