一种宽带注入锁定三倍频器

文章提出了一种宽带注入锁定三倍频器。在传统注入方式基础上,倍频器采用了推-推差分对输入信号进行二倍频,并将产生的二次谐波通过变压器耦合至注入管的源极共模点,增强了注入管源极共模点二次谐波。由于注入电流是由注入信号与源极共模点二次谐波进行混频而产生,因此注入电流也被增强,从而增大了锁定范围。除此之外,三倍频采用了四阶谐振器,谐振阻抗的相位在过零点被平坦化,锁定范围进一步被增大。采用标准CMOS 65 nm工艺设计三倍频,芯片面积为720×670 μm²,1.2-V供电时的功耗为15.2 mW。0 dBm注入功率下三倍频的锁定范围为19.2~27.6 GHz,对应的基波抑制比大于25 dB,二次谐波抑制大于35 dB。注入锁定三倍频器可满足5G收发机中本振源的要求。     

宽阻带小型化双频带通滤波器

文中提出了一种具有宽阻带的紧凑型双频带通滤波器,它采用了折叠短路枝节负载谐振器、紧凑型微 带单元谐振器(CMRC)和阶跃阻抗谐振器结构。由于多个谐振器产生了五个可控传输零点(TZ),该滤波器实现了两个 通带之间的良好隔离度以及宽阻带特性。制作并测试了尺寸紧凑的双频带通滤波器实验样品,测试结果显示,第一通 带和第二通带的中心频率/ 插入损耗分别为0. 66 GHz/0. 8 dB 和1. 73 GHz/0. 7 dB,阻带频率高达10. 5 GHz,抑制水平 超过15 dB。     

谐振器加载石墨烯的双通带可调滤波衰减器设计

石墨烯材料在微波段的阻抗可控特性是其最有价值的应用特性之一。文中首次分析了石墨烯对微带 多模谐振的影响机理,提出了一种集成滤波衰减功能为一体的灵活可控器件。首先,对不同位置加载石墨烯的微带双 模谐振器进行了严格的等效电路建模,通过奇偶模分析法及输入导纳参数计算,探究了双模谐振受石墨烯阻抗及其加 载位置的影响,明晰了石墨烯材料对微波谐振器的影响。随后设计了动态可调的滤波衰减器并阐述了石墨烯材料在谐 波控制上的潜在应用点。最后,采用不同尺寸的双模谐振器进行石墨烯加载并完成双通带幅度独立可控的滤波衰减器 的设计,仿真与实测结果吻合良好,验证了阻抗可控石墨烯材料在可调微波衰减类器件上的应用前景。     

Investigation of superconductivity effects in single-phase and multiphase Bi2Sr2CaCu2O8 single-crystals at 2-MM wavelengths

Experimental investigations of superconductivity effects in single-phase and multiphase Bi₂Sr₂CaCu₂O₈ single-crystals have been carried out at 142 GHz frequency by means of the standing wave profile method [1]. Josephson harmonic generation has been observed to be responsible for the appearence of additional peaks on the standing wave profile of the open dielectric resonator loaded with a properly orientated multiphase high-T_c superconductor specimen. This leads to the conclusion that most of the Josephson junctions in multiphase crystals are located in certain crystallographic planes. The investigations of temperature dependencies showed that sharp resonant peaks of conductivity observed earlier [2] at 60 GHz could also be observed at 142 GHz.     

