多尺度特征融合U-Net的遥感影像黑臭水体智能检测

研究采用卫星遥感技术获取高分辨率遥感影像水体样本数据集,基于深度卷积神经网络从高分辨遥感影像中提取水体并进行黑臭水体智能监测,提出了一种改进U-Net的黑臭水体检测网络模型(IWDNet)。基于U-Net结构引入跳跃式多尺度特征融合,结合通道注意力机制、卷积注意力模块、通道与空间注意力机制生成不同多尺度特征融合注意力机制(MFFAM)模块进行对比,并引入空洞卷积扩大网络感受野,最终实现黑臭水体的识别检测。实验证明：基于跳跃式多尺度融合与CBAM注意力机制的黑臭水体检测网络(MFFCBAM-IWNet)模型有效提升了识别精度,在高分辨遥感影像水体样本数据集上表现最佳,总体精度达98.56%,Kappa系数达0.978 4。     

970 nm超辐射发光二极管弯曲脊形波导数值分析

本文基于光束传播法(beam propagation method, BPM)和时域有限差分法(finite difference time domain method, FDTD)建立了分析模型,模拟并分析了弯曲脊形波导超辐射发光二极管(superluminescent light emitting diode, SLD)不同结构参数(刻蚀深度、曲率半径、脊形宽度)对波导损耗的影响和倾斜脊形波导不同结构参数(刻蚀深度、脊形宽度、倾斜角度、发射波长)对模式反射率的影响。计算表明,弯曲脊形波导的刻蚀深度和曲率半径是影响波导损耗的重要因素。刻蚀深度较浅使波导对光场的限制作用较弱,过小的曲率半径会使模式传输泄露严重,损耗大大增加。脊形宽度越大,波导损耗越小,其对波导损耗影响较小。脊形波导的端面倾斜角度是抑制模式反射率的重要因素,脊形宽度增加,模式反射率逐渐减小,并在特定的几个角度形成的奇点达到最小值。刻蚀深度对于模式反射率的影响作用较小,但随着刻蚀深度的增加,奇点发生的角度产生了向小角度偏移。在特定的倾斜角度范围内,随着波长减小,奇点的数目会逐渐增加。研究结果可对设计具有优越性能的SLD器件...     

基于积分宽度法测量发光二极管结温方法的研究

本文提出了一种基于光谱积分宽度法来测量发光二极管(light emitting diode, LED)结温的新方法,并进行了理论分析和实验研究。本方法主要分为光谱数据采集、定标函数的测定和结温测量三个过程。首先,为了测量成本的降低和精度的提高而采用在正常工作电流下采集LED光谱数据,并通过采用不同温度下的光谱积分宽度与选定的某一基准状态下的值逐差可得到线性度达0.99以上的定标函数,并通过此定标函数可实时测定任意状态下的结温。其次,为了比较本方法测量结温的精确性,分别对单色和白光LED采用本方法和业界主流的正向电压法,通过自行设计的基于积分宽度法结温测量系统和美国Mentor Graphics公司的T3Ster型仪器的测量结果进行比较,两种方法测出的结温最大偏差为2.1℃,在可接受的误差范围内。实验结果表明积分宽度法测结温具有高效便捷且低成本的的特点,具有一定的应用前景。     

用于超外差接收机提供本振源的高功率510 GHz单片集成三倍频器

本文介绍了一种基于砷化镓材料的高功率490~530 GHz单片集成三倍频器。基于提出的对称平衡结构,该三倍频器不仅可以实现良好的振幅和相位平衡,用来实现高效的功率合成,还可以在没有任何旁路电容的情况下提供直流偏置路径以保证高效倍频效率。同时,开展容差性仿真分析二极管关键电气参数与结构参数对倍频性能的影响研究,以便最大化提升倍频性能。最终,在大约80~200 mW的输入功率驱动下,研制的510 GHz三倍频,在490~530 GHz频率范围内,输出功率为4~16 mW,其中峰值倍频效率11%。在522 GHz频点处,该三倍频在218 mW的输入功率驱动下,产生16 mW的最大输出功率。该三倍频器后期将用于1 THz的固态外超外差混频器的本振源。     

