Space charge limitation on the response time of organic photodiodes

The dynamic response of an organic bulk heterojunction photodiode to small changes in applied bias or light intensity is investigated as function of the intensity of a constant background illumination by means of photoimpedance and transient photocurrent measurements. For bias voltages close to the open circuit voltage we find that the response timescale with the square root of the light intensity. The results can be quantitatively explained in terms of a space charge limitation on the photocurrent as predicted by Goodman and Rose (J. Appl. Phys. 42, 2823 (1971)). The relaxation time of the diode at open circuit corresponds to the lifetime of the slowest charge carrier in the diode. This relaxation time is determined by the dielectric constant and the smallest of the two carrier mobilities in the bulk heterojunction. This illustrates the importance of balanced carrier mobilities for obtaining diodes with fast response time at low bias for e.g. imaging arrays.     

Inrush current estimation and hot-swapping for safe parallel battery pack

ABSTRACT

Batteries used in electric vehicles and microgrid applications use battery modules connected in series to satisfy the voltage required for each system, and battery modules are connected in parallel to increase capacity. In this parallel connected system, in order to disconnect and reconnect a specific battery module or to reconnect a new battery module, the battery module to be newly connected should have a small state of charge (SOC) difference from the existing battery modules. In particular, when a new battery is to be connected under a load current, there is a problem that excessive inrush current may occur in a specific battery module due to the load current distributed to each module and the current due to the SOC difference. Therefore, in this paper, we propose a method of estimating the inrush current through an equivalent electrical modelling analysis for the case where a battery module is newly added in a system in which the battery modules are connected in parallel. In addition, the power management algorithm for the battery pack system with inrush current estimation is presented. The proposed method is validated through simulations and experiments of a battery pack system in which 10 battery modules of 710V and 120Ah are connected in parallel.     

Direct model-based predictive control scheme without cost function for voltage source inverters with reduced common-mode voltage

This paper presents a direct model-based predictive control scheme for voltage source inverters (VSIs) with reduced common-mode voltages (CMVs). The developed method directly finds optimal vectors without using repetitive calculation of a cost function. To adjust output currents with the CMVs in the range of –V_dc/6 to +V_dc/6, the developed method uses voltage vectors, as finite control resources, excluding zero voltage vectors which produce the CMVs in the VSI within ±V_dc/2. In a model-based predictive control (MPC), not using zero voltage vectors increases the output current ripples and the current errors. To alleviate these problems, the developed method uses two non-zero voltage vectors in one sampling step. In addition, the voltage vectors scheduled to be used are directly selected at every sampling step once the developed method calculates the future reference voltage vector, saving the efforts of repeatedly calculating the cost function. And the two non-zero voltage vectors are optimally allocated to make the output current approach the reference current as close as possible. Thus, low CMV, rapid current-following capability and sufficient output current ripple performance are attained by the developed method. The results of a simulation and an experiment verify the effectiveness of the developed method.     

Contingent derivatives and regularization for noncoercive inverse problems

Abstract

We study the inverse problem of parameter identification in noncoercive variational problems that commonly appear in applied models. We examine the differentiability of the set-valued parameter-to-solution map using the first-order and the second-order contingent derivatives. We explore the inverse problem using the output least-squares and the modified output least-squares objectives. By regularizing the noncoercive variational problem, we obtain a single-valued regularized parameter-to-solution map and investigate its smoothness and boundedness. We also consider optimization problems using the output least-squares and the modified output least-squares objectives for the regularized variational problem. We give a complete convergence analysis showing that for the output least-squares and the modified output least-squares, the regularized minimization problems approximate the original optimization problems suitably. We also provide the first-order and the second-order adjoint method for the computation of the first-order and the second-order derivatives of the output least-squares objective. We provide discrete formulas for the gradient and the Hessian calculation and present numerical results.     

High-performance and current crowding-free InGaN-GaNbased LEDs integrated by an electrically-reverse-connected Schottky diode and a Mg-delta doped p-GaN

This work demonstrates high-performance and current crowding-free InGaN/GaN light-emitting diodes (LEDs) using an electrically-reverse-connected Schottky diode (SD) and an Mg-delta (δ) doped layer.Poss...     

Zr掺杂对MgB2超导微观结构和超导电性的影响

将Mg粉、Zr粉和B粉按比例混合获得Mg1-xZrxB2(x=5%10%和20%),压制成型后,在流通氩气的条件下于800℃烧结2h.利用X射线衍射仪(XRD)、扫描电子显微镜(SEM)分析烧结后样品的显微结构和化学组成,采用差热分析(DTA)观察Zr掺杂对MgB2分解温度的影响,并用物性测试仪(PPMS)测试样品的超...     

Improved performance of lateral GaN-based light emitting diodes with novel buried CBL structure in ITO film and reflective electrodes

In this letter, lateral GaN-based Light Emitting Diodes (LEDs) with a SiO₂ current blocking layer (CBL) buried in the indium tin oxide (ITO) film and highly reflective metal materials have been proposed. Compared with the conventional CBL structure which was inserted between ITO film and p-type GaN, simulation results showed that LEDs with a buried CBL in the ITO film effectively facilitated current spreading under the CBL. We demonstrated that buried CBL was beneficial for suppressing current crowding (CC) effect around the edge of CBL and may facilitate higher LED efficiency. Furthermore, experimental results showed that LEDs with the buried structure we proposed showed lower working voltage and higher light output power (LOP) compared with those with conventional CBL structure. These results further confirmed that the buried CBL scheme was effective to reduce current crowding (CC) effect. In addition, highly reflective metal materials of Cr/Al/Pt/Au were employed to reduce light absorption and achieve high light extraction efficiency.     

High-speed deposition of RE123 film with large current capacity by hot-wall type PLD system

We have studied a hot-wall heating system to produce GdBa₂Cu₃O_y (GdBCO) films with large critical currents (I_c) at a high production rate by a pulsed-laser-deposition (PLD) method. GdBCO films fabricated at a production rate of 30 m/h under the optimized conditions, especially a distance of 95 mm between the target and the substrate (T–S), exhibited high critical current densities (J_c) of about 3 MA/cm² and I_c over 300 A at a thickness of 1–2 μm. Furthermore, long GdBCO tapes prepared by repeated depositions at each tape-passing speed of 80 m/h showed uniform I_c distribution along the longitudinal direction, because the hot-wall system enabled to stabilize temperature within a few degrees at 800 °C. A 170 m long tape with I_c over 600 A was successfully fabricated at a production rate of 16 m/h using a laser power of 360 W.     

Spin-dependent transport in a nanopillar non-local spin valve

We investigate the injection of a pure spin current into a non-magnetic Cu wire in a lateral spin valve. We detect the spin accumulation occurring at the interfaces between the magnetic nanopillars and the non-magnetic wire in the non-local geometry. We confirm that the accumulated spins diffuse equally in the Cu wire irrespective of the presence of a charge current. The inversion of the injector and detector magnetic nanopillars does not affect the spin signal, in agreement with analytical predictions for this system.     

A model of nonlinear electrodynamics

A new model of nonlinear electrodynamics with two parameters is investigated. We also consider a model with one dimensional parameter. It was shown that the electric field of a point-like charge is not singular at the origin and there is the finiteness of the static electric energy of point-like charged particle. We obtain the canonical and symmetrical Belinfante energy–momentum tensors and dilatation currents. It is demonstrated that the dilatation symmetry and dual symmetry are broken in the models suggested. We have calculated the static electric energy of point-like particles.