Microwave Irradiation for Accelerating Synthesis of 5,6-Diphenylimidazo[1,2-a]pyrimidines Based on Isoflavones

Microwave irradiation was used to accelerate the cyclocondensation of isoflavones with 2-aminoimidazole to synthesize 5,6-diphenylimidazo[1,2-a]pyrimidines. A series of 17 new compounds were characterized by Fourier transform infrared, NMR, and elemental analysis. 5-(2-Hydroxyl-4-isopropoxyphenyl)-6-phenylimidazo-[1,2-a]pyrimidine was determined by x-ray diffraction. A variety of substrates can participate in the process with good yields and purities, making this methodology suitable for library synthesis in drug discovery.      

Facile Synthesis of 5‐Benzylidene Rhodamine Derivatives under Microwave Irradiation

A series of 5‐benzylidenerhodamine derivatives were synthesized by the cross‐aldol condensation of an aromatic aldehyde with rhodamine or rhodamine acetic acid in sodium acetate/acetic acid under microwave irradiation. The reaction was completed in 8–20 min with 63–94% yields and was environmentally benign with easy workup.     

Rapid Conventional and Microwave-Assisted Decarboxylation of L-Histidine and Other Amino Acids via Organocatalysis with R-Carvone Under Superheated Conditions

This article reports a new methodology taking advantage of superheated chemistry via either microwave or conventional heating for the facile decarboxylation of alpha amino acids using the recoverable organocatalyst, R-carvone. The decarboxylation of amino acids is an important synthetic route to biologically active amines, and traditional methods of amino acid decarboxylation are time consuming (taking up to several days in the case of L-histidine), are narrow in scope, and make use of toxic catalysts. Decarboxylations of amino acids including L-histidine occur in just minutes while replacing toxic catalysts with green catalyst, spearmint oil. Yields are comparable to or exceed previous methods and purification of product ammonium chloride salts is aided by an isomerization reaction of residual catalyst to phenolic carvacrol. The method has been shown to be effective for the decarboxylations of a range of natural, synthetic, and protected amino acids.     

Microwave-Assisted Chemical Demulsification of Water-in-Crude-Oil Emulsions

Two case studies are presented that shows the effects of chemical demulsifiers used under conventional heating and in combination with microwave radiation on efficiency of demulsification and light transmittance of the water separated from the emulsions. The data shows that the chemical demulsifiers coupling with microwave radiation does a better job at demulsifying the water-in-crude-oil emulsions than when the chemical demulsifiers are used under conventional heating. The demulsification efficiency of AE-121 could reach 100% under microwave irradiation (300 W) for 50 seconds.     

Thermal Stabilities of Attapulgite/Polystyrene (ATP/PS) Nanocomposites via Microwave‐Assisted Bulk Polymerization

Attapulgite/polystyrene (ATP/PS) nanocomposites with different contents of attapulgite nano‐needles organo‐modified, and cetyltrimethylammonium bromide (CTAB) were successfully prepared by the in situ bulk radical polymerization of styrene, under microwave irradiation. The transmission electron microscopy (TEM) results showed good dispersibility of the organo‐modified attapulgite nano‐needles in the polystyrene matrices. The thermogravimetric analysis (TGA) revealed that the thermal stability of the nanocomposite was enhanced with the increase of additional attapulgite nano‐needles.     

Microwave‐Assisted Synthesis and Characterization of CuO Nanocrystals

CuO feather‐like and flower‐like crystals have been synthesized by a fast microwave‐assisted solution approach using Cu(NO₃)₂ and NaOH. The morphology transformation of CuO could be achieved by ionic liquid 1‐n‐butyl‐3‐methyl imidazolium tetrafluoroborate ([BMIM]BF₄). With [BMIM]BF₄, flower‐like CuO were obtained, whereas without [BMIM]BF₄, feather‐like CuO were obtained. The possible formation mechanism of flower‐like CuO was discussed on the basis of experimental results. The products were characterized by XRD, FESEM/EDS, and TEM/SAED. In addition, the adsorption of [BMIM]BF₄ on flower‐like CuO was confirmed by FTIR and TG/DSC, and the band gap energies of the flower‐like CuO was estimated by UV‐vis spectra.     

