全光纤脉冲压缩器的理论及实验研究

对色散位移光纤＋普通单模光纤构成的全光纤脉冲压缩器进行了理论分析，分析了压 缩效果与光纤参数及输入脉冲参数的关系；对不同中心波长和脉宽的主动锁模光纤激光器的 输出脉冲进行了压缩实验，均得到了近变换限Sech的压缩脉冲，实验结果与理论分析一致. 关键词： 全光纤脉冲压缩器 压缩因子 基座能量 主动谐波锁模光纤 激光器     

Realization of Tapered Waveguide by Stretching the Rod Waveguide

By stretching the rod waveguide with different velocities in opposite directions, the tapered waveguide can be fabricated. In condition of taking no account of volume expansion caused by heating and under the assumptions of volume conservation,the rod waveguide can be stretched freely in the heated region without being stretched outside of the heated region. A model,which shows the relation of the transition shape and the two factors, that is the ratio of two velocity and the heated region length, is presented for the shape of the taper transition through mathematic deduction. Based on this model, a desired tapered waveguide can be fabricated. The tapered waveguide are widely used for fabricating tapered fiber couplers and sensors. In addition, the conclusion can be used for fabricating fused fiber coupler.     

Experimental Research on Erbium-doped Superfluorescent Fiber Source

The effects of the variations in fiber length, fiber mirror reflectance on efficiency and output power are experimentally investigated for erbium-doped double pass backward superfluorescent fiber sources (SFSs). The influence of fiber length on mean wavelength stability (MWS) has also been demonstrated. By incorporating a short section of un-pumped erbium-doped fiber (EDF) at the output port, the pump power dependent on MWS becomes independent of pumped EDF length. This is a novel phenomenon that hasn‘t been reported up to now,and should be helpful to SFS fabrication and theory analysis. By using a fiber Michelson interferometer as spectrum slicing component,a multi-wavelength fiber source (MWFS) with ～20 channels (from 1542nm to 1559nm) is got. The MWFS has a channel spacing of ～0. 8 nm which satisfies ITUstandard. The intensity fluctuation among channels is less than 0.5dB,and the extinction ratio of all channels is above 14dB. This kind of MWFS should be useful to wavelength division multiplexing systems.     

Two-Frequency Brillouin Fiber Laser Based on Bragg Grating Fabry-Perot Cavity

A novel and simple two-frequency Brillouin fiber laser is presented. It is based on a fiber Fabry-Perot cavity with fiber Bragg gratings as reflectors. The model of stimulated Brillouin scattering in fiber grating-based Fabry-Perot resonator is investigated. The laser allows conversion efficiency of close to 100% and suppresses the higher-order Stokes waves. The theoretical prediction is presented and the experimental demonstration is realized.     

高能、超短脉冲、可调谐激光器用掺镱氟磷酸盐玻璃研究进展

Yb^3 与其它稀土离子相比有最简单的能级结构，这使它具有一些独特的性质，如避免激发态吸收，消除上转换和浓度猝灭等，因此它是高能输出激光器介质的理想掺杂离子。氟磷玻璃综合了氟化物玻璃和磷酸盐玻璃的优点，可降低磷酸盐的声子能量，改善其易吸湿性；提高氟化物玻璃的物理化学性能等，这使它成为稀土掺杂可调谐光纤激光器的很好的掺杂介质。众多研究表明，Yb^3 掺杂氟磷玻璃是一种很有前途的激光工作物质。本文总结了Yb^3 掺杂氟磷玻璃的特点，性质，结构及存在的问题。     

光纤传感振动检测系统及其实验研究

实际工程结构中的振动检测是十分重要的，也是十分复杂的，常用的结构振动检测传感器易受工程现场恶劣环境的影响．而光纤传感器具有小巧、抗电磁干扰、灵敏度高、适合长期监测等优点。本文建立了基于马赫—曾德(Mech-Zehnder)干涉原理的光纤传感振动检测系统．研制了运用先进的数字信号处理技术采集和处理数据的专用软件，并在典型结构件——钢制悬臂梁结构上进行了外加信号作用下的强迫振动检测和冲击载荷作用下的自由衰减振动检测，测量了该结构件的频率及振幅，其结果与同时进行的成熟的电测结果相近，说明光纤传感器用于结构件的振动测量是可靠的。本文为光纤传感器应用于实际工程的振动检测提供了新的技术装置，具有工程应用前景。     

Light Diffraction of Aligned Polymer Fibers Periodically Dispersed by Phase Separation of Liquid Crystal and Polymer

We have confirmed light diffraction of aligned polymer fibers obtained by a phase separation of an anisotropic-phase solution of liquid crystal and polymer. He—Ne laser light passing through the polymer fibers was scattered in the axis vertical to the fibers, and had two peaks of light intensity symmetrical to the center of the transmitting laser spot. The two peaks were found to be caused by light diffraction due to the periodic polymer-fiber dispersion because the peaks corresponded to values calculated by intervals between the fibers. The periodical fiber networks are considered to be formed by anisotropic spinodal decomposition. This effect can be used to measure the dispersion order of the polymer fibers. © 2004 The Optical Society of Japan     

Composite Silica Particles Using a Mixture of Organosilane Monomers

Composite silica particles were synthesized by a two-step (acid-base) process in an aqueous solution with a mixture of organoalkoxysilane monomers. The two-step process separates the hydrolysis and condensation procedures to easily control condensation rate. In this study, the silane monomers used were phenyltrimethoxysilane (PTMS), vinyltrimethoxysilane (VTMS), methyltrimethoxysilane (MTMS), and tetraethyl-orthosilicate (TEOS). The physical properties of the resultant composite particles were investigated with the change in the molar ratio of monomers. The size of the particles increased with increasing the molar ratio of R_aSi(OR)₃/R_bSi(OR)₃ or R_aSi(OR)₃/TEOS (R_a: phenyl; R_b: vinyl, methyl).     

Completely biodegradable composites of poly(propylene carbonate) and short,lignocellulose fiber Hildegardia populifolia

The composites of biodegradable poly(propylene carbonate) (PPC) reinforced with short Hildegardia populifolia natural fiber were prepared by melt mixing followed by compression molding. The mechanical properties, thermal properties, and morphologies of the composites were studied via static and dynamic mechanical measurements, thermogravimetric analysis, and scanning electron microscopy (SEM) techniques, respectively. Static tensile tests showed that the stiffness and tensile strength of the composites increased with an increasing fiber content. However, the elongation at break and the energy to break decreased dramatically with the addition of short fiber. The relationship between the experimental results and the compatibility or interaction between the PPC matrix and fiber was correlated. SEM observations indicated good interfacial contact between the short fiber and PPC matrix. Thermogravimetric analysis revealed that the introduction of short Hildegardia populifolia fiber led to a slightly improved thermooxidative stability of PPC. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 666–675, 2004     

NMR investigation of concentrated alumina and silica slurries

The longitudinal relaxation times (T₁) of water in concentrated silica and alumina slurries were measured as a function of solids content. It was shown that the results could be fit very well with a two-phase fast-exchange model between free and surface-bound water. As expected, values of T₁ for bound water were in the order of 20–2000 times lower than that for free water, indicating a higher effective viscosity of the surface-bound water. The strength of the interaction depended on the particular surface, and all of the aluminas examined interacted more strongly with water than the two silicas studied, which themselves differed considerably. The chemical mechanical polishing (CMP) removal rate of tantalum by silica slurries was shown to be directly correlated with the interaction parameters, derived from the NMR relation times rather than with total surface hydroxyl group concentration.