含气率对PTS时压力容器内流动与传热的影响

本文对反应堆压力容器紧急安注时的流动与传热特性在1/10的模型上进行了流动可视化、局部传热系数以及混合函数的试验研究。针对三个热冲击敏感区域的部分测点,比较了环腔流速为0.5m/s、安注流速为1～30 m/s时不同含气率对下降环腔内流动与传热特性的影响,得出并分析了不同测点传热系数、混合函数的变化规律。研究结果表明:随着含气率增大,安注流体与环腔流体的混合增强;下降环腔内的含气率对小安注流速时的流动与传热影响显著,而对大安注流速时影响较小。     

Signal Integrity: Fault Modeling and Testing in High-Speed SoCs

As we approach 100 nm technology the interconnect issues are becoming one of the main concerns in the testing of gigahertz system-on-chips. Voltage distortion (noise) and delay violations (skew) contribute to the signal integrity loss and ultimately functional error, performance degradation and reliability problems. In this paper, we first define a model for integrity faults on the high-speed interconnects. Then, we present a BIST-based test methodology that includes two special cells to detect and measure noise and skew occurring on the interconnects of the gigahertz system-on-chips. Using an inexpensive test architecture the integrity information accumulated by these special cells can be scanned out for final test and reliability analysis.     

双掺(Tm3+,Tb3+)LiYF4激光器1.5 μm波长激光阈值分析

由速率方程推出了双掺（Tm^3 ,Tb^3 ）离子准四能级系统的激光阈值解析式，讨论了Tm^3 和Tb^3 离子之间的相互作用。分析了1.5μm波长附近的激光阈值和Tm^3 、Tb^3 离子的掺杂原子数分数及晶体长度的关系。结果表明，对于对应Tm^3 离子^3H4→^3F4跃迁的约1.5μm波长的激光，激活离子Tm^3 的掺杂原子数分数过大时，交叉弛豫作用将使系统阈值迅速增加。Tb^3 离子的加入，一方面能抽空激光下能级，起到降低阈值的作用；另一方面亦减少了激光上能级的寿命，使阈值升高。故Tb^3 离子有最佳掺杂原子数分数。对于Tm原子数分数为y=0.01的Tm:LiYF4晶体，Tb^3 离子的最佳掺杂原子数分数为0.002左右，同时表明，激光阈值与晶体长度有关。最佳晶体长度与Tm^3 、Tb^3 离子的掺杂原子数分数以及晶体的衍射损耗和吸收损耗有关。     

灰色信息及其运算研究

本文提出了全真信息、信息的亲善性等概念,讨论了信息的有关性质及运算的关系,得到了信息的运算与普通集合运算之间存在着差异的结论,说明了引起该差异的原因.同时,以认知模式为基础,定义了信息函数,并得到了有关的命题及运算.     

热作模具钢表面激光堆焊耐磨合金层的研究

本文主要通过在H13钢上用大功率CO_2激光束进行堆焊,阐述了激光堆焊工艺变化对堆焊组织和性能的影响,在本试验条件下,得到了高密度弥散金属化合物组织的激光堆焊层,平均硬度为HV800,与基体呈冶金结合,耐磨性比H13模具钢提高149%。     

大功率CO2激光器脉冲电源研究

本文论述了直流高压与高频脉冲电源相叠加，构成高频、高压脉冲电源，并使其对CO2激光器进行放电实验，研究了同条件下的放电参数与功率。     

A Combined Antenna Array and Multi-User Detection DS-CDMA Receiver in Single-Path and Multi-Path Fading Channels

An adaptive antenna array is incorporated into a decorrelatingmulti-user detector to effectively increase the DS-CDMA system capacity.Capacity improvement is due to beamforming gain, spatial diversity gain(assuming large angle spread), and the decorrelating effect. Thereceiver has been analyzed for the cases of sufficiently andinsufficiently spaced receiving antennas. The receiver consists of afront-end beamformer for every user in the cell and has knowledge of allusers' signature sequences. The beamformer estimates the desired userchannel vector, enhancing its signal and reducing the co-channelinterference from other directions. The multi-user detection, exploitingknowledge of other users, rejects those interferers whose arrival anglesare close to that of the desired user. The average uncoded Bit ErrorRate (BER) as a function of the number of in-beam active users, theaverage antenna Signal-to-Noise Ratio (SNR), and the number of receivingantennas is examined in both single-path and multi-path Rayleigh fadingchannels. Analysis shows an increase in system capacity proportional tothe number of receiving antennas.     

Thermal gradient induced sidebranching in directional solidification

The polycrystalline perovskitelike manganese oxides La_1-xA_xMnO (A = Na, and K, ) have been fabricated by sol-gel technique. For all the compositions explored in this work, the average manganese oxidation state is practically constant, at for A = Na, and for A = K, respectively. A close relationship is confirmed to hold between the Curie temperature (T_c) and the bond distance of Mn-O. Results of magnetic measurements show that these materials can be utilized as suitable candidates for magnetic refrigerants with wide applied temperature span, for their significant entropy change and the easily tuned Curie temperature. Received: 12 September 1997 / Revised: 18 December 1997 / Accepted: 21 January 1998     

一种新颖的表面等离子谐振效应光波导水质传感技术

光学表面等离子谐振（ＳＰＲ）效应是一种很有效的水质检测技术，经过详细的理论推导，同了ＳＰＲ反射光强的普遍适用公式。在纯水与受污染水两种情况下，根据一些已知参数计算出结果。由计算结果数据一出的曲线比较表明，ＳＰＲ效应在两种情况下有明显差别，这也正是ＳＰＲ效应用于水质检测的理论根据。     

双波长稳频CO_2激光模糊控制系统的建模与优化

报导一种模糊逻辑控制系统的建模与优化方法。以此方法设计的模糊逻辑控制器，用于双波长稳频ＣＯ２激光器的控制得到令人满意的结果。