台达变频器在纺织织带盘带机上的应用

盘带机是纺织织带成品分卷设备，需要使用到收放卷控制。本文基于台达变频器在盘带机上的应用案例，论述盘带机自动化系统设计调试过程以及遇到的问题分析。     

Effect of nonstoichiometry on Raman scattering of VO2 films

We report on Raman scattering of VO2 films prepared by radio frequency magnetron sputtering under different conditions. Our investigations revealed that the dominated Raman peaks shift towards high frequency for both V-rich and O-rich VO2 films, compared with the stoichiometry VO2 films. The experimental evidence is presented and the cause for nonstoichiometry dependence of Raman spectra of VO2 films is discussed.     

低速二维流动的粒子仿真研究

本文运用信息保存法对低速二维的流动现象进行模拟，考察了低速条件下的有限平板绕流以及微槽道气体流动问题。研究表明：在对低速流动的模拟过程中，运用IP法在能够获得较好的结果的同时，具有比DSMC方法更高的计算效率。     

后退火温度对溅射沉积Pb(Zr0.52Ti0.48)O3铁电薄膜结构和性能的影响

在具有Ti缓冲层的Pt(111)底电极上,用射频溅射工艺在较低的衬底温度(370℃)和纯Ar气氛中沉积Pb(Zr0.52Ti0.48)O3(PZT)薄膜,沉积过程中基片架作15°摇摆以提高膜厚的均匀性。然后将样品在大气中进行5min快速热退火处理,退火温度550-680℃。用XRD、SEM分析薄膜的微结构,RT66A标准铁电测试系统测量样品的铁电和介电性能。结果表明,所沉积的Pt为(111)取向,仅当后退火温度高于580℃,沉积在Pt(111)上的PZT薄膜才能形成钙钛矿结构的铁电相,退火温度在580-600℃时结晶为(110)择优取向,退火温度高于600℃时结晶为(111)择优取向。PZT薄膜的极化强度随退火温度的升高而增加,但退火温度超过650℃时漏电流急剧上升,因此退火处理的温度对PZT薄膜的结构和性能有决定性的影响。     

Sterically stabilized emulsion polymerization of styrene: Pseudo‐semicontinuous approach

The sterically stabilized emulsion polymerization of styrene initiated by a water‐soluble initiator at different temperatures has been investigated. The rate of polymerization (R_p) versus conversion curve shows the two non‐stationary‐rate intervals typical for the polymerization proceeding under non‐stationary‐state conditions. The shape of the R_p versus conversion curve results from two opposite effects—the increased number of particles and the decreased monomer concentration at reaction loci as the polymerization advances. At elevated temperatures the monomer emulsion equilibrates to a two‐phase or three‐phase system. The upper phase is transparent (monomer), and the lower one is blue colored, typical for microemulsion. After stirring such a multiphase system and initiation of polymerization, the initial coarse polymer emulsion was formed. The average size of monomer/polymer particles strongly decreased up to about 40% conversion and then leveled off. The initial large particles are assumed to be highly monomer‐swollen particles formed by the heteroagglomeration of unstable polymer particles and monomer droplets. The size of the “highly monomer” swollen particles continuously decreases with conversion, and they merge with the growing particles at about 40–50% conversion. The monomer droplets and/or large highly monomer‐swollen polymer particles also serve as a reservoir of monomer and emulsifier. The continuous release of nonionic (hydrophobic) emulsifier from the monomer phase increases the colloidal stability of primary particles and the number of polymer particles, that is, the particle nucleation is shifted to the higher conversion region. Variations of the square and cube of the mean droplet radius with aging time indicate that neither the coalescence nor the Ostwald ripening is the main driving force for the droplet instability. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 804–820, 2003     

射频激励扩散型冷却阵列波导CO2激光器技术

本文介绍了目前国内外研究者们提出的各种射频激励相干阵列波导ＣＯ２激光器技术，讨论了射频激励相干阵列波导ＣＯ２激光器技术的一个研究方向。     

微光机电系统的微绞链研制

本文讨论了非硅微机械工艺和微绞链的研制工艺。我们研制的非硅表面微机械工艺采用两次或三次掩模电镀层，聚酰亚胺和光刻胶分别作为底层和第二、第三层的牺牲层。用这套工艺，研制成功了三种不同种类的微绞链。微绞链能在基片表面作０—１８０度自由转动。     

Viscometric study of gelatin in dilute aqueous solutions

The viscosities of aqueous solutions of gelatin at different temperatures were carefully measured in a common glass‐capillary Ubbelohde viscometer at dilute to extremely dilute concentrations. The adsorption effect that occurred in the viscosity measurements was theoretically analyzed and discussed. A theory based on Langmuir isotherms could adequately describe the existing data. Some structural information was obtained by the use of an iterative fitting procedure to treat the reduced viscosity data, which disclosed that individual gelatin chains underwent a coil‐to‐helix transition as the solution cooled from 40 to 15 °C. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 1804–1812, 2006     

Effects of Amplitude of the Radiofrequency Electromagnetic Radiation on Aqueous Suspensions and Solutions

The effects of radiofrequency (RF) (1–4) and magnetic fields (5–9) on the behavior of aqueous solutions and suspensions have been a popular subject in recent years. The mechanism of the magnetic “water memory” effect, though, is still largely unknown (5). In this work, we present evidence that the primary “receptor” of the electromagnetic radiation is a gas/liquid interface. Gas can be either already present in water or produced by the effects of electromagnetic fields. Perturbed gas/liquid interfaces require hours to equilibrate. Certain RF and magnetic signals also produce reactive oxygen and hydrogen species (superoxide, hydrogen peroxide, hydrogen, atomic hydrogen). The perturbed gas/liquid interface modifies the hydrogen bonding networks in water and also the hydration of ions and interfaces. Careful outgassing removes all of the effects of the electromagnetic fields, including the magnetic memory effect. The amplitude of the applied field influences the observed effects. Different amplitudes of RF radiation perturb the interfacial water in different ways and consequently affect the behavior of colloids and ions in specific manners. For instance, the bulk and template precipitation of calcium carbonate, zeta potentials of suspended colloids, rate of dissolution of colloidal silica, and attachment of colloidal silica to metal surfaces are modified in specific ways with the low amplitude or high amplitude RF treatments described in this paper. The solubility/diffusivity of gas species is also modified in a different manner, and it is probably at the core of the specificity of the RF amplitude effects.     

Microwave and RF surface wave sustained discharges as plasma sources for plasma chemistry and plasma processing

The surface wave produced plasma belongs to a class of RF and microwave induced plasmas. It results from the propagation of an electromagnetic wave which uses the plasma column it sustains and the plasma tube as its sole propagating media. This type of plasma offers several advantages compared to the positive column plasma of dc discharges or to other RF and microwave produced plasmas. Surface wave plasmas require no internal electrodes, and they can be applied over an extremely broad range of wave frequencies (27 MHz to 10 GHz demonstrated) and gas pressures (about 10^–4 Torr to a few times the atmospheric pressures). Using the surface wave plasma technique, a large variety of plasma column diameters have been created (0.5–150 mm demonstrated) and no limitation on plasma column length (column up to 6 m long demonstrated) has been found. The surface wave produced plasma is used in elemental analysis and to sustain emission in lasing media. This article is intended as a guide for potential users of surface wave plasmas in the field of plasma processing and plasma chemistry.