Kinetic modelling of cadmium removal from phosphoric acid by non-dispersive solvent extraction

In this work it is reported that the kinetic modelling of the separation of cadmium from phosphoric acid by non-dispersive solvent extraction. Using Cyanex 302 as selective extractant, the extraction step was carried out in a hollow fibre module containing polypropylene fibres, whereas the concentration step required a ceramic module with tubular channels due to the high acidity of the backextraction agent. Application of the methodology previously reported by the authors led to the development of a kinetic model with three design parameters, i.e., equilibrium constant of the extraction reaction (K'_e = 6 × 10³ mol⁻²/l⁻²), membrane mass transport coefficient of the extraction module K_me=8.33×10⁻⁸ m/s) and of the backextraction module (K_ms=3.33×10⁻⁸ m/s), that described satisfactorily the behaviour of the separation-concentration system. Thus, in this work a new application of the non-dispersive solvent extraction technology is presented, characterising at the same time the behaviour and parameters of a new type of contactor, i.e., a tubular ceramic module.     

1,9—双（1′—苯基—3′—甲基—5′—氧代吡唑—4′—基）壬二酮—（1,9）与三？…

研究了１，９－双（１′－苯基－３′－甲基－５′－氧代吡唑－４′－基）壬二酮－（１，９）（ＢＰＭＰＮＤ，Ｈ２Ａ）与三辛基氧膦（ＴＯＰＯ，Ｂ）的氯仿溶液，从硝酸介质中对Ｌａ（Ⅲ），Ｄｙ（Ⅲ）的协同萃取，计算了体系的酸性协萃系数ＲＡ和协萃系数Ｒ，用斜率法测得协萃合物的组成ＬａＡ．ＨＡ．Ｂ和ＤｙＡ．ＨＡ．Ｂ计算了协萃取平衡常数，研究了温度对协萃反应的影响，用萃取法制得了固态协萃合物，并对其组成，ＩＲ及ＴＧ     

Development of an automated sequential injection on-line solvent extraction-back extraction procedure as demonstrated for the determination of cadmium with detection by electrothermal atomic absorption spectrometry

An automated sequential injection (SI) on-line solvent extraction-back extraction separation/preconcentration procedure is described. Demonstrated for the assay of cadmium by electrothermal atomic absorption spectrometry (ETAAS), the analyte is initially complexed with ammonium pyrrolidinedithiocarbamate (APDC) in citrate buffer and the chelate is extracted into isobutyl methyl ketone (IBMK), which is separated from the aqueous phase by means of a newly designed dual-conical gravitational phase separator. A metered amount of the organic eluate is aspirated and stored in the PTFE holding coil (HC) of the SI-system. Afterwards, it is dispensed and mixed with an aqueous back extractant of dilute nitric acid containing Hg(II) ions as stripping agent, thereby facilitating a rapid metal-exchange reaction with the APDC ligand and transfer of the Cd into the aqueous phase. The aqueous phase is separated in a second dual-conical gravitational phase separator, and 30 μl of it is entrapped and metered in a sample loop (SL) and subsequently introduced via air segmentation into the graphite tube for analyte quantification. The ETAAS determination is performed in parallel with the separation/preconcentration process of the ensuing sample. An enrichment factor of 21.4, a detection limit of 2.7 ng l⁻¹, along with a sampling frequency of 13 h⁻¹ were obtained at a sample flow rate of 6.0 ml min⁻¹. The precision (R.S.D.) at the 0.4 μg l⁻¹ level was 1.8% as compared to 3.2% when quantifying the organic extractant directly. The applicability of the procedure is demonstrated for the determination of trace levels of cadmium in three certified reference materials.     

Solubility Measurements of Surfactants and Dissolution of Cytochrome c in 1,1,1,2‐Tetrafluoroethane Modified with Organic Solvents

The solubilities of four surfactants, sodium bis‐2‐ethylhexyl sulfosuccinate (AOT), cetyltrimethylammonium chloride, didodecyldimethylammonium bromide, and n‐dodecyltrimethylammonium chloride in liquid refrigerant 1,1,1,2‐tetrafluoroethane (R134a) modified with methanol, ethanol, and 2‐propanol were measured. The measurements were performed under 25 and 50 bar at 25 °C. The solubility of AOT was as high as 92 mM in R134a with addition of 2% ethanol. Cytochrome c molecules were then verified to be soluble in the AOT‐containing and ethanol‐modified R134a solution. Accordingly, liquid R134a is suggested as a potential extraction solvent for hydrophilic compounds.     

