弛豫理论对离子交换毛细管电色谱中峰压缩现象的研究

 在毛细管电色谱中,由于溶质在输运过程中所具有的电性质,常会产生一些特殊的现象。这些现象,如离子交换毛细管电色谱中产生超高柱效峰的现象,已经不能用一般的色谱理论加以解释。基于弛豫理论所建立的基本模型,在考虑溶质在两相中皆有可能发生正、反向迁移的情况下,得到了流出曲线一阶原点矩和二阶中心矩的理论表达式,并通过对溶质在两相中电扩散速率与电泳速率、电渗流速率关系的分析结果证实:溶质在固定相表面的电扩散行为可以使其保留变弱,出峰加快;而这种电扩散导致的超常柱效峰的出现具有不稳定性,只有在多方面因素综合影响匹配的情况下才可能出现。     

塔板理论对柱内和柱外浓度分布曲线的描述

使用Visual Basic和QBasic程序，分别在Excel和DOS上，在不做任何化简的情况下，对塔板理论描述的柱内和柱外组分浓度分布进行了研究。发现符合线性分配的样品组分在色谱柱内存在3种不同的浓度分布形态，在色谱柱外则都是拖尾峰形态。分析了不同分配比对柱内和柱外浓度分布曲线最高点和次高点的影响。     

紫外吸收温差光谱法及其应用

用温差光谱法观察系列化合物的紫外吸收温差谱，发现温差谱具有很强的特征性，具有π键的富勒烯Ｃ６０的温差谱峰为负值，负峰的强度样品温差增大而负荷增大，负峰的峰位无明显移。     

Hepatobiliary excretion and brain distribution of caffeine in rats using microdialysis

To investigate the pharmacokinetic mechanism of hepatobiliary excretion and brain distribution of caffeine, this study uses a method based on microdialysis technique and liquid chromatography that allows continuous and concurrent in vivo monitoring of extracellular caffeine in the blood, brain and bile of anesthetized rats following the administration of caffeine (3 or 10 mg/kg, i.v.) through the femoral vein. Dialysates of the blood, brain and bile were directly injected onto the liquid chromatographic system and no further clean-up procedures were required. The study design consisted of two groups of six rats in parallel: the rats of the control group received caffeine (3 or 10 mg/kg, i.v.) alone and those of the cyclosporine treated-group were injected cyclosporine (10 mg/kg, i.v.) 10 min prior to caffeine administration (3 or 10 mg/kg, i.v.). The decline of caffeine in the blood, brain striatum and bile suggested that caffeine had rapid exchange and equilibration between the peripheral compartment and the central nervous system. In addition, the results indicated that caffeine underwent hepatobiliary excretion and was distributed into brain. When cyclosporine was co-administered, the pharmacokinetic parameters were not significantly altered. The results of this study reveal that the pharmacokinetic mechanism of hepatobiliary excretion and brain distribution of caffeine might not relate to P-glycoprotein.     

The microstructure and optical transmittance thermal analysis of sodium borosilicate bio-glasses

The conditions to fabricate the bulk porous specimens have been studied on account of sodium borosilicate (NBS) glasses. Glass composition, heat treatment at phase separation and TiO₂ addition have been considered in this study. Original glass samples of composition in mol%: sample A: 9.19 Na₂O - 23.58 B₂O₃ - 67.23 SiO₂, sample B: 9.29 Na₂O - 3.17 TiO₂ - 23.82 B₂O₃ - 63.72 SiO₂ were prepared by melting reagent grade chemicals (Na₂CO₃, HBO₃, SiO₂ and AgNO₃) in platinum crucibles at 1480°C for 1 h in air. The melts were poured onto stainless steel plates and were annealed at 500°C for 0.5 h after cooling. Thus, obtained samples were phase separated at 700°C for 2, 15, 25 and 50 h to study their microstructure by scanning electron microscope (SEM). Besides the direct study of the microstructure by SEM, information on glass structural changes of samples are provided by measuring in situ changes by the optical transmittance thermal analysis. The isothermal measurements were carried out at 700, 720 and 740°C. The temperature of phase separation, the leaching and nucleator addition (TiO₂), significantly influence the microstructure of the resulting leached product. TiO₂ additive seems to suppress crystallization of cristobalite: especially at the extended above heat treatment phase separation runs. The phase-separated domains of glasses containing above 80 moles of SiO₂ are so small that it is very hard to observe them by SEM. The glass composition in our case was selected in a way to have relatively large phase separated areas easily observed by SEM at magnification 20 000·. The influence of TiO₂ is not too pronounced. It seems to suppress the cristobalite crystallization, especially of longer heating runs. The image analysis of leached glasses shows the prevailing content of the skeletal phase in a comparison to pores. The TiO₂ content diminishes the content of the skeletal phase. This revised version was published online in July 2006 with corrections to the Cover Date.     

