Cu(OTf)2-catalyzed Et3SiH-reductive etherification of various carbonyl compounds with trimethylsilyl ethers

A triethylsilane-reductive etherification of the trimethylsilyl ethers with a variety of carbonyl compounds in good yields at room temperature employing 0.5 mol% Cu(OTf)₂ as an extremely efficient catalyst is described here.     

Photocatalytic Oxidation of Aniline in the Gas Phase Using Porous TiO2 Thin Films

The gas-phase photocatalytic oxidation of aniline on a new kind of porous nano-TiO₂ composite films is investigated. The composite film was prepared on glass fiber with the water glass as binders and dilute H₂SO₄ solution as solidifying reagent. The surface characters were observed by scanning electron microscope. The photocatalytic degradation of aniline on the composite films was carried out in a TiO₂/UV system. Some important factors affecting the photodegradation, such as the concentration of TiO₂, the initial concentration of aniline, and the existing water vapor, are also studied. The product of photocatalytic oxidation was detected by Fourier transform-Infrared. The partial intermediate products were absorbed on TiO₂ surface, which resulted in catalyst deactivation. But when it was irradiated under UV illumination or solar irradiation for some time, the catalyst could be reused without loss of catalytic activity. Translated from the Journal of Wuhan University (Natural Science Edition), 2005, 51(2) (in Chinese)     

Synthesis and properties of novel dialkylaminocarbenium salts

Novel dialkylaminocarbenium salts with metallocomplex counter ions were prepared by the reaction of phosgene with either DMF or tetramethylurea in the presence of metal chlorides. Reactions of organosilicon amides with phosgene gave corresponding carbenium salts, while organosilicon ureas yielded aminoiminocarbenium salts. Dialkylaminochlorocarbenium salts were reduced with hydrosilanes to give dialkylaminocarbenium, salts and can be easily hydrolyzed to afford either amides or ureas. Pathways of the reaction with water and alcohols depend on the nature of reagent and the reaction conditions. Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 5, pp. 1035–1040, May 1997.     

Au/CeO2/Y和Au-MFe2O4催化剂用于有氧条件下CH4还原NOx的研究

以CeO2／Y分子筛和MFe2O4(M=Ni,Co，Zn)为载体，制备Au／CeO2／Y和Au-MFe2O4负载型金催化剂．用CH4做还原剂，考察了它们在有氧条件下催化还原NOχ的活性．结果表明：在Au-Y中引人助剂Ce，使得Au／CeO2／Y的催化活性高于Au／Y；Au-CoFe2O4的催化活性高于Au-Fe2O3，反应温度为300℃时，NOχ在Au-CoFe2O4上的转化率达到39．70%．     

Pt/Al2O3蜂窝状催化剂上NO选择性催化还原反应动力学研究

采用多次涂层和浸渍法制备了蜂窝状Pt/Al2O3催化剂，并在高空速和大气体流量条件下对无梯度循环式反应器和积分反应器上催化剂的活性进行了比较。同时采用循环式反应器对动力学数据进行了测定。根据Langmuir-Hinshelwood模型和实验结果，推测了NO-C3H6-O2体系的SCR反应机理，并导出了NO和C3H6反应速率的数学表达式。据此所计算的理论模拟值能够与实验值很好地吻合。实验结果表明，氧气浓度对NO和C3H6的反应速率有明显的影响，二者均随着氧浓度c (O2)的增加达到峰值，再增加氧气浓度时，C3H6的反应速率r(C3H6)保持不变，而NO反应速率r (NO)却下降，而且下降的程度随着温度的升高而加剧。同时，随着氧气浓度增加，r (NO)达到最大值时的温度亦随之下降。     

Effect of the Secondary Reduction on the Enantioselectivity and Function of Additives in the Chiral Oxazaborolidine‐Catalyzed Asymmetric Borane Reduction of Ketones

The secondary reduction in the direct and oxazaborolidine‐catalyzed asymmetric borane reduction of ketones was investigated by the use of GC/MS tracing titration and control experiments. The results indicate that the secondary reduction affects the enantioselectivity only in noncoordinated solvents at low temperature and not under the usual catalytic reduction conditions because the intermediate alkoxyborane is unstable and quickly converts to borane and dialkoxyborane. The function of an alcohol additive in the asymmetric borane reduction of ketones is to consume excess borane in the reduction system thus inhibiting noncatalytic reduction, which leads to increased enantioselectivity in the catalytic reduction.     

Radical anions of nitrobenzothiazoles: EPR study of conjugative properties of benzothiazolyl systems

The electrochemical reduction in DMSO of the five isomers of nitrobenzothiazole (NBTZ) gave quite persistent radical anions that could be easily characterised by EPR spectroscopy. By contrast, the chemical reduction in alkaline solution, that is by t-BuOK in DMSO or by glucose and MeOK in MeOH, presented some problems with 6- and 4-NBTZ, and in the case of 2-NBTZ did not provide any detectable paramagnetic species. The internal consistency of coupling constants of the nitrobenzothiazole radical anions is in good agreement with the conjugative properties of the various benzothiazolyl systems and allows rectifying a recent EPR characterisation of 6-NBTZ radical anion.     

CuO／活性炭和Fe2O3／活性炭催化还原NO

ＣｕＯ／活性炭和Ｆｅ_２Ｏ_３／活性炭催化还原ＮＯ高志明，赵震，杨向光，吴越（中国科学院长春应用化学研究所长春１３００２２）关键词活性炭，还原，ＮＯ，氧化铜，氧化铁目前，对固定源的ＮＯ处理是采用Ｖ２Ｏ５／ＴｉＯ２作催化剂，ＮＨ３作还原剂的选择催化还原方...     

纳米TiO2膜用于光催化氧化测定化学需氧量的研究

A photocatalytic oxidation method for determination of chemical oxygen demand （COD） using nano-TiO2 film, based on the use of a nano-TiO2-Ce（SO4）2 system and electrochemical detection, was proposed. The technique was originated from the direct determination of the Ce（Ⅲ） concentration change resulting from photocatalytic oxidation of organic compounds. Ce（Ⅲ）, which was produced by photocatalytic reduction of Ce（SO4）2, could be measured at a multi-walled carbon nanotubes （MWNT） chemically modified electrode （CME）. The COD values by this method were calculated from the differential pulse voltammetry （DPV） current of Ce（Ⅲ） at the CME. Under the optimal operation conditions, the detection limit of 0.5 mg·L^-1 COD with the linear range of 1-600 mg·L^-1 was achieved. This method was also applied to determination of various COD of ground water and wastewater samples. The resuits were in good agreement with those from the conventional COD methods, i.e., permanganate and dichromate ones.     

Synthesis of Inorganic Compounds (Metal, Oxide and Hydroxide) in Polyol Medium: A Versatile Route Related to the Sol-Gel Process

A new route for the preparation of powdery metal, oxide and hydroxide materials is presented as a chimie douce alternative to the sol-gel method. It consists in the reduction or the hydrolysis of a metal salt dissolved and heated in a polyol medium. It appears through zinc and cobalt examples that the use of acetate precursors contrarily to chloride or sulfate ones leads to the precipitation of a solid (metal, oxide, hydroxide) whose nature depends on two main factors: the hydrolysis ratio, defined by the water to metal molar ratio, and the reaction temperature. As in the sol-gel method, acetate leads to the formation of intermediate alkoxyacetate complex. The absence of water favors metal formation while its presence favors oxide or hydroxyacetate formation.