正电子产生靶上初级电子束半径的最小化研究

为获得尽可能高的正电子(e⁺)产额,严格控制初级电子(e^－)束在e⁺产生靶上的束半径是至关重要的.首先分析了使e^－束半径增大的各因素和对这些因素的制约;然后以北京正负电子对撞机(BEPC)的正电子源为例,给出了束半径的实测值和计算值的比较,以具体说明这些因素的影响;最后讨论了北京正负电子对撞机二期工程(BEPC-Ⅱ)的相应优化设计研究,提出了获得靶上最小束半径的若干途径.     

高精度的光纤衰减系数测试系统的设计

利用常规仪器设备，设计了一套集光、机、电为一体的光纤衰减测量,实现了数字化监测显示，并可与微机接口；采用双光路法，消除了由于光源光强不稳定产生的误差。     

Structure and magnetism of bcc(1 1 0)-like Fe films grown on Cu(0 0 1) via ion beam triangulation and spin-polarized electron capture

The structure and magnetism of thin epitaxial Fe layers grown on Cu(0 0 1) is investigated by grazing scattering of fast H and He atoms. Information on the atomic structure of the film and substrate surfaces is obtained by making use of ion beam triangulation with protons. The magnetic behavior is studied via the polarization of light emitted after capture of spin-polarized electrons into excited atomic terms during scattering of He atoms. For the formation of bcc(1 1 0)-like Fe films at higher coverages, we detect differences in structural and magnetic properties for room and low temperature growth. We suggest that the crystalline structure depends on the film morphology and that Cu impurities affect the magnetic properties.     

Changes in the spectrum of Gaussian Schell-model beams propagating through turbulent atmosphere

Based on the extended Huygens-Fresnel principle, the spectrum of Gaussian Schell-model (GSM) beams propagating through turbulent atmosphere is derived analytically. It is shown that, if the scaling law is valid, the normalized spectrum S(ω) of GSM beams propagating through turbulent atmosphere is the same as the normalized source spectrum S⁽⁰⁾(ω), whether GSM source is quasi-homogenous or not. On the other hand, if the scaling law fails, S(ω) of GSM is different from S⁽⁰⁾(ω). The structure constant of the refractive index, transverse coordinate of observation point and spatial correlation length of the source affect the spectrum, which is illustrated numerically.     

Monte Carlo方法研究低能电子束曝光沉积能分布规律

建立一个描述低能电子在多元多层介质中散射的物理模型,运用MonteCarlo方法模拟低能电子在靶体胶衬底中的复杂散射过程,在此基础上通过大量计算研究入射束能、胶层厚度、衬底材料等不同曝光条件对抗蚀剂沉积能密度分布的影响,获得沉积能分布规律:适量的低束能、薄胶层、低原子序数衬底可以使前散射电子对胶中沉积能密度分布的贡献增大、背散射电子的贡献减小,从而提高曝光分辨率. 关键词： 电子束曝光 MonteCarlo方法 低能电子散射 能量沉积     

Tesla变压器型电子束加速器初步实验

 介绍了一种Tesla变压器型的强流电子束加速器。当变压器初级输入20kV左右的电压时，加速器二极管输出电压500kV，电流9kA，信号脉宽大约50ns，该装置具有结构简单，安装方便，运行可靠等特点。     

Isothermal crystallization kinetics of poly(3‐hydroxybutyrate)/layered double hydroxide nanocomposites

Poly(3‐hydroxybutyrate) (PHB)/layered double hydroxides (LDHs) nanocomposites were prepared by mixing PHB and poly(ethylene glycol) phosphonates (PEOPAs)‐modified LDH (PMLDH) in chloroform solution. Both X‐ray diffraction data and TEM micrographs of PHB/PMLDH nanocomposites indicate that the PMLDHs are randomly dispersed and exfoliated into the PHB matrix. In this study, the effect of PMLDH on the isothermal crystallization behavior of PHB was investigated using a differential scanning calorimeter (DSC) and polarized optical microscopy. Isothermal crystallization results of PHB/PMLDH nanocomposites show that the addition of 2 wt % PMLDH into PHB induced more heterogeneous nucleation in the crystallization significantly increasing the crystallization rate and reducing their activation energy. By adding more PMLDH into the PHB probably causes more steric hindrance of the diffusion of PHB, reducing the transportation ability of polymer chains during crystallization, thus increasing the activation energy. The correlation among crystallization kinetics, melting behavior and crystalline structure of PHB/PMLDH nanocomposites can also be discussed. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 3337–3347, 2006     

A new method for constructing infinite families of k-tight optimal double loop networks

The double loop network (DLN) is a circulant digraph with n nodes and outdegree 2. DLN has been widely used in the designing of local area networks and distributed systems. In this paper, a new method for constructing infinite families of k-tight optimal DLN is presented. For k = 0,1,…,40, the infinite families of k-tight optimal DLN can be constructed by the new method, where the number nk(t,a) of their nodes is a polynomial of degree 2 in t and contains a parameter a. And a conjecture is proposed.     

Growth and characterization of model oxide catalysts

Oxide catalysts are frequently used to convert toxic species to environmentally benign molecules, and to prevent the formation of toxic species in the first place. In this paper, growth and characterization of model oxide systems employed in both approaches is discussed. An example of the former approach is the selective catalytic reduction (SCR) of NO emitted from power plants by NH₃, which employs tungsten and vanadium oxides supported on the anatase polymorph of TiO₂. To model SCR catalysts, epitaxial titanium, vanadium and tungsten oxide films were grown using molecular beam epitaxy and magnetron sputtering. Two different anatase orientations were grown on LaAlO₃ substrates and their interactions with vanadia were characterized. On LaAlO₃ (0 0 1), anatase exposed a (4 × 1) reconstructed (0 0 1) surface. Vanadia lifted the reconstruction and at 1 ML a (1 × 1) surface with mostly V⁵⁺ was observed. Continued V₂O₅ growth led to loss of order, but at high temperatures epitaxial VO₂ could be grown; vanadia behaved similarly on anatase films on LaAlO₃ (1 1 0). Results suggested that the monolayer is pseudomorphic with O adsorption oxidizing the surface V to 5+, since the anatase structure cannot accommodate more bulk oxygen, only a monolayer can be pseudomorphic and have only V⁵⁺. Thus the vanadia monolayer has unique structural and chemical properties that can help explain why vanadia monolayers on TiO₂ are much more active than bulk V₂O₅. For WO₃, a series of added row reconstructions were observed as the epitaxial films were reduced. The effect of these structures on surface chemistry was characterized by studying 1-propanol adsorption. The results indicated that the structure of the WO₃ surface did not alter its catalytic function but had a strong effect on reaction kinetics. As an example of a system where catalysts prevent the formation of toxic species, the reactivity of oxidized Pd surfaces used in CH₄ catalytic combustion were studied. An ordered PdO-like monolayer was found to be less reactive towards CO than adsorbed O on Pd. On the other hand, the PdO layer favored a lower activation energy C₃H₆ oxidation pathway. The results indicated that Pd oxidation reduces the sticking coefficient of reactive species but once molecules adsorb, the oxide surface can reduce the activation energy for subsequent reaction.     

Resolving Discrepancy between Theoretical and Experimental Optical Trapping Forces Using Effects of Beam Waist and Trapping Position Displacement due to Gravity

Optical trapping forces of polystyrene microspheres are analyzed both theoretically and experimentally, and comparisons are made between the two. Discrepancies are mainly caused by straight-ray approximation for axial trapping, and by trapping-position vertical displacement due to gravity for transverse trapping.