Planar potentiometric sensors based on Au and Ag microelectrodes and conducting polymers for flow-cell analysis

Back-side contact Au and Ag microelectrodes were used as transducers to construct planar all-solid-state electrodes suitable for flow-through analysis. The microsensors were based on plasticized PVC potassium-selective membranes containing ion-electron conducting polymer—polypyrrole doped with di(2-ethylhexyl) sulfosuccinate. The proposed technique allowed simple construction of microsensors in one step, by membrane solution casting directly on the surface of the planar metallic transducers. The performance of the microsensors based on Au and Ag transducers were determined and compared with planar sensors based on internal electrolyte immobilized in polyHEMA. The addition of the polypyrrole to the membrane composition did not influence on the selectivity, reproducibility and long-term stability of the microsensors but improved their standard potential stability in time in comparison with coated-wire type sensors. Moreover, all-solid-state microsensors based on Au transducers exhibited better signal stability than Ag based sensors.     

Non‐Planar Lithium‐Phthalocyanine in the Double Salt (nBu4N)2[Lipc]PF6

We report the synthesis of the diamagnetic double salt bis(tetra(n‐butyl)ammonium) phthalocyanato(2‐)lithate hexafluorophosphate (nBu₄N)₂[Lipc]PF₆ [pc = phthalocyanine, nBu₄N⁺ = tetra(n‐butyl)ammonium] in dme (dme = dimethoxyethane). According to single‐crystal X‐ray diffraction structure analysis [P$\bar{1}$ , a = 8.642(2) Å, b = 12.820(3) Å, c = 15.019(3) Å, α = 83.01(3)°, β = 87.87(3)°, γ = 74.45(3)°, Z = 1, R₁ = 6.4 %], the phthalocyanine building bloc shows a substantial distortion of the macrocyclic ring from planarity. The deviation from D_4h symmetry originates from packing effects induced by the two tetra(n‐butyl)ammonium cations located above and below the macrocycle. DFT structure optimization starting from the experimental non‐planar configuration produces a fully planar complex anion [Lipc]^–.     

Electrochemical and XPS studies on corrosion behaviours of AISI 304 and AISI 316 stainless steels under plastic deformation in sulphuric acid solution

The corrosion behaviours of austenitic stainless steels were investigated by electrochemical methods under plastic deformation with constant strain in the naturally aerated 0.5 M H₂SO₄ + 0.2 M KCl solution at room temperature. The work addresses the influence of plastic deformation and molybdenum element on the corrosion resistance of austenitic stainless steels in the test solution. Electrochemical impedance spectroscopy presents the decreasing charge transfer resistance (R_t) and polarization resistance (R_p) values with the immersion time for AISI 304 stainless steel under constant strain deformation, and the increasing R_t and R_p values with the immersion time for AISI 316 stainless steel. The analysis of the chemical composition of the corrosion products was carried out by XPS. Molybdenum addition in AISI 316 stainless steel affects significantly the corrosion resistance because of its high ability to form Mo (VI) and MoCl₅ insoluble compounds in acid medium. Copyright © 2011 John Wiley & Sons, Ltd.     

Emanation thermal analysis study of a sol-gel precursor for silica-titania waveguides

Emanation Thermal Analysis (ETA) was demonstrated as a tool for the characterization of microstructure changes of a sol-gel precursor for silica-titania layers deposited on the glass plate to be used as planar waveguides. Temperature ranges of 280-330 and 380-500°C, respectively, in which the densification of the layers took place, were determined by ETA under in situ conditions of the sample heating. Results of thermogravimetry were compared with the ETA data. This revised version was published online in August 2006 with corrections to the Cover Date.     

Integrated circuit thermal analysis: A new thermal technique for polymer characterization

Polymer characterization has largely helped in the development of thermal analyzers and calorimeters, based mainly on the thermocouple technology, or more recently the semiconductor technology. With the use of an integrated silicon thermopile as a detector, a new thermal technique is appearing, to give more possibilities of investigations in the field of polymeric materials. Combining high sensitivity and use of small amount of sample, the originality of the new design comes from its low power consumption, giving rise to a portable version of the instrument. With such a concept, the thermal analysis technique is carried on the industrial site, to perform online measurements.Melting and crystallization, glass transition, control of reticulation are a promising field of applications for the characterization of polymeric materials on industrial sites.This revised version was published online in November 2005 with corrections to the Cover Date.     

