铜基催化剂的结构、物性及其对混合碳四选择加氢反应的催化性能

 用XRD，XPS，SEM和H2－TPR等手段研究了铜基负载型催化剂的结\r\n构和物性及其对混合碳四加氢脱炔的催化性能．结果表明，在负载铜催\r\n化剂中加入一定量的Co可提高催化剂的加氢脱炔活性，而Co含量较少时\r\n加入少量的Ce也能提高催化剂的活性和选择性．Cu和Co之间存在着相互\r\n协同作用，使得活性组分在催化剂表面偏析，CuO在催化剂表面呈非晶\r\n相分散状态，催化剂颗粒粒径变小，催化剂更容易被还原，从而改善了\r\n催化剂的催化性能．     

催化裂化汽油脱硫添加剂USY/ZnO/Al2O3的性能评价

 在固定流化床催化裂化装置上，以减压蜡油为原料，对制备的U\r\nSY／ZnO／Al2O3催化裂化汽油脱硫添加剂的性能进行了评价．结果表明\r\n，随着添加剂添加量和剂油比的增加，生成汽油的硫含量降低．在500\r\n℃和剂油比为5的条件下，在FCC平衡催化剂中添加30％的添加剂时，汽\r\n油的硫含量可由不加添加剂时的1230μg／g降低到770μg／g左右．添\r\n加剂的添加量（10％）较低时，对催化裂化产物的分布基本没有影响；\r\n添加30％的添加剂时，焦炭的产率有所增加，但汽油收率基本不变．X\r\nRD表征结果表明，USY／ZnO／Al2O3添加剂中的ZnO对USY的晶相结构有\r\n一定的破坏作用，但随着反应与再生次数的增多，ZnO与Al2O3之间形成\r\n较为稳定的锌铝尖晶石结构，使添加剂的性能趋于稳定．     

The study of electron beam flue gas treatment for coal-fired thermal plant in Japan

The fundamental research work with simulated coal-fired flue gas was performed in JAERI to get basic data for electron beam treatment of flue gas from thermal power plants in Japan. The standard condition of the experiments was set to be the same as that of next large scale pilot test in Nagoya. The concentrations of NO_x and SO_x were 225 ppm and 800 ppm, respectively. The temperature of the system was 65°C. The effect of multiple irradiation was observed for NO_x removal. The target SO_x and NO_x removals (94% and 80%, respectively) with low NH₃ leakage (less than 10 ppm) were achieved at 9 kGy irradiation with 0.9 NH₃ stoichiometry during 7 hours continuous operation. The facility for the pilot plant (12,000 Nm³/hr) has just built at the site of Shin-Nagoya power plant of Chubu Electric Power Company and will be started in full operation in November 1992.     

利用H2与金属氧化物的选择性反应从CO中除H2

研究了一些氧化物的H2－TPR及CO－TPR行为,结果发现,Co3O4／Al2O3,NiO／SiO2,NiO和Pd／NiO的H2－TPR温度要低于它们的CO－TPR温度,特别是Pd／NiO样品,它的H2－TPR温度为598K,而其CO－TPR温度高达949K,差别为351K,因此有可能利用Pd／NiO在一定温度下选择性地与CO中的H2反应而将其除去. 实验结果表明,Pd／NiO可在603K及4000h-1的条件下从H2（0.34％）,CO（50％）和N2（余）的混合气中选择性地除去90％以上的H2,吸氢容量为每克样品55mL标准态H2.     

Protection of immobilized sulfhydryl groups against autooxidation by alterations in their microenvironment

Immobilized sulfhydryl groups were prepared by partial thiolation of NH₂-glass beads. The microenvironment of the immobilized SH groups was varied by different chemical modifications of neighboring NH₂ groups. Introduction of a strong charge in the surroundings of immobilized sulfhydryls results in their dramatic stabilization against autooxidation. This effect is due to the salting of O₂ from the surface microlayer of the thiolated beads.     

