Flow injection determination of bismuth in urine by successive retention of Bi(III) and tetrahydroborate(III) on an anion-exchange resin and hydride generation atomic absorption spectrometry

Bismuth as BiCl₄⁻ and BH₄⁻ ware successively retained in a column (150 mm × 4 mm, length × i.d.) packed with Amberlite IRA-410 (strong anion-exchange resin). This was followed by passage of an injected slug of hydrochloric acid resulting in bismuthine generation (BiH₃). BiH₃ was stripped from the eluent solution by the addition of a nitrogen flow and the bulk phases were separated in a gas–liquid separator. Finally, bismutine was atomized in a quartz tube for the subsequent detection of bismuth by atomic absorption spectrometry. Different halide complexes of bismuth (namely, BiBr₄⁻, BiI₄⁻ and BiCl₄⁻) were tested for its pre-concentration, being the chloride complexes which produced the best results. Therefore, a concentration of 0.3 mol l⁻¹ of HCl was added to the samples and calibration solutions. A linear response was obtained between the detection limit (3σ) of 0.225 and 80 μg l⁻¹. The R.S.D.% (n = 10) for a solution containing 50 μg l⁻¹ of Bi was 0.85%. The tolerance of the system to interferences was evaluated by investigating the effect of the following ions: Cu²⁺, Co²⁺, Ni²⁺, Fe³⁺, Cd²⁺, Pb²⁺, Hg²⁺, Zn²⁺, and Mg²⁺. The most severe depression was caused by Hg²⁺, which at 60 mg l⁻¹ caused a 5% depression on the signal. For the other cations, concentrations between 1000 and 10,000 mg l⁻¹ could be tolerated. The system was applied to the determination of Bi in urine of patients under therapy with bismuth subcitrate. The recovery of spikes of 5 and 50 μg l⁻¹ of Bi added to the samples prior to digestion with HNO₃ and H₂O₂ was in satisfactory ranges from 95.0 to 101.0%. The concentrations of bismuth found in six selected samples using this procedure were in good agreement with those obtained by an alternative technique (ETAAS). Finally, the concentration of Bi determined in urine before and after 3 days of treatment were 1.94 ± 1.26 and 9.02 ± 5.82 μg l⁻¹, respectively.     

单一手性锌配位聚合物：晶体结构，荧光及介电性质

在原位水热条件下,单一手性有机配体(S)-甲基-2-(4-氰基苯胺)-3-(4-羟基苯)丙酸甲酯与叠氮化钠和氯化锌反应,得到了一个新的四唑锌配位聚合物{[Zn(TBHPA)H2O].H2O}n(1,TBHPA=(S)-2-(4-(2H-tetrazol-5-yl)benzylamino)-3-(4-hydroxy-phenyl)propa-noic acid)。单晶结构表明该化合物结晶在手性空间群P212121,CD谱进一步证实该化合物固体粉末具有单一手性。倍频实验结果表明化合物1的SHG(倍频效应)响应大概是尿素的0.6倍。荧光测定结果显示该化合物在428 nm处有较强的荧光发射峰(激发波长319 nm)。另外,还研究了化合物1在室温条件下不同频率的介电常数变化。     

Second-order nonlinear optical properties of side-chain liquid crystalline polymers studied by second harmonic generation from thin films

The two independent elements of the second-order nonlinear optical susceptibility tensor of a range of contact poled, donor–acceptor substitued side-chain polymers are reported. The susceptibilities were measured by second harmonic generation from thin films, typically less than 0.5 μm thick, at a fundamental wavelength of 1064 nm. The largest value was χ = 2.64 pm/V which is three times greater than the χ value of KDP and was measured in a nitrobenzylidene side chain, polyhydroxystyrene polymer with an eleven unit alkyl chain spacer attaching the side group to the backbone. Typical susceptibility values obtained were χ～0.3 pm/V and X⁽²⁾₃₃～1 pm/V. The coherence lengths of the materials, which lay in the range 4–12 μm, were measured at 1064 nm by the maker fringe technique using thick, wedge-shaped samples.     

Highly Dispersed and Small‐Sized Nickel(II) Hydroxide Co‐Catalyst Prepared by Photodeposition for Hydrogen Production

Photodeposition has been widely used as a mild and efficient synthetic method to deposit co‐catalysts. It is also worth studying how to synthesize non‐noble metal photocatalysts with uniform dispersion. Different synthetic conditions in photodeposition have a certain influence on particle size distribution and photocatalytic activity. Therefore, we designed experiments to prepare the inexpensive composite photocatalyst Ni(OH)₂/g‐C₃N₄ by photodeposition. The Ni(OH)₂ co‐catalysts disperse uniformly with particle sizes of about 10 nm. The photocatalytic hydrogen production rate of Ni(OH)₂/g‐C₃N₄ reached about 19 mmol g^?1 h^?1, with the Ni(OH)₂ deposition amount about 1.57 %. During 16 h stability testing, the rate of hydrogen production did not decrease significantly. The composite catalyst also revealed a good hydrogen production performance under sunlight. The Ni(OH)₂ co‐catalyst enhanced the separation ability of photogenerated carriers, which was proved by surface photovoltage and fluorescence analysis.     