凝胶渗透色谱法测定聚丙烯腈共聚物分子量中宽分布校正法的应用

应用宽分布校正法对凝胶渗透色谱(GPC)进行了校正，将校正曲线用于聚丙烯腈(PAN)共聚物分子量的计算。对扣除色谱峰扩展效应前后的测试结果与乌氏粘度法测得的数据进行比较。结果表明，应用宽分布校正法时，必须扣除色谱峰扩展效应，才能得到较为准确的测试结果。     

Infrared spectroscopic study of the interactions of nylon‐6 with water

We studied the interactions of nylon‐6 with water by following the Fourier transform infrared spectra of a hydrated thin film during dehydration. Very small changes in the spectra caused by the interactions were clearly revealed by the application of spectral subtraction. The water was found to interact with amide groups to form hydrogen bonds with non‐hydrogen‐bonded or free C?O and NH groups in the amorphous portion in the first hydration sphere. This was deduced from an analysis of minus and plus peaks appearing around the absorptions of the NH stretching, amide I band, and amide II bands in the difference spectra between the spectra during dehydration and the one at the most dehydration. The interactions of the amide groups with water were significantly stronger than the hydrogen bond between CO and NH in the crystalline portion, according to the magnitude of the frequency shift of relevant bands. Water, as the interacting counterpart, showed a distorted OH stretching absorption with two close peaks at about 3450 cm^?1. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 1722–1729, 2003     

Morphology,surface roughness,electron inelastic and quasielastic scattering in elastic peak electron spectroscopy of polymers

In elastic peak electron spectroscopy (EPES), the nearest vicinity of elastic peak in the low kinetic energy region reflects electron inelastic and quasielastic processes. Incident electrons produce surface excitations, inducing surface plasmons, with the corresponding loss peaks separated by 1–20 eV energy from the elastic peak. In this work, X‐ray photoelectron spectroscopy (XPS) and helium pycnometry are applied for determining surface atomic composition and bulk density, whereas atomic force microscopy (AFM) is applied for determining surface morphology and roughness. The component due to electron recoil on hydrogen atoms can be observed in EPES spectra for selected primary electron energies. Simulations of EPES predict a larger contribution of the hydrogen component than observed experimentally, where hydrogen deficiency is observed. Elastic peak intensity is influenced more strongly by surface morphology (roughness and porosity) than by surface excitations and quasielastic scattering of electrons by hydrogen atoms. Copyright © 2007 John Wiley & Sons, Ltd.     

高频介质系统介电性能与相组成的定量关系分析

采用普通电子陶瓷工艺制备两种高频介质系统ZnO-B2O3-SiO2三元系和BaO-PbO-Nd2O3-Bi2O3-TiO2五元系,通过XRD分析确定各系统的主晶相, 运用衍射峰强度计算法准确测定出各组分的体积百分含量,并代入Lichnetecker对数混合定则,计算出系统的介电性能,获得了分析介质系统介电性能与物相含量之间定量关系的新方法.     

基于数据流图划分的低峰值功耗扫描测试

扫描测试作为数字集成电路设计中最常用的可测性设计方法,能显著提高电路的可测性,但同时也会引起测试功耗问题.本文采用划分待测电路数据流图的方法降低测试峰值功耗.实验表明,在稍微降低故障覆盖率的条件下,本文提出的测试方法能显著降低测试的峰值功耗,同时也能降低平均功耗和能耗.