Temperature-Dependent Surface-Enrichment Effects of Imidazolium-Based Ionic Liquids

We present the first systematic study of the influence of temperature on the degree of surface enrichment of 1-alkyl-3-methylimidazolium-based ionic liquids (ILs). Using angle-resolved X-ray photoelectron spectroscopy, we demonstrate that the degree of surface enrichment strongly decreases with increasing temperature for all the studied ILs. For ILs with the same cation, but different anions, [C₈C₁Im]Br, [C₈C₁Im][TfO] and [C₈C₁Im][Tf₂N], no significant differences of the temperature-induced partial loss of surface enrichment are found. Measurements for [C₄C₁Im][TfO], [C₈C₁Im][TfO] and [C₁₈C₁Im][TfO] indicate a small effect of the chain length. For [C₁₈C₁Im][TfO], a continuous decrease of alkyl surface enrichment is found with increasing temperature, with no abrupt changes at the phase-transition temperature from the smectic A to the isotropic phase, indicating that the surface enrichment is not affected by this phase transition.     

试验优化设计Er3+-Yb3+共掺杂Gd2Ti2O7上转换发光特性

采用溶胶-凝胶（Sol-gel）法制备了Er³⁺-Yb³⁺共掺杂Gd₂Ti₂O₇纳米晶粉末,通过试验优化设计的理论建立了Er³⁺-Yb³⁺掺杂浓度与发光强度的回归方程,利用遗传算法优化计算出方程的最优解Er³⁺、Yb³⁺掺杂浓度分别为5.60%（物质的量分数）和13.43%。Er³⁺-Yb³⁺共掺杂Gd₂Ti₂O₇纳米晶粉末为单一面心立方Gd₂Ti₂O₇相结构,随Yb³⁺共掺杂浓度增加,X射线衍射峰逐渐向高角偏移。在976 nm激光激发下,Er³⁺-Yb³⁺共掺杂Gd₂Ti₂O₇获得了分别对应于Er³⁺的²H_11/2/⁴S_3/2→⁴I_15/2和⁴F_9/2→⁴I_15/2跃迁的绿色和红色上转换发光,且绿色和红色发光均为双光子吸收过程。研究了最优样品上转换发光与温度之间的关系,发现绿色上转换发光具有优良的温度传感特性,对红色上转换发光的温度猝灭进行了解释。     

(Pr0.9La0.1)2(Ni0.74Cu0.21Ga0.05)O4+δ-Ce0.9Gd0.1O2-δ复合阴极的制备及电化学性质

采用EDTA-柠檬酸盐法制备了（Pr_0.9La_0.1）₂（Ni_0.74Cu_0.21Ga_0.05）O_4+δ（PLNCG）,并与Ce_0.9Gd_0.1O_2-δ（CGO）形成复合阴极PLNCG-CGO。XRD和SEM分析结果表明PLNCG与CGO在1 000℃具有较好的化学相容性。电化学阻抗测试结果表明PLNCG-30% CGO复合阴极在700℃的极化电阻为0.092 Ω·cm²;过电位为39.3 mV时,电流密度达到113.3 mA·cm^-2。氧分压分析表明电极反应的速率控制步骤为电荷转移过程。阳极支撑单电池（Ni-CGO/CGO/PLNCG-30% CGO）在700℃的最大输出功率密度达到569 mW·cm^-2,开路电压（OCV）为0.76 V。综上结果预示PLNCG-30% CGO复合阴极是一种有发展前景的电极材料。     

退火温度对TiO2/CdSe纳米片异质结薄膜光电性能的影响

采用水热法在FTO上制备（001）高活性晶面主导的TiO₂纳米片薄膜,利用循环伏安法在TiO₂纳米片薄膜上沉积CdSe颗粒,制备了TiO₂/CdSe纳米片异质结薄膜。分别在150、250、350、450 ℃,氩气保护气氛中对样品进行退火。利用X射线衍射仪（XRD）、场发射扫描电镜（FESEM）、X射线光电子能谱分析仪（XPS）、紫外-可见（UV-Vis）分光光度计以及电化学工作站对不同温度退火后的TiO₂/CdSe纳米片异质结薄膜的微观形貌、晶体结构、光电化学性能进行表征和测试。结果表明：六方相CdSe纳米颗粒均匀包覆在TiO₂纳米片表面,直径30 nm左右;随着退火温度的升高CdSe纳米颗粒长大,形成光滑的CdSe薄膜,且晶化程度提高;TiO₂纳米片表面的Se元素与Cd元素发生氧化;TiO₂/CdSe纳米片异质结薄膜对可见光的吸收光谱发生红移,禁带宽度逐渐减小。光电化学性能测试表明随着退火温度的升高,TiO₂/CdSe纳米片异质结薄膜的光电流密度显著提高,开路电压减小,但由于SeO2和CdO的出现,导致填充因子减小,影响光电转换效率的提高。在本实验条件下,TiO₂/CdSe纳米片异质结薄膜的最佳退火温度为150 ℃,填充因子为0.77,光电转换效率达到3.12%。     

重度原油注空气低温氧化过程研究(英文)

低温氧化反应对现场燃烧(ISC)技术点火的成功有十分重要的影响.采用高压氧化管,研究了不同温度压力下,新疆克拉玛依重度原油的低温氧化过程.结果表明,温度和压力的变化对低温氧化反应的放热程度、持续时间以及气体产物有明显影响.适合油样低温氧化反应的温度和压力分别为150℃和10MPa.此外,采用纯组分替代原油族组分进行低温氧化实验,研究低温氧化反应对原油族组分(饱和烃、芳香烃、胶质、沥青质)含量的影响.结果表明,原油所含族组分中,芳香烃组分最易被氧化,其含量由氧化前的19.17%减少到12.38%(150℃)和9.51%(250℃).随着低温氧化过程的进行,结构复杂的族组分(胶质、沥青质)的含量明显增加.实验数据对油藏实施注空气技术,以及该技术现场实施条件的确定有十分重要的指导意义.     