Determination of partition behavior of organic surrogates between paperboard packaging materials and air

The suitability of recycled paperboard packaging materials for direct food contact applications is a major area of investigation. Chemical contaminants (surrogates) partitioning between recycled paper packaging and foods may affect the safety and health of the consumer. The partition behavior of all possible organic compounds between cardboards and individual foodstuffs is difficult and too time consuming for being fully investigated. Therefore it may be more efficient to determine these partition coefficients indirectly through experimental determination of the partitioning behavior between cardboard samples and air. In this work, the behavior of organic pollutants present in a set of two paper and board samples intended to be in contact with foods was studied. Adsorption isotherms have been plotted and partition coefficients between paper and air have been calculated as a basis for the estimation of their migration potential into food. Values of partition coefficients (Kpaper/air) from 47 to 1207 were obtained at different temperatures. For the less volatile surrogates such as dibutyl phthalate and methyl stearate higher Kpaper/air values were obtained. The adsorption curves showed that the more volatile substances are partitioning mainly in air phase and increasing the temperature from 70 to 100 degrees C their concentrations in air (Cair) have almost doubled. The analysis of surrogates was performed with a method based on solvent extraction and gas chromatographic-flame ionization detection (GC-FID) quantification.     

Supercritical fluid extraction of oxadixyl from food crops

Summary This work describes the study of a degradation curve of Oxadixyl in field-treated potato and tomato samples. The residues were extracted using classical and supercritical fluid (SFE) extraction methods and analyzed by HRGC/ECD. The extraction techniques were compared and the results indicate the advantages of using SFE as an alternative method for pesticide analyses in these samples.     

N,N（二甲庚基）乙酰胺萃钯机理研究

本文研究了N,N二甲庚基乙酰胺(N_(s03))从氯化物体系中萃取钯的机理。应用等摩尔系列法和斜率法确定萃合物组成为:(CH_3CONR_2H)_2PdCl_4。通过紫外-可见光谱法研究,证实N_(503)萃取钯的机理属阴离子交换反应,其萃取方程式为: 2CH_3CONR_2HCl_((o)) PdCl_4~(2-)(a)?(CH_3CONR_2H)_2PdCl_4(o) 2Cl~-(a)     

Gas Hydrate Formation in Reversed Micelles

We describe a technique to modify protein solubility and optimize enzyme activity in reversed micellar solutions. The technique is based on the ability of hydrates of natural gas to form in the micro-aqueous phase. Clathrate hydrates are crystalline inclusions of water and gas, and their formation in bulk water has traditionally been studied with relevance to natural gas recovery. We have found that hydrates can form in the environment of the microaqueous pools of reversed micelles, and that their extent of formation can be well controlled through the thermodynamic variables of temperature and pressure. Additionally, formation of hydrates affects the size and aggregation number of the micelles, and thus influences the solubility and conformation of encapsulated proteins. We demonstrate how the concept can be used in two applications: (i) protein extraction into reversed micelles and subsequent recovery, and (ii) optimization of enzyme activity in reversed micelles.     

Determination of decabromodiphenyl ether in sediments using selective pressurized liquid extraction followed by GC–NCI-MS

A method based on selective pressurized liquid extraction (SPLE) followed by gas chromatography–negative ion chemical ionization-mass spectrometry (GC–NCI-MS) has been evaluated for analysis of decabromodiphenyl ether (PBDE-209) in sediment samples. Instrumental operating conditions such as source temperature and system pressure were optimized in the NCI-MS system, giving an instrumental detection limit of 2 pg. The limit of determination of the entire SPLE–GC–NCI-MS procedure was around 50 pg g^–1 dry weight (dw), with repeatability of replicates between 4 and 21% relative standard deviation. Application of the method to 13 different river and marine sediment samples collected in Spain revealed that levels of decabromodiphenyl ether ranged between 2 and 132 ng g^–1 dry weight.     

固相萃取光度法测定饮用水中挥发酚的研究

研究了用Waters Sep-Park-C18小柱固相萃取光度法测定饮用水中挥发酚的方法。水样中经水汽蒸馏分离后的挥发酚，用4－氨基安替比林显色，显色产物可用C18固相萃小柱萃取、乙醇洗脱后用分光光度法测定。方法污染小，操作简便，便于批量样品处理，用于饮用水中挥发酚的测定，结果令人满意。