Compositional, structural, optical and electrical characterization of CulnTe2 grown by the tellurization of stoichiometric Cu and in in the liquid phase

A new method to grow single crystals with stoichiometry close to 1:1:2 of CuInTe₂, an important member of the Cu-III-VI₂ family of semiconductors is described. This consists of tellurization in the liquid phase of stoichiometric Cu and In and later solidification under directional freezing. It is found from energy dispersive spectroscopy that the ingots obtained with the evaporation temperature (T_t) of Te at 590 and 635°C were very close to the ideal stoichiometry 1:1:2. Samples of all ingots obtained with T_t between 530 and 690°C, as studied by x-ray and differential thermal analysis, were of single phase having chalcopyrite structure and p-type conductivity. Optical and electrical characterization of different ingots were made. The acceptor ionization energy E_A and the density of states effective mass m _p ^* of the holes are estimated from the temperature dependence of the hole concentration p in samples of different ingots. m _p ^* = (0.78 ± 0.02) m_e agrees quite well with the reported value. From a combined analysis of the variation of E_A with p^1/3 and the knowledge of molecularity and valence stoichiometry of each sample, it is established that the shallow acceptor level observed in different samples with E_A (0) ⋍ 30 meV is due to V_In.     

利用相位和强度调制器产生高消光比超短光脉冲

提出了一种产生高消光比超短光脉冲的新方法.利用相位调制器调制连续光生成啾啁光,而后利用M-Z强度调制器的倍频调制抑制对压缩不利的啁啾部分的影响,再通过等效啁啾光纤光栅进行压缩产生光脉冲.理论和仿真结果表明,该方法可以很好地消除光脉冲的基底及减小旁辦,产生消光比大于30 dB、波形理想的光脉冲,具有很强的可实现性.最后利用实际制作的色散系数为-380 ps/nm的等效啁啾光纤光栅对该方法进行了实验验证,结果表明,在重复频率为2.5 GHz、相位调制系数为9时,可产生脉宽小于18 ps的高质量光脉冲.     

液晶投影电视中视频信号与显示模件接口电路的设计与研究

本文介绍了液晶投影电视的基本原理和光学系统,根据液晶显示模件的接口参数,设计了液晶投影电视的接口电路,对该电路的工作原理进行了分析和讨论。同时,对行同步相位调整电路进行了详细的电路设计和研究。     

Spiking patterns of a hippocampus model in electric fields

We develop a model of CA3 neurons embedded in a resistive array to mimic the effects of electric fields from a new perspective. Effects of DC and sinusoidal electric fields on firing patterns in CA3 neurons are investigated in this study. The firing patterns can be switched from no firing pattern to burst or from burst to fast periodic firing pattern with the increase of DC electric field intensity. It is also found that the firing activities are sensitive to the frequency and amplitude of the sinusoidal electric field. Different phase-locking states and chaotic firing regions are observed in the parameter space of frequency and amplitude. These findings are qualitatively in accordance with the results of relevant experimental and numerical studies. It is implied that the external or endogenous electric field can modulate the neural code in the brain. Furthermore, it is helpful to develop control strategies based on electric fields to control neural diseases such as epilepsy.     

L波段高功率线极化径向线阵列天线理论分析与数值模拟

 探索了L波段的高功率线极化径向线阵列天线。基于三角形栅格形式实现了径向线圆形平面阵列天线,分析并给出了径向线并联馈电网络,并以同轴馈电的水平单圆环线极化天线为基础,利用径向线并联馈电网络设计出了间距小于一个波长下L波段高功率线极化径向线阵列天线。研究结果表明：这种结构实现径向线阵列天线的线极化辐射是可行的,该天线在中心频率1.57 GHz下,增益为19.97 dBi,轴比为-52.06 dB,反射系数为0.105 2;在1.37～1.77 GHz的频率范围内增益大于18.64 dBi,轴向轴比值小于-46.45 dB。     

温度对铌酸锂电光相位调制特性的影响

利用折射率椭球基本理论对线性电光效应进行了分析,对单轴晶体铌酸锂电光相位调制器的温度特性进行了研究。通过计算机进行数值模拟计算,分析了加电场时光通过LiNbO3电光调制器后出射光的相位变化与温度间的关系,得出在横向和纵向调制中温度对相位改变的影响。研究发现,无论在横向还是在纵向调制下,入射光偏振方向不同但其各自受温度影响的相位变化趋势大体一致,即随着晶体中温度的增加而增大。计算结果表明,LiNbO3电光调制的最佳使用方案为：电场沿x主轴方向施加,入射光偏振方向为感应主轴x’方向,且LiNbO3电光调制器粟用横向相位调制方式。     

自蔓延高温合成实验压力与燃烧速率测试方法研究

自蔓延高温合成技术是利用原料在初始点燃条件下化学反应所产生的高温高热,使燃烧反应自发地进行,从而得到新的成分和结构的产物。通过对自蔓延高温合成实验压力和燃烧速率测试方法的研究,根据实验的要求,选择合适的压力传感器,并自行设计有效的燃烧速率测试系统,合理选择监测点,编制满足测试需求的数据采集及控制程序,获取大量有效实验数据,为测定自蔓延燃烧过程中的压力和速率变化曲线,进行反应热力学、动力学分析,对反应安全进行评估,提供有力的数据支持,并对相关研究具有重要的借鉴意义。     

幅相一致行波管非线性理论与计算机模拟

采用谐波互作用的行波管二维大信号非线性理论,建立了高频电路结构和外部工作条件零散模型,对影响增益、相位频率特性的主要因素进行了理论分析和数值计算,开发了可动态实时显示行波管工作状态的可视化科学计算软件,并利用该软件全面地分析了某管型的幅相一致特性,为新近研制的幅相一致行波管提供了很有价值的计算结果。     

Dislocation driven chromium precipitation in Fe-9Cr binary alloy: a positron lifetime study

The influence of initial heat treatment on anomalous Cr precipitation within high temperature solubility region of the Fe–9Cr alloy has been investigated using positron lifetime studies. Air-quenched samples with pre-existing dislocations exhibited a distinct annealing stage in positron lifetime between 800 and 1100?K corresponding to Cr-precipitation. During this stage, Transmission Electron Microscopy showed fine precipitates of average size 4 nm, dispersed throughout the sample and from Energy-dispersive X-ray spectroscopy (EDS) analysis they are found to be Cr-enriched. The presence of dislocations is found to be responsible for Cr precipitation.     

Effect of long-period stacking ordered phase on thermal stability of refined grains in Mg-RE-based alloys

The refined grains in both as-cast Mg-10Y-1Zn-2Zr (WZ101?K, wt.%) and Mg-10Y-1Al (WA101, wt.%) alloys have been found to have superior thermal stability after solution treatment. Plate-shaped, but different polytypes of long-period stacking ordered (LPSO) phases distributed along grain boundaries are considered as the predominant inhibitors of grain growth. Based on the plate-shaped features of the LPSO phases, a modified Zener’s model is established and the predicted limiting grain sizes are in a good agreement with the experimental results. Therefore, this model has strong potential for designing advanced Mg-RE-based alloys with high strength and high creep resistance at high temperatures.