Solid Phase Extraction and Flame Atomic Absorption Spectrometric Determination of Trace Amounts of Zinc and Cobalt Ions in Water Samples

A simple and rapid method for the preconcentration of Co²⁺ and Zn²⁺ as their 2-guanidino-benzimidazole chelates is proposed using an octadecyl silica cartridge. The retained analytes were recovered with a mixture of 5mL of 0.01M HNO₃ and 5mL of methanol. The metal ions in the effluent were determined by flame atomic absorption spectrometry. The effect of different parameters, such as sample matrix, amount of ligand, type of eluent for elution of ions from cartridge, flow rates of sample solution and eluent, breakthrough volume, and limit of detection, were evaluated. The effects of various cationic and anionic interferences on the percent recovery of Co²⁺ and Zn²⁺ were also studied. Quantitative extraction efficiencies were obtained by elution of the cartridge with a minimal amount of solvent. Hence, with a typical preconcentration factor of 50, the limits of detections of the proposed method are 0.26 and 1.62ngmL^–1 for Zn²⁺ and Co²⁺, respectively. The method was applied to the determination of zinc and cobalt ions in different water samples.     

火焰原子吸收光谱法测定铅锌混合精矿中高含量的银

建立了以硝酸-硫酸溶样,在碱性介质中用火焰原子吸收光谱法测定铅锌混合精矿中高含量银的分析方法对硫酸用量、碱性介质的浓度、干扰离子等进行了探讨在0～4μg/mL范围内,银含量与吸光度呈线性关系,相关系数为0．9993加标回收率为98．78％～102．56％,测量结果的相对标准偏差小于2．0％,测定范围为500～3000g/t。     

火焰原子吸收光谱法间接测定青霉素V钾

基于青霉素V钾在酸性条件下的水解产物可与Pb2 + 形成沉淀 ,用火焰原子吸收光谱法测定沉淀中铅的含量 ,可间接测定药片中青霉素V钾的含量。在优化条件下 ,测定青霉素V钾的线性范围为 5 .15× 10 -5～ 4 .12× 10 -4mol/L ,线性回归方程为A =2 .4 2× 10 3 c - 0 .0 6 3 1,相关系数为 0 .999 1,检出限为 7.392× 10 -7mol/L ,测定结果的相对标准偏差为 0 .0 6 %～ 0 .6 9% ,回收率为 97.8%～ 10 2 .0 %。     

Acid-base sensors based on novel quinone-type dyes

We present a detailed study on the acid-base behaviour of a family of "potentially antiaromatic" p-benzoquinonediimine ligands. These 12pi electron molecules can be considered as constituted of two chemically connected but electronically not conjugated 6pi-electron subunits. Upon successive protonation, "mono" and "double" cyanine-type chromophores are generated in solution and allow a precise and sensitive spectrophotometric detection. These molecules represent a new class of tunable quinones whose electronic and structural properties can be triggered by proton input, as established by a complete physico-chemical study involving a combination of potentiometric and spectrophotometric methods (absorption and emission).     

Determination of inorganic arsenic species As(III) and As(V) by high performance liquid chromatography with hydride generation atomic absorption spectrometry detection

The paper presents the principles and advantages of a technique combining high performance liquid chromatography and hydride generation atomic absorption spectrometry (HPLC-HGAAS) applied to speciation analysis of inorganic species of arsenic As(III) and As(V) in ground water samples. With separation of the arsenic species on an ion-exchange column in the chromatographic system and their detection by the hydride generation atomic absorption spectrometry, the separation of the analytical signals of the arsenic species was excellent at the limits of determination of 1.5 ng/ml As(III) and 2.2 ng/ml As(V) and RSD of 4.3% and 7.8% for the concentration of 25 ng/ml. The hyphenated technique has been applied for determination of arsenic in polluted ground water in the course of the study on migration of micropollutants. For total arsenic concentration two independent methods: HGICP-OES and HGAAS were used for comparison of results of real samples analysis.     

XANES Determination of Intraatomic Potentials

A new scheme has been developed for determining the parameters of the local one-electron potential in molecules and solids. The scheme is based on interpretation of the experimental X-ray absorption near edge struucture. The scheme is an extension of the method for solving the inverse problem of XANES theory suggested by one of the authors. In this scheme, oscillator strengths and maximum heights are considered along with the energy and half-width of spectral maxima. The scheme is used for determining the intraatomic potential in the nitrogen molecule.Original Russian Text Copyright © 2004 by Yu. F. Migal and O. M. Kholodova__________Translated from Zhurnal Strukturnoi Khimii, Vol. 45, No. 6, pp. 986–989, November–December, 2004.     