Helical Biphenyl Bisazo Polyurethane: Preparation,Characterization and Analysis of Polymeric Thermo-Optic Switch

The bisazo chromophore molecule (CAAPM) and helical biphenyl bisazo polyurethane (HBBPU) were synthesized. The structures of CAAPM and HBBPU were characterized by FT-IR and UV-vis spectroscopic techniques. The measurements of refractive index and thermo-optic coefficient (dn/dT) of HBBPU were demonstrated at different wavelengths and different temperatures by the ATR technique. By using CCD digital imaging devices, transmission loss of the internal waveguide was measured. The refractive index dispersions and Sellmeyer coefficients of HBBPU were obtained by the Sellmeyer equation. A Y-branched switch based on the thermo-optic effect was proposed and the performance of the switch was simulated. With a branching angle of 0.143° and the FD-BPM method, the result showed that the power consumption of the thermo-optic switch could be only 3.6 mW, and the response time of the switch could reach about 8 ms. This is a significant improvement in reducing power consumption compared with the normal Y-branched polymer thermo-optic switch.     

Synthesis,isolation and characterization of methyl levulinate from cellulose catalyzed by extremely low concentration acid

A direct synthesis of methyl levulinate from cellulose alcoholysis in methanol medium under mild condition (180–210 °C) catalyzed by extremely low concentration sulfuric acid (≤0.01 mol/L) and the product isolation were developed in this study. Effects of different process variables towards the catalytic performance were performed as a function of reaction time. The results indicated that sulfuric acid concentration, temperature and initial cellulose concentration had significant effects on the synthesis of methyl levulinate. An optimized yield of around 50% was achieved at 210 °C for 120 min with sulfuric acid concentration of 0.01 mol/L and initial cellulose concentration below 100 g/L. The resulting product mixture was isolated by a distillation technique that combines an atmospheric distillation with a vacuum distillation where n-dodecane was added to help distill the heavy fraction. The light fraction including mainly methanol could be reused as the reaction medium without any substantial change in the yield of methyl levulinate. The chemical composition and structural of lower heavy fraction were characterized by GC/MS, FTIR, ¹H-NMR and ¹³C-NMR techniques. Methyl levulinate was found to be a major ingredient of lower heavy fraction with the content over 96%. This pathway is efficient, environmentally benign and economical for the production of pure levulinate esters from cellulose.     

Flow injection analysis simulations and diffusion coefficient determination by stochastic and deterministic optimization methods

Stochastic and deterministic simulations of dispersion in cylindrical channels on the Poiseuille flow have been presented. The random walk (stochastic) and the uniform dispersion (deterministic) models have been used for computations of flow injection analysis responses. These methods coupled with the genetic algorithm and the Levenberg–Marquardt optimization methods, respectively, have been applied for determination of diffusion coefficients. The diffusion coefficients of fluorescein sodium, potassium hexacyanoferrate and potassium dichromate have been determined by means of the presented methods and FIA responses that are available in literature. The best-fit results agree with each other and with experimental data thus validating both presented approaches.     

Ultra high performance liquid chromatography-quadrupole-time of flight analysis for the identification and the determination of resveratrol and its metabolites in mouse plasma

Resveratrol is a polyphenol that has numerous interesting biological properties, but, per os, it is quickly metabolized. Some of its metabolites are more concentrated than resveratrol, may have greater biological activities, and may act as a kind of store for resveratrol. Thus, to understand the biological impact of resveratrol on a physiological system, it is crucial to simultaneously analyze resveratrol and its metabolites in plasma. This study presents an analytical method based on UHPLC-Q-TOF mass spectrometry for the quantification of resveratrol and of its most common hydrophilic metabolites. The use of ¹³C- and D-labeled standards specific to each molecule led to a linear calibration curve on a larger concentration range than described previously. The use of high resolution mass spectrometry in the full scan mode enabled simultaneous identification and quantification of some hydrophilic metabolites not previously described in mice. In addition, UHPLC separation, allowing run times lower than 10 min, can be used in studies that requiring analysis of many samples.     

High sensitivity chemiluminescence enzyme immunoassay for detecting staphylococcal enterotoxin A in multi-matrices

In this study, detection of staphylococcal enterotoxin A (SEA) in multi-matrices using a highly sensitive and specific microplate chemiluminescence enzyme immunoassay (CLEIA) has been established. A pair of monoclonal antibodies (mAbs) was selected from 37 anti-SEA mAbs by pairwise analysis, and the experimental conditions of the CLEIA were optimized. This CLEIA exhibited high performance with a wide dynamic range from 6.4 pg mL⁻¹ to 1600 pg mL⁻¹, and the measured low limit of detection (LOD) was 3.2 pg mL⁻¹. No cross-reactivity was observed when this method was applied to test SEB, SEC1, and SED. It has also been successfully applied for analyzing SEA in a variety of environmental, biological, and clinical matrices, such as sewage, tap water, river water, roast beef, peanut butter, cured ham, 10% nonfat dry milk, milk, orange juice, human urine, and serum. Thus, the highly sensitive and SEA-specific CLEIA should make it attractive for quantifying SEA in public health and diagnosis in near future.