Mode selective directional couplers for overmoded waveguide systems

Two types of directional couplers for transverse electric (TE) modes are described: short and multihole couplers, respectively. They selectively pick one mode out of a mode mixture in an overmoded circular waveguide system. Unwanted modes are either statistically kept at low level or are suppressed by destructive interference in the coupling waveguide. Mode selectivity and directivity in multihole couplers oscillate up and down with an increasing number of holes, finally reaching a minimum of approximately 20 dB, unless there are competing modes with rational fractions of the beat wavelength. A multihole coupler for the TE₀₂ mode (28 GHz, 63.4 mm waveguide diameter, 41 holes) and a length of 1.6 m shows a calculated directivity of 68 dB and suppresses the unwanted modes TE₀₁ with 34 dB (24 dB), TE₂₂ with 37 dB (45 dB), and further modes TE_m (<5, m<6) with 17 dB to 34 dB in forward direction (figures in parentheses are for unwanted modes propagating in backward direction).A short directional coupler for the TE₀₁ mode (28 GHz, 63.4 mm waveguide diameter) with 16 holes and a length of 230 mm shows a directivity of 55 to 100 dB between 27.9 and 28.1 GHz, suppressing the TE₀₂ mode with 35 to 80 dB, the TE₀₃ mode with 30 to 65 dB, and the TE₂₂ mode with 30 to 70 dB.     

Operation of the quasi-optical gyrotron at harmonics of the gyrofrequency

This paper investigates the performance of a quasioptical gyrotron, when the electron beam interacts with the radiation fields at harmonics of the gyrofrequency. The nonlinear equations of motion are obtained in the slow-timescale. The expression for the linear gain is derived and the conditions for excitation are given (frequency threshold, optimal operating point, bean current and resonator quality thresholds). In the nonlinear regime, it is shown that maximum efficiencies comparable to those at the fundemental (50%) are possible, albeit at a prohitively high radiation field amplitude, while realistically feasible field amplitudes can give somewhat smaller, but nevertheless still high efficiencies (15%). Finally, the results are suplemented by empirical scaling laws, useful for experimental designs.     

1.55μm SiGe 2×3光开关

利用多模干涉效应和自由载流子等离子体色散效应设计和模拟了基于1.55μm波长的2×3 SiGe光开关.该光开关由两个单模输入端口、一个多模干涉区和三个单模输出端口构成.在多模干涉区,设有两个折射率调制区,可以利用来把从两个输入端口输入的光信号分别从三个输出端口输出.束传播法分析结果表明,该光开关的传输损耗小于1.43dB,串扰在-18～-32.8dB之间.     

束变换环孔激光谐振腔的环束场传输差分计算

 通过使用新的坐标变量和光场的表达形式，推导了新坐标系下环束场传输的偏微分方程，给出了相应差分方程的截断误差和稳定性条件，使得环束场传输计算速度大幅提高；使用二阶精度的Crank-Nicolso差分方法对束变换环孔激光谐振腔的环束场传输进行了计算，并与W.D.Murphy和M.L.Bernabe所给M-B积分近似方法的计算结果进行了比较，证实了该方法无论计算速度和精度都优于M-B积分近似方法。     

A 10-MHz SOI-Based Face Shear Square Micromechanical Resonator

A 10-MHz face shear (FS) square micromechanical resonator based on silicon-on-insulator (SOI) technology is presented in this paper. In order to examine the improvement of quality factor as well as motional resistance Rx in this structure, the center-stem anchor is employed in this study. The benefit of anchoring the square in the center, which is the nodal point, is that the energy losses through the anchor can be minimized. Hence, a quality factor value of 2.0 million and the motional resistance of 8.2 kΩ can be obtained with an FS mode resonator via finite element (FE) simulation. The results show the significance of the FS mode in this design, not only in its structure but also in its square-extensional mode and Lame-mode. Additionally, an SOI-based fabrication process is proposed to support the design.     

基于耦合T型空腔的多重法诺共振现象

提出由T型空腔和挡板组成的两种金属-电介质-金属(MIM)波导结构,分别为:正T型空腔结构和倒T型空腔结构,并应用有限元法系统地研究了该结构的透射特性.对于正T型空腔结构,仿真结果出现了双重法诺共振现象,并且共振波长可以通过改变T型空腔长度和高度进行调节.该结构有助于设计成敏感度达到1 620nm/RIU、品质因数为5.4×10~4的纳米传感器.对于倒置T型空腔,在波导中产生了多重法诺共振现象,其敏感度可达1 560nm/RIU,品质因数为9.37×104.该结构有望在光学集成回路,特别是纳米传感器、光束分路器方面具有广泛应用.