Two-photon absorption in quadrupolar pi-conjugated molecules: influence of the nature of the conjugated bridge and the donor-acceptor separation

Quadrupolar-type substitution of pi-conjugated chromophores with donor and acceptor groups has been shown to increase their two-photon absorption (TPA) response by up to two orders of magnitude. Here, we apply highly correlated quantum-chemical calculations to evaluate the impact of the nature of conjugated bridge and the charge-transfer distance on that enhancement. We compare chromophores with phenylenevinylene-, thienylenevinylene-, polyene-, and indenofluorene-type backbones substituted by dimethylamino and cyano groups. In all compounds, we find a strongly TPA-active A(g) state (either 2A(g) or 3A(g)) in the low-energy region, as well as a higher lying TPA-active state (mA(g)) at close to twice the energy of the lowest lying one-photon allowed state; the smaller energy detuning in the mA(g) states results in very large TPA cross sections delta. We also investigate the influence of the degree of ground-state polarization on TPA. Independent of the nature of the backbone and the donor-acceptor separation, delta displays the same qualitative evolution with a maximum before the cyanine-like limit; the highest TPA cross sections are calculated for distirylbenzene- and polyene-based systems.     

Study of parameters associated with the determination of cadmium in lake sediments by slurry sampling electrothermal atomic absorption spectrometry

Cadmium concentration in lake sediments is determined by suspending the solid samples in a solution containing 5% (v/v) concentrated nitric acid and 0.1% (v/v) Triton X-100. Three modifiers were tested for the direct determination. The furnace temperature programmes and appropriate amount for each modifier were optimised to get the highest signal and the best separation between the atomic and background signals. The drying stage is performed by programming a 400 °C temperature, a ramp time of 25 s and hold time of 10 s on the power supply of the atomiser. No ashing step is used and platform atomisation is carried out at 2200 °C. W–Rh permanent modifier combined with conventional modifier by delivering 10 μl of 0.50% (w/v) NH₄H₂PO₄ solution was the best chemical modifier for cadmium determination. This modifier also acts as a liquid medium for the slurry, thus simplifying the procedure. Calibration is performed using aqueous standards in the 1–5 μg l⁻¹ range. The optimised method gave a limit of detection of 0.56 ng ml⁻¹, characteristic mass of 10.1±0.8 pg for aqueous standard, 9.6±0.7 pg for slurry samples containing different Cd concentrations and good precision (7.6–5.2%). The method was validated by analysing four certified reference lake sediment materials: LKSD-1, LKSD-2, LKSD-3 and LKSD-4; satisfactory recoveries were obtained (90.0–96.3%) and no statistical differences were observed between the experimental and the certified cadmium concentration. The developed methodology was used to determine cadmium in three ‘real’ sediment samples from lakes in the area of Wielkopolski National Park, Poland.     

Flow injection determination of bismuth in urine by successive retention of Bi(III) and tetrahydroborate(III) on an anion-exchange resin and hydride generation atomic absorption spectrometry

Bismuth as BiCl₄⁻ and BH₄⁻ ware successively retained in a column (150 mm × 4 mm, length × i.d.) packed with Amberlite IRA-410 (strong anion-exchange resin). This was followed by passage of an injected slug of hydrochloric acid resulting in bismuthine generation (BiH₃). BiH₃ was stripped from the eluent solution by the addition of a nitrogen flow and the bulk phases were separated in a gas–liquid separator. Finally, bismutine was atomized in a quartz tube for the subsequent detection of bismuth by atomic absorption spectrometry. Different halide complexes of bismuth (namely, BiBr₄⁻, BiI₄⁻ and BiCl₄⁻) were tested for its pre-concentration, being the chloride complexes which produced the best results. Therefore, a concentration of 0.3 mol l⁻¹ of HCl was added to the samples and calibration solutions. A linear response was obtained between the detection limit (3σ) of 0.225 and 80 μg l⁻¹. The R.S.D.% (n = 10) for a solution containing 50 μg l⁻¹ of Bi was 0.85%. The tolerance of the system to interferences was evaluated by investigating the effect of the following ions: Cu²⁺, Co²⁺, Ni²⁺, Fe³⁺, Cd²⁺, Pb²⁺, Hg²⁺, Zn²⁺, and Mg²⁺. The most severe depression was caused by Hg²⁺, which at 60 mg l⁻¹ caused a 5% depression on the signal. For the other cations, concentrations between 1000 and 10,000 mg l⁻¹ could be tolerated. The system was applied to the determination of Bi in urine of patients under therapy with bismuth subcitrate. The recovery of spikes of 5 and 50 μg l⁻¹ of Bi added to the samples prior to digestion with HNO₃ and H₂O₂ was in satisfactory ranges from 95.0 to 101.0%. The concentrations of bismuth found in six selected samples using this procedure were in good agreement with those obtained by an alternative technique (ETAAS). Finally, the concentration of Bi determined in urine before and after 3 days of treatment were 1.94 ± 1.26 and 9.02 ± 5.82 μg l⁻¹, respectively.