The measurement of subcritical electroconvection

Under idealized conditions, electroconvection in a nematic liquid crystal sets in at a well-defined threshold of the driving ac voltage. Fluctuating convection rolls of a small amplitude below that threshold have been observed recently. The measurement of the amplitude of these fluctuations is described in detail in this paper. It is based on averaging the light intensity signals using the structure function and a quantitative analysis of the light deflection.     

DDS+PLL系统的频谱分析

简要介绍了 ＤＤＳ＋ＰＬＬ频率合成的原理，分析了在 ＤＤＳ没有相位截断误差时，ＤＤＳ＋ＰＬＬ输出信号的杂散抑制度，并讨论了杂散抑制度与环路参数的关系。     

Case-study evaluations of the acoustical designs of renovated university classrooms

The acoustical characteristics of 14 university classrooms at the University of British Columbia were measured before and after renovation—seven of these are discussed in detail here. From these measurements, and theoretical considerations, values of quantities used to assess each classroom configuration were predicted, and used to evaluate renovation quality. Information on each renovation was determined with the help of the university campus-planning office and/or the project acoustical consultant. These were related to the evaluation results in order to determine the relationship between design and acoustical quality. The criteria focused on the quality of verbal communication in the classrooms. Room-average Speech Intelligibility (SI) and its physical correlate, Speech Transmission Index (STI), were used to quantify verbal-communication quality. A simplified STI-calculation procedure was applied. The results indicate that some renovations were beneficial, others were not. Verbal-communication quality varied from ‘poor’ to ‘good’. The effect of a renovation depends on a complex interplay between changes in the reverberation and changes in the signal-to-noise level difference, as affected by sound absorption and the source outputs. Renovations which reduce noise are beneficial unless signal-to-noise level differences remain optimal. Renovations often put too much emphasis on adding sound absorption to control reverberation, at the expense of lower speech levels, particularly at the backs of classrooms. The absorption and noise contributed by room occupants has apparently often been neglected.     

冲击噪声背景下的近场源二维参数估计方法

本文针对背景噪声为冲击噪声的情况,提出了一种新的近场源二维参数估计方法.本方法利用协变异(或协变异系数)构造矩阵,并通过求根的方法估计近场源的方向角和距离参数.该算法可以抑制冲击噪声对估计性能的影响,同时具有无需谱峰搜索的优点.仿真实验证明了该算法的有效性.     

From Long Infrared to Very Long Infrared Wavelength Focal Plane Arrays Made with HgCdTe n + n ?/ p Ion Implantation Technology

This paper aims at studying the feasibility of very long infrared wavelength (VLWIR) (12–18 μm) focal plane arrays using n-on-p planar ion-implanted technology. To explore and analyze the feasibility of such VLWIR detectors, a set of four Cd _x Hg_1−x Te LPE layers with an 18 μ cutoff at 50 K has been processed at Defir (LETI/LIR–Sofradir joint laboratory), using both our “standard” n-on-p process and our improved low dark current process. Several 320 × 256 arrays, 30-μm pitch, have been hybridized on standard Sofradir readout circuits and tested. Small dimension test arrays characterization is also presented. Measured photonic currents with a 20°C black body suggest an internal quantum efficiency above 50%. Typical I(V) curves and thermal evolution of the saturation current are discussed, showing that standard photodiodes remain diffusion limited at low biases for temperatures down to 30 K. Moreover, the dark current gain brought by the improved process is clearly visible for temperatures higher than 40 K. Noise measurements are also discussed showing that a very large majority of detectors appeared background limited under usual illumination and biases. In our opinion, such results demonstrate the feasibility of high-performance complex focal plane arrays in the VLWIR range at medium term.     

行波管放大器相位噪声的分析及其抑制

主要分析规则调相信号对行波管放大器频谱纯度的影响,并且根据行波管放大器相位噪声产生的过程和原因,提出两种抑制相位噪声的方法.     

32位MIPS微处理器中乘法器的设计和实现

在Booth算法的基础上,结合MIPS 4KC微处理器中的流水线结构和乘法器的工作过程,提出了一种改进的Booth乘法器的设计方法,并采用全制定方法实现,用这种方法实现的乘法器单元具有面积小、单元电路可重复性好、版图设计工作量小、功耗低等特点.     

SoC低功耗设计中的DVS技术

随着系统芯片(SoC)集成更多的功能并采用更先进的工艺,它所面临的高性能与低功耗的矛盾越来越突出.动态电压调整(DVS)技术可以在不影响处理器性能的前提下,通过性能预测软件根据处理器的繁忙程度调整处理器的工作电压和工作频率,达到降低芯片功耗的目的.文中讨论了DVS技术降低功耗的可能性,介绍了如何利用两种不同的DVS技术让处理器根据当前的工作负荷运行在不同的性能水平上,以节省不必要的功耗.     

320×240 Pixels CMOS Digital Image Sensor with Wide Dynamic Range

A 320×240 CMOS image sensor is demonstrated,which is implemented by a standard 0.6 μm 2P2M CMOS process.For reducing the chip area,each 2×2-pixel block shares a sample/hold circuit,analog-to-digital converter and 1-b memory.The 2×2 pixel pitch has an area of 40 μm×40 μm and the fill factor is about 16%.While operating at a low frame rate,the sensor dissipates a very low power by power-management circuit making pixel-level comparators in an idle state.A digital correlated double sampling,which eliminates fixed pattern noise,improves SNR of the sensor, and multiple sampling operations make the sensor have a wide dynamic range.     

一种低功耗Cache设计技术的研究

低功耗、高性能的cache系统设计是嵌入式DSP芯片设计的关键。本文在多媒体处理DSP芯片MD32的设计实践中，提出一种利用读／写缓冲器作为零级cache，减少对数据、指令cache的读／写次数，由于缓冲器读取功耗远远小于片上cache，从而减小cache相关功耗的方法。通过多种多媒体处理测试程序的验证，该技术可减少对指令cache或者数据cache20％～40％的读取次数，以较小芯片面积的增加换取了较大的功耗降低。