Explanation of Theoretical Mechanism of Isomerization of L-Alanine Conformation for Experimental Results

B3LYP/6-31＋＋G＊＊ method was applied to investigate the mechanism of alanine isomerization.12 minima and 22 transition states were obtained after optimization and several paths of isomerization were found.It is found that intramolecular single-bond rotation and proton transfer might lead to isomerization.The energy barrier of C–N bond rotation was lower than 2.52 kcal·mol 1,while the energy barrier ranges of the rotation of C–C and C–O were separately 0.43~ 7.01 and 4.69~12.19 kcal·mol 1,and the minimum energy barrier of proton transfer was 30.76 kcal·mol 1.The most probable isomerization path and mechanism for the two most stable conformations was discussed to find that the highest energy barrier to be crossed in this path was 11.87 kcal·mol 1.In order to understand the microscopic nature why only 4 conformations were detected in the experiment,thermodynamic properties of all conformations at the experimental temperature of 391 K was calculated.It is found that conformations XII,XI,X and IX can only unidirectionally convert into conformations rapidly with low energy and vanish immediately.The other conformations were distributed according to Maxwell-Boltzman＇s law,and the distribution probabilities of conformations I,II,III,IV,V,VI,VII and VIII were respectively 27.2%,26.5%,25.8%,6.4%,5.2%,4.8%,2.5% and 1.6%.Conformations I,II and III with bigger probability and stronger absorption peak were easy to detect in the experiment.Conformation IV had a relatively smaller probability（6.4%） and weak absorption peak which,however,could also be identified.The other conformations had too small probability to identify in the spectrum.     

Application of a new focused microwave technology with species-specific isotope dilution analysis for the quantitative extraction of organometallic contaminants in solid environmental matrices

A new self-tuning single-mode-focused microwave technology has been evaluated in this work to perform the quantitative routine extraction of organometallic species from solid matrices of environmental interest. Species-specific isotope dilution analysis has been employed to better investigate the real influence of the microwave-assisted extractions on the final results. The advantages of such methodology in comparison with other established microwave units for the routine speciation analysis of organomercury and organotin compounds are discussed (such as the capability of using disposable glass vials, a self-tuning mode to provide an accurate control of the temperature and pressure inside of the vials, and the possibility of performing automated sequence of extractions with low sample size). The results obtained in this work demonstrated that such technology provides a fast and reliable quantitative extraction of the organometallic species in a wide range of extraction conditions even when the multi-elemental (Sn and Hg) species-specific determination is carried out.     

Design and Synthesis of a γ1β8‐Cyclodextrin Oligomer: A New Platform with Potential Application as a Dendrimeric Multicarrier

We report the synthesis and characterization of a water‐soluble, star‐shaped macromolecular platform consisting of eight β‐cyclodextrin (β‐CD) units anchored to the narrower rim of a γ‐CD core through bis(triazolyl)alkyl spacers. The efficient synthetic protocol is based on the microwave (MW)‐promoted Cu‐catalyzed 1,3‐dipolar cycloaddition of CD monoazides to CD monoacetylenes. The ligand‐hosting capability of the construct has been assessed by relaxometric titration and nuclear magnetic relaxation dispersion (NMRD) profiling, which showed it to be good, and this was supported by molecular dynamics simulations. To demonstrate the feasibility of obtaining supramolecular structures with high hosting ability, we designed a dimeric platform, formed by joining two nonamers through the γ‐CD cores through a bis(lithocholic acid) linker. With a view to the potential biological applications, cytotoxicity and extent of binding to human serum albumin were assessed. The properties of this dendrimeric multicarrier make it suitable for pharmaceutical and diagnostic purposes, ranging from targeted drug delivery to molecular imaging.     

Microwave‐Induced In Situ Synthesis of Zn2GeO4/N‐Doped Graphene Nanocomposites and Their Lithium‐Storage Properties

Zn₂GeO₄/N‐doped graphene nanocomposites have been synthesized through a fast microwave‐assisted route on a large scale. The resulting nanohybrids are comprised of Zn₂GeO₄ nanorods that are well‐embedded in N‐doped graphene sheets by in situ reducing and doping. Importantly, the N‐doped graphene sheets serve as elastic networks to disperse and electrically wire together the Zn₂GeO₄ nanorods, thereby effectively relieving the volume‐expansion/contraction and aggregation of the nanoparticles during charge and discharge processes. We demonstrate that an electrode that is made of the as‐formed Zn₂GeO₄/N‐doped graphene nanocomposite exhibits high capacity (1463 mAh g^?1 at a current density of 100 mA g^?1), good cyclability, and excellent rate capability (531 mAh g^?1 at a current density of 3200 mA g^?1). Its superior lithium‐storage performance could be related to a synergistic effect of the unique nanostructured hybrid, in which the Zn₂GeO₄ nanorods are well‐stabilized by the high electronic conduction and flexibility of N‐doped graphene sheets. This work offers an effective strategy for the fabrication of functionalized ternary‐oxide‐based composites as high‐performance electrode materials that involve structural conversion and transformation.