Next-generation quantum theory of atoms in molecules for the photochemical ring-opening reactions of oxirane

The conical intersections corresponding to the C─O and C─C ring opening were optimized and the reaction paths traversing these intersections were obtained. Investigation of the C─O ring opening revealed that when traversing the lowest energy conical intersection, the reaction path returns to the closed ring geometry. The C─O path traversing the intersection featuring torsion of terminal CH₂ group however, led to a ring-opened geometry, an H-shift and the formation of acetaldehyde that can undergo further dissociation. The observation of different reaction paths was explained by the 3-D paths from quantum theory of atoms in molecules (QTAIM) that defined the most preferred direction of electronic motion that precisely tracked the mechanisms of bond breaking and formation throughout the photo-reactions. The size, orientation, and location of these most preferred 3-D paths indicated the extent and direction of motion of atoms, bonds, and the degree of torsion or planarity of a bond indicating a predictive ability.     

A genetic algorithm for the automated generation of molecules within constraints

Summary A genetic algorithm has been designed which generates molecular structures within constraints. The constraints may be any useful function, for example an enzyme active site, a pharmacophore or molecular properties from pattern recognition or rule-induction analyses. The starting point may be random or may utilise known molecules. These are modified to grow into families of structures which, using the evolutionary operators of selection, crossover and mutation evolve to better fit the constraints. The basis of the algorithm is described together with some applications in lead generation, 3D database construction and drug design. Genetic algorithms of this type may have wider applications in chemistry, for example in the design and optimisation of new polymers, materials (e.g. superconducting materials) or synthetic enzymes.     

Simultaneous determination of arsenic, antimony and selenium by gas-phase diode array molecular absorption spectrometry, after preconcentration in a cryogenic trap

This paper describes a method for the simultaneous determination of As(III), Sb(III) and Se(IV) by combining hydride generation and gas phase molecular absorption spectrometry. A system for continuous hydride generation has been designed and developed, based on the use of a double process of gas-liquid separation, and optimal compromise operation conditions for the three compounds have been found. After generation, the hydrides are collected in a liquid nitrogen cryogenic trap, and then evaporated and driven to the flow cell of a diode array spectrophotometer, in which the transient signals over the 190–250 nm wavelength interval are measured. Under the recommended conditions (sample flow: 35 ml min⁻¹, 0.5 M HCl; reductor flow: 4 ml min⁻¹ of 4% NaBH₄, solution) linear response ranges above 50 μg 1⁻¹ for As(III), 30 μg 1⁻¹ for Sb(III) and 200 μg 1⁻¹ for Se(IV) are obtained with detection limits of 22 μg 1⁻¹, 15 μg 1⁻¹ and 65 μg 1⁻¹, respectively. Multiwavelength linear regression equations were used for the simultaneous determination of the three elements in different synthetic samples, with good precision and accuracy and to study simultaneously the interference from different chemical species for the three compounds. Results were similar to those obtained by other techniques using hydride generation.     

氢化物发生石墨炉原位富集直接测定高温镍基合金中碲

通过选择碲的氢化物发生条件，克服了高含量镍对碲的干扰，把氢化物富集在涂钯石墨管里，然后再原子化，成功地测定了高温镍基合金中碲。     

钯作基体改进剂FIA－HG－GFAAS法测定锗及其机理研究

采用钯，钯－镁作基体改进剂，ＦＩＡ－ＨＧ－ＧＦＡＡＳ法成功地测定了锗。灵敏度、精密度和分析速度都得到很大的提高。峰值吸收的特征质量８．０ｐｇ，检出限１０．９ｐｇ，相对标准偏差０．３４％，同时探讨了基体改进剂钯的稳定作用机理及锗在石墨管中的原子化机理。     

磷脂酰胆碱LB单分子膜诱导下KDP晶体取向生长的研究

有机超薄膜诱导晶体生长是在化学、物理与生物多门学科相互交融的基础上发展起来的新兴学科 ,并逐渐成为仿生合成的重要分支 [1] .目前的研究重点主要集中于以有机化合物 LB膜作为模板剂诱导生物矿化材料上 [2～ 5] .磷脂 LB膜是生物膜的简化模型体系 [6 ] ,用它作模板剂将使该领域的研究进一步接近生物体系 .对晶体而言 ,修饰晶体材料的特征对于改善和测定材料的光学性能至关重要 [2 ] ,但目前有关上述领域的研究几乎均是空白 .KH2 PO4 ( KDP)晶体是性能优良的非线性光学材料 [7] ,本文首次以磷脂分子 LB膜作为模板剂诱导 KDP的晶化…