Synthesis of Nonracemic 9-(1-Methoxycarbonylethyl)-1,2,3,4-tetrahydrocarbazole

A new approach has been proposed to the synthesis of indole derivatives containing a chiral substituent at the nitrogen atom, comprizing Fischer indolization of phenylhydrazines with a chiral substituent at the -nitrogen atom. The initial hydrazines were obtained by the alkylation (Mitsunobu reaction applying optically active esters of lactic acid) of anilines containing an electron-accepting substituent at the amino group. Subsequent removal of the activating acceptor grouping was realized by nitrosation of the chiral secondary aniline followed by reduction of the corresponding N-nitroso compound.     

Shape analysis based critical Eotvos numbers for buoyancy induced partial detachment of oil drops from hydrophilic surfaces

Removal of oil drops from solid surfaces immersed in an aqueous medium is of interest in many applications. It has been shown that drop shape analysis can be used to predict conditions at which the stability limit of a lighter than water oil drop on a solid surface immersed in an aqueous bath is reached (Adv. Colloid Interface Sci. 98 (2002) 265). However the above analysis is restricted to cases where the contact angle made by the drop is below 90degrees and when the surface conditions result in a 'pinned' contact line. In this paper, it is shown that drop shape analysis can be used to predict the critical conditions at which drop stability limit is reached for drop contact angles of 90degrees and above, which is encountered with 'hydrophilic' surfaces. This critical condition can predict the occurrence of partial oil drop detachment, before complete removal due to 'roll-up', which occurs when the hydrophilic surface is adequately smooth which prevents 'pinning' of the contact line. The critical conditions at which partial drop detachment occurs can also be approximately predicted from simple force balances. It has been shown (Adv. Colloid Interface Sci. 98 (2002) 265) that for contact angles less than 90degrees, the critical limit based on shape analysis appears to resolve the differences that arise due to alternate expressions for capillary retention force. This paper shows that even for contact angles above 90degrees, the critical conditions predicted from the shape analysis resolves the differences in the predictions from the alternate force balances. Drop shape analysis used in this paper is based on the 'Arc-length' form of Young-Laplace or 'drop shape' equation, which is different from the 'Y vs X' form of the above equation that is used in Adv. Colloid Interface Sci. 98 (2002) 265. The above drop shape equation is solved by a fourth order Runge-Kutta technique and it is shown that for angles less than 90degrees, the two forms of the drop shape equation, predict almost identical values of the critical Eotvos number. This paper highlights the competing effects of interfacial tension lowering induced drop instability and 'roll-up', a term that is used to describe the retraction of the contact line of an oil drop on a surface, in being the primary c ause for drop detachment.     

Halogenated Ti3C2 MXenes Prepared by Microwave Molten Salt for Hg0 Photo-Oxidation

Ti₃C₂ MXenes with different halogen modifications are prepared rapidly and efficiently by microwave molten salt method, and the MXene surface functional group modification is successfully achieved to address the problems of low purity, complex functional groups, and uncontrollable energy band structure of MXenes obtained by traditional liquid phase etching. Among them, the modification of the iodine (I) functional group onto the surface of Ti₃C₂ changes the energy band structure and band gap, resulting in easier photoexcitation and more photogenerated carriers. The increased Fermi energy is closer to the conduction band, the decreased surface work function weakens the electron confinement ability. The photogenerated carriers can migrate to the surface of the material more easily with extended lifetime, so the activity of the catalyst is improved. Further, for gaseous monomeric mercury (Hg⁰) photo-oxidative removal, Ti₃C₂-I₂ exhibits 85.5% efficiency of Hg⁰ photo-oxidative removal under visible light. Based on the experimental characterization and density functional theory calculations, a mechanism for the photo-oxidative removal of Hg° from Ti₃C₂-I₂ MXene is proposed, which provides a valuable strategy for studying Ti₃C₂ MXenes in the field of photocatalysis.     

脱色阴离子交换剂的再生研究

提出一种新的离子交换剂再生理论，即吸附物的脱附依靠离子交换和络合的协同效应完成．以二价钙离子为再生剂，对糖液脱色用的阴离子交换树脂和阴离子交换纤维进行再生，并与传统的碱性钠盐相比较，研究证明钙离子为再生剂的工艺，具有低成本、无污染的特点．