基于OpenGL的包装纸盒设计的三维实现

提出了基于OpenGL技术的一种由面模型构造三维盒体的方法,以多边形组成一个面、以面为基本单元构造纸盒,并将其应用于三维包装纸盒设计系统的开发中,该系统不仅实现了纸盒结构的二维平面设计,而且能够仿真三维盒型,并采用贴图技术看到装潢设计的立体效果。     

MMS在中国市场的成功运营之道

MMS作为移动通信运营商最近推出的一类业务新品．受到了众多国外手机厂商的热情追捧。MMS在国内市场的成长空间有多大?手机厂商的对策是什么?本文试图运用SWOT战略分析矩阵及三点效用模型对MMS手机的市场进入机会及厂商的营销策略进行研究，旨在探讨MMS在中国市场的成功运营之道。     

含气率对PTS时压力容器内流动与传热的影响

本文对反应堆压力容器紧急安注时的流动与传热特性在1/10的模型上进行了流动可视化、局部传热系数以及混合函数的试验研究。针对三个热冲击敏感区域的部分测点,比较了环腔流速为0.5m/s、安注流速为1～30 m/s时不同含气率对下降环腔内流动与传热特性的影响,得出并分析了不同测点传热系数、混合函数的变化规律。研究结果表明:随着含气率增大,安注流体与环腔流体的混合增强;下降环腔内的含气率对小安注流速时的流动与传热影响显著,而对大安注流速时影响较小。     

基于WVD的防空雷达直升机信号特征分析

基于直升机目标旋转部件的调制模型，本文针对防空雷达提出了分析直升机信号特征的一种新方法——WVD法，并对直升机目标旋转部件调制回波信号在不同噪声情况下加以仿真分析，结果表明：用WVD分析雷达回波中直升机信号特征是一种非常有效的方法。     

Sensitivity analysis of thermal performances of flat plate solar air heaters

Sensitivity analysis is a mathematical tool, first developed for optimization methods, which aim is to characterize a system response through the variations of its output parameters following modifications imposed on the input parameters of the system. Such an analysis may quickly become laborious when the thermal model under consideration is complex or the number of input parameters is high. In this paper, we develop a mathematical model to analyse the heat exchanges in four different types of solar air collectors. When building this thermal model we show that for each collector, at quasi-steady state, the energy balance equations of the components of the collector cascade into a single first-order non-linear differential equation that is able to predict the thermal behaviour of the collector. Our heat transfer model clearly demonstrates the existence of an important dimensionless parameter, referred to as the thermal performance factor of the collector, that compares the useful thermal energy which can be extracted from the heater to the overall thermal losses of that collector for a given set of input parameters. A sensitivity analysis of our thermal model has been performed for the most significant input parameters such as the incident solar irradiation, the inlet fluid temperature, the air mass flow rate, the depth of the fluid channel, the number and nature of the transparent covers in order to measure the impact of each of these parameters on our model. An important result which can be drawn from this study is that the heat transfer model developed is robust enough to be used for thermal design studies of most known flat plate solar air heaters, but also of flat plate solar water collectors and linear solar concentrators.     

双掺(Tm3+,Tb3+)LiYF4激光器1.5 μm波长激光阈值分析

由速率方程推出了双掺（Tm^3 ,Tb^3 ）离子准四能级系统的激光阈值解析式，讨论了Tm^3 和Tb^3 离子之间的相互作用。分析了1.5μm波长附近的激光阈值和Tm^3 、Tb^3 离子的掺杂原子数分数及晶体长度的关系。结果表明，对于对应Tm^3 离子^3H4→^3F4跃迁的约1.5μm波长的激光，激活离子Tm^3 的掺杂原子数分数过大时，交叉弛豫作用将使系统阈值迅速增加。Tb^3 离子的加入，一方面能抽空激光下能级，起到降低阈值的作用；另一方面亦减少了激光上能级的寿命，使阈值升高。故Tb^3 离子有最佳掺杂原子数分数。对于Tm原子数分数为y=0.01的Tm:LiYF4晶体，Tb^3 离子的最佳掺杂原子数分数为0.002左右，同时表明，激光阈值与晶体长度有关。最佳晶体长度与Tm^3 、Tb^3 离子的掺杂原子数分数以及晶体的衍射损耗和吸收损耗有关。     

热作模具钢表面激光堆焊耐磨合金层的研究

本文主要通过在H13钢上用大功率CO_2激光束进行堆焊,阐述了激光堆焊工艺变化对堆焊组织和性能的影响,在本试验条件下,得到了高密度弥散金属化合物组织的激光堆焊层,平均硬度为HV800,与基体呈冶金结合,耐磨性比H13模具钢提高149%。     

大功率CO2激光器脉冲电源研究

本文论述了直流高压与高频脉冲电源相叠加，构成高频、高压脉冲电源，并使其对CO2激光器进行放电实验，研究了同条件下的放电参数与功率。     

硅微机械梳齿静电谐振器的建模与分析

基于参数化的计算机辅助设计（CAD）软件，对硅微机械梳齿静电谐振器进行了实体建模，以有限元分析软件为工具，进行了谐振器的模态分析，静态分析和谐响应分析，初步揭示了谐振器的静、动态特性，有助于改善设计效率和质量，展示了计算机辅助工程（CAE）技术在微机电系统（MEMS）研究中的重要作用。     

A Combined Antenna Array and Multi-User Detection DS-CDMA Receiver in Single-Path and Multi-Path Fading Channels

An adaptive antenna array is incorporated into a decorrelatingmulti-user detector to effectively increase the DS-CDMA system capacity.Capacity improvement is due to beamforming gain, spatial diversity gain(assuming large angle spread), and the decorrelating effect. Thereceiver has been analyzed for the cases of sufficiently andinsufficiently spaced receiving antennas. The receiver consists of afront-end beamformer for every user in the cell and has knowledge of allusers' signature sequences. The beamformer estimates the desired userchannel vector, enhancing its signal and reducing the co-channelinterference from other directions. The multi-user detection, exploitingknowledge of other users, rejects those interferers whose arrival anglesare close to that of the desired user. The average uncoded Bit ErrorRate (BER) as a function of the number of in-beam active users, theaverage antenna Signal-to-Noise Ratio (SNR), and the number of receivingantennas is examined in both single-path and multi-path Rayleigh fadingchannels. Analysis shows an increase in system capacity proportional tothe number of receiving antennas.