14N遥测核四极共振中的偏离共振效应

本文对遥测NQR谱中的偏离共振效应作了较详细地研究,发现¹⁴N谱线的强度随偏离共振效应而变化。当偏离共振强度与射频场强度接近时,测得的谱线强度最大。该效应可用来增强¹⁴N遥测NQR谱仪的灵敏度。上述实验现象在理论上采用脉冲的激发带宽方法作了解释和讨论。     

等离子体聚萘薄膜作发光层的蓝色发光二极管

等离子体聚萘薄膜作发光层的蓝色发光二极管马於光，唐建国，张海峰，沈家骢，刘式墉，刘晓东（吉林大学分子光谱与分子结构开放实验室，集成光电子学国家重点实验室，长春，１３００２３）（白求恩医科大学）关键词等离子体聚合物，蓝光，发光二极管Ｂｕｒｒｏｕｇｈｅｓ...     

Quantitative Comparison Between Vacuum-Ultraviolet Irradiation and Remote Hydrogen Plasma Treatment of Hydrocarbon Polymers

The photon flux of vacuum ultraviolet (VUV) and ultraviolet (UV) radiation of a hydrogen plasma with and without a MgF₂window was recorded by fluorescence measurements of sodium salicylate layers. After the compensation of the MgF₂absorption by increasing the input power into the plasma source, a comparison between afterglow hydrogen plasma and VUV treatments was made. Polyethylene (PE), polypropylene (PP), and polystyrene (PS) were treated either with VUV radiation or with remote hydrogen plasma and mass loss and CH absorption loss were measured by a quartz crystal microbalance and by infrared reflection absorption spectroscopy, respectively. In the case of PE the effects of both treatments were found to be very similar white for PP slight differences were observed. For the actual set of experimental conditions, the radiation component is largely responsible for the efficiency of the plasma treatment. VUV and remote hydrogen plasma treatments of PS showed only a negligible loss of mass and CH absorption.     

Low-temperature bath/coupled-capillary/sweeping-micellar electrokinetic capillary chromatography for the separation of naphthalene-2,3-dicarboxaldehyde-derivatized dopamine and norepinephrine

The use of a low-temperature (0 degrees C) bath-assisted coupled capillary for the separation of naphthalene-2,3-dicarboxaldehyde (NDA)-derivatized dopamine and norepinephrine using the sweeping-micellar electrokinetic capillary chromatography (MEKC) mode is described. In this technique, a capillary consisting of two portions with different inside diameters is used. Therefore, the field strength inside the capillary is different. Hence, the electrophoretic migration velocities of the analytes and the electro-osmotic flow (EOF) also are different. Furthermore, when a portion of the capillary (wide portion, used for sweeping) is immersed in a low-temperature bath, the viscosity of the buffer and the retention factor of the analytes inside are increased. Thus, not only are the interactions between the SDS micelles and the analytes increased, but the SDS-analytes also move more slowly. As a result, a more complete separation can be achieved, even when the sample injection volume is large, up to approximately 2 microL. In general, when the volume of an injected sample is larger, the effects of sweeping and separation would become insufficient, especially when the retention values (k) of the analytes are quite different. However, this limitation can be improved when the low-temperature bath/coupled capillary/sweeping-MEKC mode is used.     

Synthesis of anodic silicon oxide films in water-organic solutions containing orthophosphoric acid

Variations in electrophysical properties of anodic silicon oxide at the surface of semiconductor silicon are studied as a function of the composition of electrolytic solutions containing orthophosphoric acid and the conditions of reaching the final formation potential. The optimum conditions for the formation of anodic SiO₂ coatings that include phosphorus-containing admixtures are determined, the coatings being intended for application as diffusates in nanoelectronics.