三环无源谐振腔在光纤激光器中的选频特性

利用琼斯矩阵对一种三环嵌套的无源谐振腔的选频特性进行了分析,并根据无源谐振腔选频的原理,设计了一种基于三环嵌套无源谐振腔的掺铒光纤激光器.实验结果表明:三环嵌套的无源谐振腔具有良好的选频特性,当泵浦功率为159 mW时,得到了稳定的单纵模激光信号输出;输出功率的最大波动为0.04 dB,输出中心波长最大漂移为0.016...     

Wideband LC balun transformer using coupled LC resonators embedded into organic substrate

In this paper, wideband LC balun using coupled LC resonator has been newly designed, simulated, and fabricated. The proposed balun has a novel scheme which consists of two pairs of coupled embedded LC resonators which share one resonator with each other. The coupled resonators are applied to provide a precise phase difference of 180° and an identical magnitude between two balanced ports and DC isolation characteristic with impedance transformation. Furthermore, proposed resonators have relatively small inductance values which can be easily embedded into the organic package substrate. In order to reduce the size of embedded capacitors, BTO composite high dielectric film was applied to increase their capacitance densities. The measured results of fabricated wideband balun exhibited an insertion loss of 1.8 dB, a return loss of 10 dB, a phase imbalance of 0.5°, and magnitude imbalance of 0.7 dB at frequency bandwidth of 700 MHz ranged from 1.8 to 2.5 GHz, respectively. They agreed well with the simulated ones. The fabricated balun has a relatively small volume of 2 mm×3.5 mm×0.66 mm (height).     

应用于新能源发电系统的双输入高增益直流变换器

在新能源联合发电系统中,多输入直流变换器能够简化系统结构和降低成本,因而被广泛采用。针对现有的多输入直流变换器输出电压低、功率不稳定的问题,提出了一种新型双输入高增益直流变换器拓扑。从双输入直流变换器的工作原理出发分析变换器的工作特性,并计算在不同工作方式下的电压增益。不同模式下的MATLAB/Simulink仿真结果表明,该电路拓扑具有高升压比、电路拓扑简洁,且输入源可根据负载协调分配等优点。     

Optical modulator using metal-oxide-semiconductor type Si ring resonator

Electric-field drive optical modulators using a Si ring resonator were fabricated on silicon-on-insulator (SOI) wafers. The fabricated resonators consisted of Si waveguides with width and thickness of 1.0 and 0.3 μm, respectively. In order to induce the linear electro-optic (EO) effect in the Si core layer, the strain was applied by covering the layer with Si₃N₄ film (0.26 μm thick) deposited by low pressure chemical vapor deposition (LPCVD) at 750 °C. The vertical electric-field was applied to the Si waveguide through the top and bottom cladding layers, and the optical output from the drop port at the resonance wavelength was measured. At a wavelength of 1501.6 nm, the optical modulation of 33% was obtained at 200V (electric-field at the silicon surface ∼3 × 10⁵ V/cm, nearly the breakdown field). The resonance wavelength was shifted toward the short wavelength side by applying both positive and negative voltages, this shift was explained by carrier concentration modulation. The linear EO effect in the Si core layer was not observed, presumably because the strain in the Si core layer was too small.     

高性能声表面波调频振荡器的研究

分析了声表面波谐振器的性能 ,论述了声表面波振荡器的工作原理及设计方法 ,最终完成中心频率为797.3 MHz的振荡电路 ,调频带宽 2 MHz(2 5 0 0 PPM)。文中对影响调频带宽、相位噪声的因素进行了分析讨论。本项目研究成果已获得实际应用     

120 W的二极管泵浦Nd:YAG绿光激光器

对激光二极管泵浦的NdYAG声光调Q腔内倍频固体激光器的折叠腔型进行了研究,当泵浦功率达800 W时,在V型腔上实现了脉宽为80 ns、重复频率为10 kHz、发散角为6 mrad、绿光功率为112 W的输出;在Z型腔上实现了脉宽为95 ns、重复频率为10 kHz、发散角为4 mrad、绿光功率为120 W的输出.比较两种腔型的实验结果可看出,Z型腔由于插入的光学元件较多,腔长较长,输出激光的脉宽较宽,但输出激光的光束质量有明显的提高.     

种子注入式单纵单横电光调Q激光器

基于种子注入技术、干涉法腔模锁定方案以及自滤波非稳腔技术,设计并研制出一套单纵单横电光调Q脉冲激光器系统。该系统输出的基波(波长1064nm)能量达到600mJ,倍频后绿光能量达到300mJ,发散角接近衍射极限,线宽接近傅里叶变换极限,在强气流强振动环境中单纵模的锁定概率为100%。实验观测了种子注入对巨脉冲建立时间、光斑模式以及能量的影响。该系统可应用于受激布里渊散射(SBS)、大视场风洞全息以及光学合成孔径等研究领域。     

一种体声波滤波器仿真设计分析

文中着重阐述了基于微机电系统（Micro-Electro-Mechanical Systems，MEMS）技术制造的薄膜体声波谐振器／滤波器，简述了它的结构及原理，分析了其主要特征参数和设计方法，并设计了中心频率为2．4GHz，带宽为100MHz的带通滤波器，展示了薄膜体声波谐振器／滤波器的突出性能，为通信MEMS技术的微型化发展提供了更广阔的道路。     

声表面波谐振型无源无线温度传感器硬件系统

介绍了一种基于声表面波谐振器的无源无线温度传感系统,系统采用一次变频的构成方式,解决了传统传感系统存在电路结构复杂和控制灵活性差的缺点,给出了系统的具体构成、工作原理和天线的设计。与传统系统构成相比,本系统的构成更简洁,操作性和灵活性更强。实验验证了本系统构成方式的可行性和天线设计的优点。