Two-beam interference detection of the changes in fibre structural parameters during low drawing process

A Pluta polarizing interference microscope with a fibre stretching device attached was used to detect the changes in molecular structure that occur during the fibre cold drawing process. Fibres drawn with low draw ratios show different types of deformation mechanisms. The interference patterns recorded at different draw ratios are used to relate the deformation mechanisms with the measured structural parameters. Some optical parameters are measured such as; refractive indices nand n birefringence n, the polarizability per unit volume , the orientation distribution function f(θ), the angle θ between the stretching direction and the chain axis, and the angle θ_m which the transition dipole moment of the molecular species makes with the molecular axis (chain axis). Three polymeric fibres (Polyethylene terephthalate PET, Polypropylene PP and Polyamide PA) were used in this study and their interferograms are illustrated.     

1.55μm SiGe 2×3光开关

利用多模干涉效应和自由载流子等离子体色散效应设计和模拟了基于1.55μm波长的2×3 SiGe光开关.该光开关由两个单模输入端口、一个多模干涉区和三个单模输出端口构成.在多模干涉区,设有两个折射率调制区,可以利用来把从两个输入端口输入的光信号分别从三个输出端口输出.束传播法分析结果表明,该光开关的传输损耗小于1.43dB,串扰在-18～-32.8dB之间.     

高精度测量F-P标准具间距的光谱方法

利用高分辨率光谱分析仪对空气隙F P标准具透射谐振峰频率进行测量 ,然后通过直线拟合获得自由谱域 ,从而计算得出F P标准具的间距。对F P标准具间距测量的精度进行分析 ,F P标准具间距测量的相对误差为2× 10 -3 。提出了一种新颖的入射光与F P标准具垂直的精确调节方法     

基于重叠式联盟博弈的Femtocell干扰管理研究

给出了一种基于重叠式联盟形成博弈论的协作式算法,用于解决正交频分多址宏小区和家庭基站(Femtocell)两层网络中的资源分配和干扰管理问题。给出的算法相比于已有算法显著降低了家庭基站接入点到家庭基站用户的下行同层干扰,提高了以系统码率衡量的系统性能。     

Research on the optical fiber gas flowmeters based on intermodal interference

In this work, a self-heating type optical fiber flowmeter with high sensitivity was proposed. The core-offset fiber structures were employed to couple a part of signal light into the fiber cladding layer, and the other part of light still propagated in the core layer. The intermodal interference between the two parts of light happened when the cladding modes were coupled back into core layer. Meanwhile, the high power laser was also introduced into fiber to heat the silver film coated on the surface of the cladding layer. When the cool gas flow passed, the temperature of the sensor probe decreased due to the heat transfer process. Because of the thermo-optic effect in the fiber, interference spectrum could be shifted when the temperature was changed. The experimental results showed the resolution of the proposed sensor was 2×10⁻² m/s in the region of 0–8 m/s. The highest sensitivity could achieve 1537 pm/(m/s).     

A mechanism for detecting on-chip radio frequency interference of field-programmable gate array

One-chip measurements without modifying the physical structure of packaged integrated circuits such as field-programmable gate arrays (FPGA) is challenging. This paper proposes a sensor for detecting the radio frequency interference (RFI) on the supply inside the FPGA chip. The core of the sensor is a ring oscillator built with FPGA look-up tables. The paper proposes a model to predict the response of the ring oscillator to power supply RFI, and shows that the normalized frequency shift of the ring oscillator resulting from the interference is determined by the amplitude of the interference. This relationship is independent of the interference frequency and the size of the ring oscillator. To verify the model, simulations on transistor-level look-up tables of 130-nm and 40-nm technologies were performed. The simulation results matched well with the model. In addition to simulation, an FPGA test board was fabricated. Measurements of FPGA RFI response were performed and the results were consistent with the theoretical model. The effect of the interference on the ring oscillator provided a mechanism to detect the amplitude of the supply interference on the FPGA chip. The frequency of the ring oscillator was monitored through the supply pin by measuring the spectrum of the supply noise. The properties of the sensor, such as constant response in a wide frequency range, insensitiveness to the oscillator size, ease of implementation, and minimal modification requirement of the physical structure, made it suitable for performing on-chip FPGA measurements.     

TD-LTE(F)系统干扰问题分析

TD-LTE采用F频段组网面临着较为复杂的干扰问题,异系统干扰将会导致系统吞吐能力的下降。本文对TD-LTE F频段的干扰原因进行分析,并通过现网测试确认相关干扰源,最后提出TD-LTE系统与其他各系统的隔离度要求及F频段天面规划设计流程。     

基于光储频的超宽带相控阵干扰系统设计

瞄准现代化信息战争中有源电子干扰超宽带、大功率、多目标作战能力需求,将超宽带光储频技术与有源相控阵相技术相结合,构建并设计了一套基于光储频的超宽带相控阵干扰系统。基于光延时网络结合波分复用技术实现超宽带光储频,并通过实时时间延时技术实现超宽带有源相控阵发射多波束合成。系统具有大有效辐射功率发射、同时多波束发射以及超宽带瞬时干扰特性,有效解决了传统数字储频、非功率合成体制有源电子干扰系统有效辐射功率小、多波束能力不足、干扰带宽受限等问题。     

A modified sequential extraction method for arsenic fractionation in sediments

A modified sequential extraction method was developed to characterize arsenic (As) associated with different solid constituents in surficial deposits (sediments), which are unconsolidated glacial deposits overlying bedrock. Current sequential extraction methods produce a significant amount of unresolved As in the residual fraction, but our proposed scheme can fractionate >90% of the As present in sediments. Sediment samples containing different As concentrations (3–35 μg g⁻¹) were used to assess the developed method. The pooled amount of As recovered from all the fractions using the developed method was similar (83–122%) to the total As extracted by acid digestion. The concentrations of As in different fractions using the developed scheme were comparable (89–106%) to the As fractions obtained by other existing methods. The developed method was also evaluated for the sequential extraction of other metals such as copper (Cu), cobalt (Co), chromium (Cr) and strontium (Sr) in the sediment samples. The pooled concentrations of these four individual metals from all the fractions were similar (96–104%) to their total concentrations extracted by acid digestion. During method development, we used extractants that did not contain chloride to eliminate formation of polyatomic ions of argon chloride (⁴⁰Ar³⁵Cl) that interfered with ⁷⁵As when analyzed using inductively coupled plasma mass spectrometer (ICP-MS). The results suggest that the developed method can reliably be employed for complete As and other metals’ fractionation in sediments using ICP-MS.