电压闪变测量的数字化实现

闪变作为评定电能质量的重要指标之一,准确测量闪变具有重要意义。本文基于IEC设计规范的闪变测量系统设计,依据其设计原理,在Matlab环境下运用双线性变换将IEC推荐的模拟系统变换为数字系统,给出了各环节数字滤波器的传递函数。编写m文件对电压闪变测量进行了设计与仿真,结果表明:所给出的数字化实现方法完全能满足IEC推荐标准的精度要求。     

基于滤波方法提高精寻北阶段的寻北精度

为了解决摆式陀螺寻北仪在复杂环境下寻北精度不高的问题,在分析寻北过程各个阶段信号特点的基础上,将滤波方法引入精寻北阶段的陀螺信号处理中。该文使用最小均方算法(LMS)自适应滤波、滑动均值滤波、低通滤波及中值滤波对精寻北阶段陀螺信号进行处理,然后对滤波效果进行了分析比对,并进行了精度分析。结果表明,滤波处理后的精寻北阶段数据信号较之前更平滑,波动减小,有利于提高寻北结果的准确度,且经计算,滑动均值滤波的处理结果精度更高。使用滤波方法对陀螺信号进行处理,减小了信号的精度损失,提高了寻北结果的精度和可靠度,具有良好的工程实践性。     

重质油胶体聚集结构的耗散粒子动力学模拟

重质油是以沥青质为胶核分散于饱和油分中形成的极其复杂的胶体体系.本文采用耗散粒子动力学(DPD)方法研究重质油的胶体结构及其影响因素.根据重质油各组分的分子结构特征,构建了描述重质油组分的粗粒化模型化合物.模拟结果表明,本文构建的粗粒化模型能很好地反映重质油的胶体聚集结构.沥青质分子结构对胶体聚集结构有序性有显著影响,较高稠合程度的芳香环结构将使胶束结构有较高的有序性,烷基侧链则表现出分散作用.重质油中的胶质具有胶溶作用,胶质与沥青质的浓度比存在一个极限,当小于这个极限时,重质油将出现聚沉.     

二级热脱附-气相色谱-质谱联用测定大气可吸入颗粒物中的16种多环芳烃

建立了二级热脱附-气相色谱-质谱联用技术测定大气可吸入颗粒物PM10中16种多环芳烃的分析方法。对二级热脱附和色谱-质谱条件进行了优化。实验结果表明,方法的检出限为0.14～0.42 ng/m3,平均加标回收率为52.7%～97.9%,相对标准偏差(RSD)为8.0%～18.4%。与传统方法相比,该方法的样品前处理时间短、有机溶剂的使用量少,是对人体及环境友善的检测技术。该方法已应用于32份实际大气颗粒物样品的分析。     

关于Parseval框架小波的刻画

In this paper,we characterize all generalized low pass filters and MRA Parseval frame wavelets in L 2 （R n ） with matrix dilations of the form （Df）（x） =√ 2f（Ax）,where A is an arbitrary expanding n × n matrix with integer coefficients,such that ｜det A｜ = 2.We study the pseudo-scaling functions,generalized low pass filters and MRA Parseval frame wavelets and give some important characterizations about them.Furthermore,we give a characterization of the semiorthogonal MRA Parseval frame wavelets and provide several examples to verify our results.     

Observations and calculations of two-dimensional angular optical scattering (TAOS) patterns of a single levitated cluster of two and four microspheres

We use single bi-sphere particles levitated in an electrodynamic balance to record two-dimensional angular scattering patterns at different angles of the coordinate system of the aggregate relative to the incident laser beam. Due to Brownian motion the particle covers the whole set of possible angles with time and allows to select patterns with high symmetry for analysis. These are qualitatively compared to numerical calculations. A small cluster of four spheres shows complex scattering patterns, comparison with computations suggest a low compactness for these clusters. An experimental procedure is proposed for studying restructuring effects occurring in mixed particles upon evaporation.     

Photonic generation of microwave signals using dual-wavelength single-longitudinal-mode fiber lasers

Photonic generation of microwave signals is demonstrated with a dual-wavelength single-longitudinal-mode erbium-doped fiber ring laser. Microwave signal with a frequency of 21.07 GHz is obtained by aligning the reflection band of a uniform fiber Bragg grating to the two transmission peaks within a fiber Bragg grating-based Fabry-Perot filter. Stable dual-wavelength single-longitudinal-mode operation is guaranteed by means of the combined filtering effect of a saturable absorber and the Fabry-Perot filter. This approach provides an effective solution to the photonic generation of high-frequency microwave signals.     

Remote fiber sensor based on cascaded Fourier domain mode-locked laser

We propose a high-speed remote fiber Bragg grating (FBG) sensor interrogation system based on a 1.3-μm cascaded Fourier-domain mode-locked (FDML) laser. It consists of multiple FBGs connected to an optical circulator in the laser cavity. The cascaded FDML laser with these multiple FBGs is operational when the scanning frequency of the fiber Fabry-Perot tunable filter matches the fundamental frequency of the laser cavity. Each FBG provides a separate laser cavity for the FDML laser. The scanning frequencies of each laser cavity are 30.5314, 31.5393, 32.7108, and 33.8023 kHz. Using the cascaded FDML laser, we measure the performance of the long-distance static strain FBG sensor interrogation system in both the time and spectral domains. The slope coefficients of the measured relative wavelength difference and the relative time delay from the static strain are found to be 0.95 pm/μstrain and 0.15 ns/μstrain, respectively. We also demonstrate the dynamic response of the interrogation system with 80-Hz modulation strain using the cascaded FDML laser. Thus, an FBG sensor interrogation system for high-speed and high-sensitivity long-distance monitoring systems can be realized using a cascaded FDML laser.     

Complex-number asymmetry parameters of the optical Fano effect in ring resonators

We studied the sharp asymmetric Fano line shape in fiber ring resonator systems and provided an explicit expression for asymmetry parameters using the physical parameters of the system. The fiber ring system was controllable and reconfigurable, allowing us to produce a variety of Fano line shapes in different configurations. Experimentally observed asymmetric spectral structures were fully reproduced using the complex-number asymmetry parameters, validating the approximations used to reduce the analytical expression for the line shape to the phenomenological Fano formula. The results may be useful in the design of on-chip application systems.     

Determination of depth-of-focus in lensless in-line digital particle holography

Lensless in-line digital particle holography (DPH) can be thought of as a special case of photography, and its depth of focus (DoF) characteristics combine those of both photography and holography. The effect of important parameters such as the pixel size and the number of pixels in a charge-coupled device (CCD), the object's distance, the wavelength of the laser, and the particle diameter on the DoF of a reconstruction image in lensless in-line DPH was investigated using simulation holograms. The DoF is directly proportional to the object distance and the particle size. As the wavelength of the laser increases, the DoF decreases. The DoF is inversely proportional to the pixel size and to the number of pixels in a CCD. Instead of expressing nonspecific proportional relationships for DoF, the DoF prediction equations for typical CCD cameras were obtained using DoF data from many simulation holograms and efficient data-fitting software. Finally, the DoF prediction equations were verified using real holograms from a calibration target for several cases. Good agreement between measured and predicted values was confirmed.