OFDM技术及其应用

首先对OFDM的发展以及应用做了简要的介绍,然后讨论了当前OFDM研究过程中的两个关键技术问题,最后展望了OFDM的未来发展。     

应变Si1-xGex层中p型杂质电离常温和低温特性

本文采用解析的方法计算了应变Si1-xGex层中p型杂质电离度与Ge组分x、温度T以及掺杂浓度N的关系.发现常温时,在同一Ge组分下,随着掺杂浓度的升高,杂质的电离度的先变小,而后又迅速上升到1.在同一掺杂浓度下,轻掺杂时,杂质的电离度随Ge组分的增加先变大,而后几乎不变;重掺杂时,杂质电离能变为0后,杂质电离度为1.低温下,轻掺杂时,载流子低温冻析效应较为明显,杂质的电离度普遍较小,当掺杂浓度大于Mott转换点时,载流子冻析效应不再明显,电离率迅速上升到1.在同一Ge组分下,随着掺杂浓度的升高,杂质的电离度先变小,后变大,而后又迅速上升到1.在同一掺杂浓度下,轻掺杂时,杂质的电离度随Ge组分的增加变大;重掺杂时,杂质电离能变为0后,杂质电离度为1.     

现代热力学的完整分类系统--非平衡非耗散热力学新领域

在同一体系中同时有多个不可逆过程时，不可逆过程之间会有相互影响，原来的非自发过程有可能在其他自发过程的影响下得以进行，这种现象就称为热力学耦合或反应耦合，长期以来，经典热力学把热力学第二定律的等式作为平衡体系的充分必要条件，其中隐含了一个前提性的假定，即经典热力学的对象只限于非耦合的体系，摈弃这一隐含的前提性假定以后，热力学自身就发展成为一个现代热力学的完整学术体系，适用于任何宏观体系（包括极其复杂的生命体系），现代热力学的完整学术体系中包含了一个崭新的非平衡非耗散热力学新领域，由于该领域属于热力学第二定律的等式部分，因此可以定量计算，并得到一系列理论计算的非平衡相图，与文献上报道的激尖低压金刚石合成等的大量实验数据相符。     

轴快流CO2激光器气体压力控制

激光切割对激光功率模式、功率密度和功率稳定性要求很高,采用轴快流CO2激光器时,控制工作气体压力工作在最佳状态并保持其恒定是激光器输出连续、稳定功率的必要条件和关键技术之一。在深入研究激光器工作原理和影响激光输出功率因素的基础上,采用带积分分离的智能PID控制算法对工作气体压力进行调节。该过程控制算法简单实用,可以有效地提高气体压力控制精度,改善功率控制精度和稳定性,并用实验加以验证。     

Assessment of thermal expansion coefficient of methylsilsesquioxane thin film

For the methylsilsesquioxane film whose optical birefringence is almost zero, it was recently reported that its vertical thermal expansion coefficient (CTE) was approximately one order of magnitude larger than the lateral CTE. Though the birefringence is not an absolute predictor of anisotropic behavior, the discrepancy in both the CTEs was so remarkable that it was essential to investigate whether the anisotropy was intrinsic property or not. If the effect of Poisson's ratio is considered in the calculation of the vertical CTE and when elastic modulus measured by surface acoustic wave spectroscopy is used in the assessment of the lateral CTE, both the CTEs are coincident with each other. Therefore, it can be concluded that the discrepancy in the CTEs can be attributed to a higher in‐plane polymer chain orientation but it can also arise from the misleadingly assumed modulus and Poisson's ratio. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 3109–3120, 2006     

Asymptotic analysis of elastic curved rods

We consider a sequence of curved rods which consist of isotropic material and which are clamped on the lower base or on both bases. We study the asymptotic behaviour of the stress tensor and displacement under the assumptions of linearized elasticity when the cross‐sectional diameter of the rods tends to zero and the body force is given in the particular form. The analysis covers the case of a non‐smooth limit line of centroids. We show how the body force and the choice of the approximating curved rods can affect the strong convergence and the limit form of the stress tensor for the curved rods clamped on both bases. Copyright © 2006 John Wiley & Sons, Ltd.     

用于频率合成器的低损耗声表面波滤波器

简述了产生声表面波滤波器插入损耗的主要机理和获得低损耗的原则；介绍了根据此原则对１００～５００ＭＨｚ５种滤波器的研制过程和结果。实验表明，采用镜像阻抗连接换能器结构可达到３～４ｄＢ的低损耗，并成功地应用于频率合成器中。     

微波BJT超宽带低噪声放大器的设计

本文给出了一种频带覆盖达１０－１６００ＭＨｚ的微波ＢＪＴ超宽带低噪声放大器的设计方法，从微波ＢＪＴ的噪声模型出发，通过拟合５０Ω源阻抗下微波ＢＪＴ的噪声系数ＮＦ５０和Ｓ参数来提取其噪声参数，然后根据增益，噪声及驻波比要求优化设计放大器，使放大器在超宽带范围内获得平坦增益和低噪声，本文所给出的微波ＢＪＴ惨数提取及放大器优化设计方法已由实验结果所验证。     

A 24-GHz Patch Array with a Power Amplifier/Low-Noise Amplifier MMIC

This paper presents an active patch array designed at 24 GHz. It can be used as a front-end component for a phased array. A series resonant array structure is chosen which is compact and easy excite. With 5 elements, the array proved a 12-dB antenna gain. A power amplifier and a low noise amplifier are designed on a single GaAs chip (PALNA). Bias switch is used in the PALNA, which greatly reduces the switch loss in a transceiver and increases the efficiency. 20-dB small signal gain is achieved in both power amplifier and low noise amplifier. The active patch array is built by the combination of the patch array and PALNA. The measured active gain of this antenna is 35-dB for the PA mode and 31-dB for the LNA mode. This active patch array can obtain an EIRP of 34 dBm with a total radiated power of 22dBm and a maximum PAE of 32%. To check the noise performance, we applied sources at both normal temperature and 77K (liquid nitrogen) and extracted the noise figure (3.5 dB) of the active antenna by the Y factor method. The results proved that the active antenna is working efficiently as both a transmitting and receiving antenna.     

群时延精确设计的全差分四阶Bessel滤波器

采用MOS管有源电阻,提出了一种全差分R-MOSFET-C四阶Bessel有源低通滤波器,.通过调节工作于亚阈值区的CMOS管的沟道导纳补偿电阻值的大小,能抵消集成电路制造工艺中电阻值的一致偏差,实现Bessel有源滤波器群时延的精确设计.根据无源滤波器的状态方程完成有源滤波器的综合,应用3.3V,0.5μm CMOS工艺完成了群时延大小为0.75μs的四阶Bessel低通滤波器的管极计算机仿真,仿真结果表明所提电路正确有效,适于全集成.