碱性介质中 (氢) 氧化铜修饰电极电催化氧化蔗糖

 A stable copper (hydr)oxide-modified electrode was prepared in 0.5 mol/L NaOH solution by cyclic voltammetry in the range of -250 to 1 000 mV. It can be used for electrochemical studies in the range of -250 to 1 000 mV without interfering peaks because there is no oxidation of copper. During an anodic potential sweep, the electro-oxidation of saccharose on Cu occurred by the formation of Cu^III and this reaction also occurred in the early stages of the reversed cycle until it is stopped by the negative potentials. A mechanism based on the electro-chemical generation of Cu^III active sites and their subsequent consumption by saccharose was proposed, and the rate law and kinetic parameters were obtained. The charge transfer resistance from theoretical and impedance studies was used to verify the mechanism. Under chronoamperometry regimes, the reaction followed Cottrellian behavior. The transfer of up to 21 electrons was observed in further investigations of the electro-oxidation of saccharose on a (hydr)oxide Cu rotating disk electrode.     

Planar or quasi-planar octa- and ennea-coordinate aluminum and gallium in boron rings

An ab initio theoretical investigation has been performed on planar or quasi-planar octa-and ennea-coordinate Al and Ga centered in X@B8- and X@B9 (X=Al, Ga). These high symmetry molecular wheels all turned out to be true minima of the systems and σ+π double aromatic in nature, similar to the previously characterized D8h B@B8- both electronically and geometrically. Adiabatic and vertical detachment energies of the anions and the ionization potentials of the neutrals have been calculated to aid their eventua...     

Formaldehyde interaction with adsorbed oxygen on open-circuit platinum electrodes in aqueous sulfuric acid solutions

The open circuit potential transients and cathodic potentiodynamic pulses were measured upon formaldehyde (methylene glycol) interaction with pre-adsorbed oxygen (O_ads) on Pt/Pt and pc Pt electrodes in aqueous sulfuric acid solutions. The slowest interaction of CH₂(OH)₂ with O_ads was observed in the high coverage range of the electrode surface (θ_O ～ 0.2 0.8 to 1). The process rate in this range is determined by the direct reaction of O_ads with CH₂(OH)₂ molecules from the bulk solution. In the middle surface oxygen coverage range (θ_O 0.2 to 0.8), CH₂(OH)₂ interaction with O_ads takes place by the mechanism of “conjugated reactions”. The kinetic parameters of reactions for CH₂(OH)₂, HCOOH, and CH₃ OH were compared. The rate of CH₂(OH)₂-O_ads interaction on Pt electrodes in the high oxygen coverage range was found higher by an order of magnitude than that of HCOOH and by two orders of magnitude than in the case of CH₃OH.     

M@B<Subscript>9</Subscript> and M@B<Subscript>10</Subscript> molecular wheels containing planar nona- and deca-coordinate heavy group 11, 12, and 13 metals (M=Ag,Au, Cd,Hg, In,Tl)

A density functional and ab initio theory investigation on M@B₉ and M@B₁₀ molecular wheels containing planar nona- and deca-coordinate heavy group 11, 12 and 13 metals (M=Ag, Au, Cd, Hg, In, Ti) has been performed. These unusual clusters all prove to be true minima on the potential energy surfaces of the systems and σ+π double aromatic in nature. The first two vertical one-electron detachment energies of M@B₁₀⁻ (M=Ag, Au) anions and first two ionization potentials of M@B₉ (M=Ag, Au) and M@B₁₀ (M=Cd, Hg) neutrals were calculated to aid future experiments. The cluster complexes designed in this work may expend the domain of planar hyper-coordinate elements to include heavy group 11, 12, and 13 metals and serve as interesting candidates to be targeted in experiments. Electronic Supplementary Material  Supplementary material is available for this article at and is accessible for authorized users. Supported by the National Natural Science Foundation of China (Grant No. 20873117)     

New Types of Planar Chiral [2.2]Paracyclophanes and Construction of One‐Handed Double Helices

New types of planar chiral (R_p)‐ and (S_p)‐4,7,12,15‐tetrasubstituted [2.2]paracyclophanes were synthesized from racemic 4,12‐dihydroxy[2.2]paracyclophane as the starting compound. Regioselective dibromination and transformation afforded a series of planar chiral (R_p)‐ and (S_p)‐4,7,12,15‐tetrasubstituted [2.2]paracyclophanes, which can be used as chiral building blocks. In this study, left‐ and right‐handed double helical structures were constructed via chemoselective Sonogashira–Hagihara coupling. The double helical compounds were excellent circularly polarized luminescence (CPL) emitters with large molar extinction coefficients, good photoluminescence quantum efficiencies, and large CPL dissymmetry factors.