G.652光纤长途传输系统的色散补偿

针对当前国内长途传输光缆系统在扩容过程中，因光信号色散而影响传输质量的现象，结合实际工程建设，分析了光信号色散的危害及其成因，并提出了相应的解决办法及建议。     

Transmission Fiber Chromatic Dispersion Dependence on Temperature: Implications on 40 Gb/s Performance

In this letter, we will evaluate the performance degradation of a 40 km high‐speed (40 Gb/s) optical system, induced by optical fiber variations of the chromatic dispersion induced by temperature changes. The chromatic dispersion temperature sensitivity will be estimated based on the signal quality parameters.     

Advanced modulation formats for more robust optical transmission systems

Interest in advanced modulation formats for optical communication systems has so far experienced two major waves. The first one was motivated by the potential to enhance receiver sensitivity of thermal noise-limited systems using coherent detection in combination with phase shift keying. It ended with the advent of optical amplification, enabling high sensitivities together with polarization insensitive, simple and stable direct detection. The second wave is still rolling, fueled by the potential of advanced modulation formats to increase robustness of optical transmission systems against signal distortions. Due to performance limitations given by direct detection and nonlinear effects in the transmission fiber, it is not decided yet, whether there will be widespread application in carrier networks.     

光波分复用技术及其应用

分析了波分复用系统的组成原理和几种分类方式,最后给出了一些基本应用形式。     

An experimental study of dynamic tensile properties of glass fiber at low-temperatures

Tensile impact experiments of EC8.0−24×7 glass fiber bundles at different low temperaturesT(14°C, −40°C and −10°C) and strain rates ɛ were carried out, and complete stress-strain curves were obtained. Within the range of the experiment temperatures and strain rates, it is found that the initial modulusE, the ultimate strength σ_max and the unstable strain ɛ _b of the glass fiber bundles all increase with ɛ at an identicalT. At an identical ɛ, with the decrease ofT, E and σ_max increase; but ɛ _b increases when 10°C>T>−40°C and decreases when −40°C>T>−100°C. The strain-rate- and temperature-dependent bimodal Weibull statistical constitutive theory was adopted for the statistical analysis of the experimental results, and the Weibull parameters of single fiber were obtained. The results show that the bimodal Weibull distribution function is suitable to represent the strength distribution of the glass fiber at low temperature and different strain rates. The differences in the mechanical properties between EC8.0−24×7 and EC5.5−12 ×14 glass fiber bundles were also discussed. Project supported by the National Natural Science Foundation of China (No. 19772058).     

光纤放大器增益饱和对有源光纤环形腔滤波特性的影响

从理论和实验两个方面研究了有源光纤环形腔滤波器输入光功率对光纤放大器增益的影响及由此引起的对有源光纤环形腔滤波特性的影响。在考虑上述影响的情况下 ,对有源光纤环形腔滤波器参数的优化作了讨论     

高精度的光纤衰减系数测试系统的设计

利用常规仪器设备，设计了一套集光、机、电为一体的光纤衰减测量,实现了数字化监测显示，并可与微机接口；采用双光路法，消除了由于光源光强不稳定产生的误差。     

An ASE Reduction Filter Using Cascaded Optical Fiber Grating Couplers in EDFA Repeater

A new configuration for an ASE reduction filter in EDFA repeaters for WDM optical transmission systems using optical fiber grating couplers (FGCs) was proposed and first demonstrated. The filtering characteristics of the proposed filter for amplified single wavelength signal and 2-channel WDM signals using EDFA were identified. It was found that the filter was effective to improve SNR in optical domain by reducing ASE noise. The required FGC characteristics for the filter were theoretically predicted under the condition that the total filter loss did not exceed 3 dB. More than 70% of drop efficiency was required in each FGC for the application of the proposed filter to an 8-channel WDM system using EDFA repeaters.     

等效可变孔径远场法测量单模光纤模场半径

本文提出等效远场的可变孔径方法,由测量光纤远场累积分布求得模场半径。并且利用Petermann关于模场半径的新定义,推出了一种对非高斯模场分布也适用的求模场半径的方法。实验表明,这种测量方法简便可靠,在不同的制备端面下,重复测量的标准误差小于0.04μm。     

Determination of ultra-trace gold in natural water by graphite furnace atomic absorption spectrophotometry after in situ enrichment with thiol cotton fiber

A simple method of determining ultra-trace Au in natural water was presented by using graphite furnace atomic absorption spectrophotometry (GFAAS) after in situ enrichment with thiol cotton fiber (TCF). The sample solution was adjusted to pH 1.5-2.0 with HCl, then the water sample was passed through a column packed with 0.10-0.20 g TCF and the flow rate was controlled at 20-40 ml min⁻¹. The effects of interferences, such as complexing and oxidizing agents and other elements adsorbed on TCF were overcome by chemical treatments prior to the desorption of Au. The adsorbed Au was adsorbed with 2.0 ml hot acid, then it was extracted with 1.00 ml methyl isobutylketone (MIBK). For a 5 l water sample, the detection limit of Au is 0.02 ng l⁻¹. The relative standard deviation (R.S.D.) for the determination of 1.44 ng l⁻¹ Au was 9.4%.The method was applied to determine ultra-trace Au both in suspended phase and soluble phase in natural water, the concentrations of total Au in natural water samples range from 0.51 to 67.82 ng l⁻¹. The recovery of added 0.50-6.00 ng l⁻¹ Au was 80-95%. The method is useful in prospecting for Au deposits by means of hydrogeochemical methods. The enrichment is carried out in the field, and then the determination of Au is completed later in the laboratory.