宽带隙Cu(In,Al)Se2薄膜的制备及表征

以特殊脉冲电沉积方法制备CuInSe2(CIS)前驱体薄膜, 通过真空蒸镀法在CIS薄膜上沉积Al膜, 经硒化退火后在氧化铟锡(ITO)基底上制备了Cu(InAl)Se2(CIAS)薄膜. 采用扫描电子显微镜(SEM)、X射线能谱(EDS)、X射线衍射(XRD)、X射线光电子能谱(XPS)、紫外-可见吸收光谱(UV-Vis)对其形貌、结构、成分及光学吸收性质进行了表征. 结果表明, 制备的CIAS薄膜颗粒均匀, 表面平整致密, 呈黄铜矿结构. 薄膜在可见光区具有良好的吸收, 带隙约为1.65 eV.     

Carbon-Based Solid Acid as An Efficient and Reusable Catalyst for One-Pot Synthesis of Tetrasubstituted Imidazoles under Solvent-Free Conditions

Carbon‐based solid acid catalyst was found to be highly efficient, eco‐friendly and recyclable heterogeneous catalyst for the multicomponent reaction of benzil, aromatic aldehyde, primary amine and ammonium acetate, giving rise to 1,2,4,5‐tetrasubstituted imidazoles in good to excellent yields. The present methodology offers several advantages, such as high yields, short reaction time, mild reaction condition and a recyclable catalyst with a very easy work up.     

嵌入式碳纳米管石墨电极测定灯盏花素的研究

制备嵌入式多壁碳纳米管修饰石墨电极,利用循环伏安法(CV)研究灯盏花素在嵌入式多壁碳纳米管修饰石墨电极(ESCFE)上的电化学氧化行为,结果表明,灯盏花素在修饰电极上出现一对明显的准可逆氧化还原峰,峰电位分别为Epa=0.17 V和Epc=0.05 V(△E=0.12 V),峰电流分别为ipa=42.79μA,ipc=...     

线偏振周期量级脉冲中H-强场光解离的不对称性

Photodetachment of H^- irradiated by linearly polarized few-cycle laser field is investigated by time-dependent Schr?dinger equation numerically. The photo-electron left-right asym-metry parameter as a function of carrier-envelop (CE) phase of few-cycle pulses is attained. We confirm the asymmetry of photoelectron distribution in H^- photodetachment and find that the maximal asymmetry parameter of H^- is equal to that of H atom under the same conditions but the corresponding CE phases are quite different. Thus a CE phase shift ap-pears. Compared to that of H atom and field free electron, the zero asymmetry CE phase shift is sensitively affected by Coulomb field. The Coulomb effect on the asymmetry of H^- photodetachment mainly behaves in the CE phase shift of H^- instead of the amplitude of asymmetry parameter curve.     

茜素S复合铋膜电极电催化还原氯霉素

本研究采用电化学法制备茜素S复合铋膜修饰玻碳电极,利用循环伏安法、差示脉冲伏安法(DPV)研究氯霉素在茜素S复合铋膜电极上的电化学行为,并对其电化学测试条件进行优化.在pH 7.0的KH2PO4-Na2HPO4缓冲溶液中,氯霉素在-0.63 V处产生一灵敏的不可逆还原峰,显示出复合铋膜对氯霉素的还原有很好的催化作用.D...     

B和N原子掺杂超长(3,3)单壁碳纳米管的从头算研究

用从头算的周期边界条件方法,建立了(3,3)型超长单壁碳纳米管的新模型.使用B3LYP/3-21G方法计算了B和N掺杂纳米管的结构参数、掺杂能量、能带结构以及能隙.研究表明,B和N原子掺杂的(3,3)型单壁碳纳米管具有直接带隙半导体特征,其α轨道计算所得能隙值分别为1.797和2.041 eV.     

Determination of Imidacloprid in Tomato Grown in Greenhouse Based on Copper(II) Phthalocyanine Modified Carbon Ceramic Electrode by Differential Pulse Voltammetry

A new sol‐gel derived electrocatalytic carbon ceramic electrode was prepared by incorporating copper(II) phthalocyanine (CuPc) in a carbon ceramic network. This electrode was used as a sensitive electrochemical sensor for determination of the insecticide Imidacloprid (1‐(6‐chloro‐3‐pyridylmethyl)‐N‐nitro‐imidazolidin‐2‐ylideneamine) by differential pulse voltammetry (DPV). The resulting modified electrode exhibits a cathodic peak potential shifted positively and an increasing in cathodic peak current in comparison with unmodified electrode. The redox properties of this modified electrode at various pH values and CuPc percentage were investigated. The catalytic current obtained from differential pulse voltammetry is linearly dependent on Imidacloprid concentration over the two linear ranges of 0.67‐17 μM and 17‐93 μM with correlation coefficient of R² = 0.9999 and R² = 0.990, respectively. The detection limit for Imidacloprid was found to be 0.28 μM according to lower linear range. Possible interferences from several common pesticides were also evaluated. The inherent stability, high sensitivity, low detection limit and low cost for each preparation are advantages of this sensor. Determination of Imidacloprid in commercial formulation and residual Imidacloprid in tomato grown in greenhouse (protected cultivation) was also conducted. The results obtained from commercial formulation were completely consistent with those obtained through the standard high‐performance liquid chromatography (HPLC) method.     

