光参量啁啾脉冲饱和放大的增益稳定性

 光参量啁啾脉冲放大（OPCPA）在饱和放大区存在一个增益稳定点，据此设计了一个输出稳定的三级OPCPA系统；第一、二、三级分别选用准相位匹配的周期极化钛氧磷酸钾（PPKTP）晶体、LBO晶体和KDP晶体作为增益介质。饱和放大时，增益随泵浦光强度变化时的增益输出稳定性明显改善，在泵浦光强度抖动低于6%的情况下，各级光参量放大器OPA输出的增益抖动小于1%。前级采用准相位匹配的PPKTP晶体作为增益介质，在远低于破坏阈值的30MW/cm²的泵浦功率密度下，可得到2×10⁵的饱和放大增益和20%的能量转换效率。     

介质靶表面的充电效应对等离子体浸没离子注入过程中鞘层特性的影响

针对等离子体浸没离子注入技术在绝缘体表面制备硅薄膜工艺，采用一维脉冲鞘层模型描述介质靶表面的充电效应对鞘层厚度、注入剂量及靶表面电位等物理量的影响.数值模拟结果表明：随着等离子体密度的增高，表面的充电效应将导致鞘层厚度变薄、表面电位下降以及注入剂量增加，而介质的厚度对鞘层特性的影响则相对较小. 关键词： 等离子体浸没离子注入 脉冲鞘层 绝缘介质 充电效应     

超短脉冲超强激光与固体靶相互作用中高能离子的产生

 用2D3V PIC粒子模拟方法得到了超短脉冲超强激光与固体靶相互作用中高能离子产生的图像，并对其机理进行了研究。在靶前后表面都观察到了高能离子的产生，并诊断了离子能谱。模拟结果表明，在靶前表面所产生的高能离子，角分布较大，在向靶内输运过程中会损失能量；在靶后表面产生的高能离子，定向性很好，能获得很高的能量。模拟得到的离子能量和实验观测结果在量级上相符。     

On a resolvent estimate of the Stokes equation with Neumann–Dirichlet‐type boundary condition on an infinite layer

This paper is concerned with the standard Lp estimate of solutions to the resolvent problem for the Stokes operator on an infinite layer with ‘Neumann–Dirichlet‐type’ boundary condition. Copyright © 2004 John Wiley & Sons, Ltd.     

高速色散补偿系统中喇曼放大器性能研究

利用喇曼放大器的非线性偏微分耦合方程组,对带喇曼放大器的色散补偿系统进行了仿真,并与传统的仿真方法进行了比较.结果表明:在色散完全补偿系统中,当传输速率较高时,忽略色散后的传统仿真方法的结果,与采用色散补偿技术后使整个系统色散为零的仿真结果有一定偏差,此时不能忽略色散的作用.还对前补偿系统和后补偿系统进行了研究,利用Q值性能判别法,分别得到了信号光脉冲的最佳占空比和最佳脉冲阶数.     

New developments in CdTe and CdZnTe detectors for X and γ-ray applications

There has been considerable recent progress in II-VI semiconductor material and in methods for improving performance of the associated radiation detectors. New high resistivity CdZnTe material, new contact technologies, new detector structures, new electronic correction methods have opened the field of nuclear and x-ray imaging for industrial and medical applications. The purpose of this paper is to review new developments in several of these fields. In addition, we will present some recent results at LETI concerning first the CdTe 2-D imaging system (20 × 30 mm² with 400 × 600 pixels) for dental radiology and second the CdZnTe fast pulse correction method applied to a 5 × 5 × 5 mm³ CdZnTe detector (energy resolution = 5% for detection efficiency of 85% at 122 keV) for medical imaging.     

采用模数转换技术提高脉冲激光测距的测时精度

针对脉冲激光测距中计数量化误差影响测时精度的问题,本文提出了采用模数转换技术提高测时精度的方法,并进行了可行性与精度分析,理论与实践结果均表明,该方法易于实现,能够容易地将计数量化误差减少若干个数量级。     

On Optimality Condition for Vector Optimization Based on Convex Set-Valued Mapping

1.IntroductionTheoptimalityconditionsofmathematicalprogrammingisaveryimportantsubjectbecausetLeyprovideausefulanalyticaltoolforstudingthedualitytheoryandnonlinearprogrammingalgoirthms.Inrecelltyears,someauthorshavebeguntostudytheoptimalityconditionsforvectoroptimizationproblemofset-valuedmapping,suchas[4][51.Inthispaperlwedefinetheconceptofcone--weaklyefficientsubdifferentialofset-valuedmappinginthecaseofgeneralpartiallyorderedlocallyconvextopologicalvectorspaces.Thecone-weaklysubdifferential…     

Quadratic Functionals with General Boundary Conditions

The purpose of this paper is to give the Reid ``Roundabout Theorem' for quadratic functionals with general boundary conditions. In particular, we describe the so-called coupled point and regularity condition introduced in [16] in terms of Riccati equation solutions. Accepted 27 February 1996     

Picosecond control of coherent magnetisation dynamics in permalloy thin films by picosecond magnetic field pulse shaping

We have measured the response of a 20×10 μm, 8 nm thin NiFe (80:20) permalloy film due to excitation by short in-plane magnetic field pulses. We will show that using a two-pulse-technique a complete control of the precessional motion of the magnetisation can be achieved on picosecond timescales. Furthermore, we will present numerical calculations which show that a complete suppression of magnetisation ringing after switching can only be realised by a cascade of short field pulses.