Au deposits on graphite: On the nature of high temperature desorption peaks in CO thermal desorption spectra

Due to the discovery of Au as a catalyst for low temperature CO oxidation, the adsorption of CO on Au surfaces has attracted a lot of attention recently. On stepped and rough single crystal surfaces as well as on deposited particles two characteristic desorption states above 100 K have been observed via TPD. We have studied Au deposits on graphite in order to elucidate the nature of these desorption peaks in more detail. For this purpose, Au was deposited at 100 K and 300 K on HOPG as a weakly interacting support. In analogy to other supports, we obtain two desorption states (∼140 K and ∼170 K) whose relative intensities depend strongly on the deposition temperature with the high temperature peak being much more pronounced for the 100 K deposits. After annealing to 600 K, both states drastically lose intensity. XP spectra, on the other hand, show virtually no decrease of the Au 4f intensity as would be expected for desorption or significant changes of the particle morphologies. We conclude that both desorption peaks are defect-related and connected with under-coordinated Au atoms that are lost for the most part upon annealing. These sites could be located at the perimeter of dendritic islands or on small, defect-rich particles in addition to larger particles not adsorbing CO at 100 K. Preliminary STM results are in favour of the second interpretation.     

40Ar+诱导无定形碳到金刚石纳米晶相变的研究

通过60 keV的⁴⁰Ar⁺辐照无定形碳靶合成了大量尺寸不同的金刚石纳米颗粒.高分辨透射电子显微镜配合能量色散X射线谱和电子衍射以及Raman谱分析的结果表明，这些嵌于具有扰动石墨结构薄膜中的纳米金刚石颗粒，其成核率很高(约为10¹³/cm²)，而且可以生长到较大的尺寸，有的甚至可以达到微米量级.对其相转变过程也进行了初步探讨. 关键词： 离子束 金刚石纳米晶 相变 透射电子显微镜     

Study of nitrogen ion implantation and diffusion phenomena on thin chromium layers followed by the atomic force microscopy and secondary ion mass spectroscopy techniques characterization

This research investigates the effect of ion implantation dosage level and further thermal treatment on the physical characteristics of chromium coatings on Si(1 1 1) substrates. Chromium films had been exposed to nitrogen ion fluencies of 1 × 10¹⁷, 3 × 10¹⁷, 6 × 10¹⁷ and 10 × 10¹⁷ N⁺ cm⁻² with a 15 keV energy level. Obtained samples had been heat treated at 450 °C at a pressure of 2 × 10⁻² Torr in an argon atmosphere for 30 h. Atomic force microscopy (AFM) images showed significant increase in surface roughness as a result of nitrogen ion fluence increase. Secondary ion mass spectroscopy (SIMS) studies revealed a clear increased accumulation of Cr₂N phase near the surface as a result of higher N⁺ fluence. XRD patterns showed preferred growth of [0 0 2] and [1 1 1] planes of Cr₂N phase as a result of higher ion implantation fluence. These results had been explained based on the nucleation-growth of Cr₂N phase and nitrogen atoms diffusion history during the thermal treatment process.     

The structure of monolayer SiO2 on Mo(1 1 2): A 2-D [Si-O-Si] network or isolated [SiO4] units?

In this letter, atomically resolved scanning tunneling microscopic (STM) images obtained from monolayer SiO₂/Mo(1 1 2) are presented. The results are consistent with a previously proposed structural model of isolated [SiO₄] units based on vibrational features observed by high-resolution electron energy loss spectroscopy (HREELS) and infrared reflection-absorption spectroscopy (IRAS), and oxygen species identified by ultra-violet photoemission spectroscopy (UPS). These results are inconsistent with a structural model that assumes a two-dimensional (2-D) [Si-O-Si] network. These data illustrate that a metal substrate, although coated with an oxide thin layer, can be directly imaged at the atomic-scale with STM.     

The effect of ITO films thickness on the properties of flexible organic light emitting diode

Indium tin oxide (ITO) thin films were deposited on cyclic olefin copolymer substrate at room temperature by an inverse target sputtering system. The crystal structure and the surface morphology of the deposited ITO films were examined by X-ray diffraction and atomic force microscopy, separately. The electrical properties of the conductive films were explored by four-point probing. Visible spectrometer was used to measure the optical properties of ITO-coated films. The performance of the flexible organic light emitting diode device with different thickness anode was investigated in this study.     

The chemisorption of pentacene on Si(0 0 1)-2 × 1

Adsorption structures of the pentacene (C₂₂H₁₄) molecule on the clean Si(0 0 1)-2 × 1 surface were investigated by scanning tunneling microscopy (STM) in conjunction with density functional theory calculations and STM image simulations. The pentacene molecules were found to adsorb on four major sites and four minor sites. The adsorption structures of the pentacene molecules at the four major sites were determined by comparison between the experimental and the simulated STM images. Three out of the four theoretically identified adsorption structures are different from the previously proposed adsorption structures. They involve six to eight Si-C covalent chemical bonds. The adsorption energies of the major four structures are calculated to be in the range 67-128 kcal/mol. It was also found that the pentacene molecule hardly hopped on the surface when applying pulse bias voltages on the molecule, but was mostly decomposed.     

二维磁结构的扫描隧道显微术研究

文章介绍了近年来利用扫描隧道显微术（STM）对表面和薄膜磁结构的研究进展。二维或表面磁结构可以通过在非磁性单晶上外延磁性单原子层薄膜形成，也可以在清洁的磁性单晶表面形成。利用磁性的STM针尖可以观测到原子分辨的表面磁结构。这将增进人们从纳米尺度对磁性的理解，并推动磁电子学的发展。     

Epitaxy: the motion picture

The engineering of many modern electronic devices demands control over a crystal down to the thickness of a single layer of atoms—and future demands will be even more challenging. Such control is achieved by the method of crystal growth known as epitaxy, and that makes this method the subject of intense study. More than that, recent advances are revolutionizing our knowledge of how surfaces grow. In fact, growing surfaces show a beautifully rich variety of phenomena, many of which are only now beginning to be uncovered. In the past few years many surface imaging techniques have been used to give us a close look at how crystals grow—while they are growing. The purpose of this article will be to illustrate some of the ways real surfaces grow and change as revealed by some of the latest in situ microscopic imaging technologies.

It is often said that crystal growth is more of an art than a science. Here we will show that it is emphatically both.     

Calculated elastic constants of dilute alloys based on bcc metals

The elastic constants of dilute alloys based on bcc metals have been calculated using the Green’s function method obtaining explicit expressions for change in elastic constants in terms oft-matrix. The crystal impurity problem is discussed within an impurity model containing central and non-central force constant changes extended up to second neighbours of the impurity. The effect of volume change on elastic constants and a contribution from electron pressure term are considered. Numerical results for changes in three elastic moduli have been presented for a number of dilute alloys based on Mo, Nb, W, Ta and V.     

Effect of the three-body force on triton asymptotic normalization constants by the hyperspherical harmonics expansion method

We investigate the change in the calculated value of asymptotic normalization constant (ANC) by the hyperspherical harmonics expansion method with the inclusion of three nucleon force (3BF) in addition to two nucleon force. We see that ANC does not change very much with the inclusion of 3BF indicating that the 3BF does not alter the asymptotic behaviours of HHE wavefunction significantly.