正癸烷与二甲苯在超临界压力下的热裂解

采用连续流动装置对正癸烷和二甲苯在超临界压力下的热裂解对比研究. 用气相色谱和色质联用仪对其气相产物和液相产物进行分析, 计算气相产物产率和裂解转化率, 并运用计算化学方法获得正癸烷和二甲苯不同化学键的键能, 从实验和理论上分析其裂解反应的难易程度和裂解规律. 实验结果表明, 在4 MPa和650、700、750 ℃条件下, 正癸烷比二甲苯更容易裂解, 正癸烷裂解产物以C₁-C₃小分子的烃类和氢气为主, 而二甲苯裂解产物主要为乙苯、甲苯和其它芳香类化合物; 键能计算结果表明, 正癸烷碳链骨架的C－C键能和C－H键能均较小, 裂解反应的诱发步骤应该是C－C键断裂, 而二甲苯苯环上C－C和C－H键能均较大, 裂解诱发步骤应该是侧链甲基脱氢反应. 因此正癸烷裂解反应以C－C键断裂和脱氢反应为主, 二甲苯裂解主要发生侧链甲基C－C键断裂和脱氢反应, 而芳环则比较稳定, 理论计算键能分析与裂解实验结果一致.     

A selective electromembrane extraction of uranium (VI) prior to its fluorometric determination in water

A novel method for the selective electromembrane extraction (EME) of U⁶⁺ prior to fluorometric determination has been proposed. The effect of extraction conditions including supported liquid membrane (SLM) composition, extraction time and extraction voltage were investigated. An SLM composition of 1% di-2-ethyl hexyl phosphonic acid in nitrophenyl octyl ether (NPOE) showed good selectivity, recovery and enrichment factor. The best performance was achieved at an extraction potential of 80 volts and an extraction time of 14 minutes Under the optimized conditions, a linear range from 1 to 1000 ng mL⁻¹ and LOD of 0.1 ng mL⁻¹ were obtained for the determination of U⁶⁺. The EME method showed good performance in sample cleanup and the reduction of the interfering effects of Mn²⁺, Zn²⁺, Cd²⁺, Ni²⁺, Fe³⁺, Co²⁺, Cu²⁺, Cl⁻ and PO₄³⁻ ions during fluorometric determination of uranium in real water samples. The recoveries above 54% and enrichment factors above 64.7 were obtained by the proposed method for real sample analysis.     

Anodic stripping voltammetry of antimony at unmodified carbon electrodes

Antimony is an element of significant environmental concern, yet has been neglected relative to other heavy metals in electroanalysis. As such very little research has been reported on the electroanalytical determination of antimony at unmodified carbon electrodes. In this paper we report the electrochemical determination of Sb(III) in HCl solutions using unmodified carbon substrates, with focus on non-classical carbon materials namely edge plane pyrolytic graphite (EPPG), boron doped diamond (BDD) and screen-printed electrodes (SPE). Using differential pulse anodic stripping voltammetry, EPPG was found to give a considerably greater response towards antimony than other unmodified carbon electrodes, allowing highly linear ranges in nanomolar concentrations and a detection limit of 3.9?nM in 0.25?M HCl. Furthermore, the sensitivity of the response from EPPG was 100 times greater than for glassy carbon (GC). Unmodified GC gave a comparable response to previous results using the bare substrate, and BDD gave an improved, yet still very high limit of detection of 320?nM compared to previous analysis using an iridium oxide modified BDD electrode. SPEs gave a very poor response to antimony, even at high concentrations, observing no linearity from standard additions, as well as a major interference from the ink intrinsic to the working electrode carbon material. Owing to its superior performance relative to other carbon electrodes, the EPPG electrode was subjected to further analytical testing with antimony. The response of the electrode for a 40?nM concentration of Sb(III) was reproducible with a mean peak current of 1.07?µA and variation of 8.4% (n?=?8). The effect of metals copper, bismuth and arsenic were investigated at the electrode, as they are common interferences for stripping analysis of antimony.