量子点器件的三端电测量研究

利用三端电测量方法，研究了调制掺杂二维电子气结构的量子点器件输运特性.报道了可分别测量二维电子气电阻和量子点隧穿电阻的实验方法.实验结果表明：量子点的横向耦合控制了量子点器件在小偏压下的电输运特性. 关键词： 自组装量子点 二维电子气 量子隧穿 肖特基接触     

微型生化分析仪样品室温度控制系统研究

结合微型生化分析仪样品室的要求,设计了一种基于单片机的微型生化分析仪样品室温度控制系统.它以AT89S51为核心,采用单总线高精度数字温度传感器DS18B20对样品室温度采样,同时利用汇编语言编写温度设定与控制程序,采用半导体制冷的方式,实现了温度在25℃、30℃、32℃和37℃四个温度值的稳定,控制精度达±0.5℃.     

From Long Infrared to Very Long Infrared Wavelength Focal Plane Arrays Made with HgCdTe n + n ?/ p Ion Implantation Technology

This paper aims at studying the feasibility of very long infrared wavelength (VLWIR) (12–18 μm) focal plane arrays using n-on-p planar ion-implanted technology. To explore and analyze the feasibility of such VLWIR detectors, a set of four Cd _x Hg_1−x Te LPE layers with an 18 μ cutoff at 50 K has been processed at Defir (LETI/LIR–Sofradir joint laboratory), using both our “standard” n-on-p process and our improved low dark current process. Several 320 × 256 arrays, 30-μm pitch, have been hybridized on standard Sofradir readout circuits and tested. Small dimension test arrays characterization is also presented. Measured photonic currents with a 20°C black body suggest an internal quantum efficiency above 50%. Typical I(V) curves and thermal evolution of the saturation current are discussed, showing that standard photodiodes remain diffusion limited at low biases for temperatures down to 30 K. Moreover, the dark current gain brought by the improved process is clearly visible for temperatures higher than 40 K. Noise measurements are also discussed showing that a very large majority of detectors appeared background limited under usual illumination and biases. In our opinion, such results demonstrate the feasibility of high-performance complex focal plane arrays in the VLWIR range at medium term.     

Fiber-Optic Chemical Sensor for Detection of NO2 Using Poly (3-Octylthiophene)

A fiber-optic chemical sensor (FOCS) for detection of nitrogen dioxide (NO₂) molecules is reported. The FOCS presents an optropode structure because of the transmission properties of the sensitive material. The NO₂ FOCS is activated by using the semiconductor polymer: regioregular head-to-tail poly(3-octylthiophene-2,5-diyl). The operation wavelength of the sensor is 543.5 nm such that a simple LED and detector can be used for the design of this device. The sensor response decreases after each exposure, demonstrating the reduction in sensitivity as well as irreversibility lower than 5%. However, its properties such as rapid response, high selectivity, high sensitivity (0.43 ± 0.01 muW/ppm), hygroscopic properties, and its operation at room temperature make this kind of FOCS a good alternative for NO₂ toxic gas detection.     

Single to 16-Channel Wavelength Conversion at 10 Gb/s Based on Cross-Gain Modulation of ASE Spectrum in SOA

A simple scheme for single to multi-channel wavelength conversion based on cross-gain modulation of amplified spontaneous emission (ASE) spectrum in semiconductor optical amplifier (SOA) is described. Single to 16-channel wavelength conversion at 10 Gb/s is first demonstrated without any additional probe lights, the modulation information carried by input signal could be converted into arbitrary many channels if only the demultiplexer with enough channels is exploited. Output performance and pattern effects are investigated experimentally.     

32位MIPS微处理器中乘法器的设计和实现

在Booth算法的基础上,结合MIPS 4KC微处理器中的流水线结构和乘法器的工作过程,提出了一种改进的Booth乘法器的设计方法,并采用全制定方法实现,用这种方法实现的乘法器单元具有面积小、单元电路可重复性好、版图设计工作量小、功耗低等特点.     

SoC低功耗设计中的DVS技术

随着系统芯片(SoC)集成更多的功能并采用更先进的工艺,它所面临的高性能与低功耗的矛盾越来越突出.动态电压调整(DVS)技术可以在不影响处理器性能的前提下,通过性能预测软件根据处理器的繁忙程度调整处理器的工作电压和工作频率,达到降低芯片功耗的目的.文中讨论了DVS技术降低功耗的可能性,介绍了如何利用两种不同的DVS技术让处理器根据当前的工作负荷运行在不同的性能水平上,以节省不必要的功耗.     

InP基应变补偿结构偏振不灵敏半导体光放大器制作的研究

为了制备偏振不灵敏的半导体光放大器(SOA)，将有源区设计为由4个压应变、3个张应变阱层及晶格匹配的垒层InGaAsP交替组合而成的应变补偿结构。器件做成带有倾角的扇形脊形波导结构，避免了常规制作SOA的复杂工艺。对样品3在80～125mA电流范围内，获得了偏振灵敏度≤0．6dB．最小可达0．1dB；较大的电流范围内FWHM值为40nm。     

一种低功耗Cache设计技术的研究

低功耗、高性能的cache系统设计是嵌入式DSP芯片设计的关键。本文在多媒体处理DSP芯片MD32的设计实践中，提出一种利用读／写缓冲器作为零级cache，减少对数据、指令cache的读／写次数，由于缓冲器读取功耗远远小于片上cache，从而减小cache相关功耗的方法。通过多种多媒体处理测试程序的验证，该技术可减少对指令cache或者数据cache20％～40％的读取次数，以较小芯片面积的增加换取了较大的功耗降低。     

BEPCII直线加速器相控系统设计研究

为了补偿由于各种因素引起的微波相位漂移,BEPCII直线加速器需要建立微波相位反馈控制系统.能量最大法将用来确定每台功率源的最佳相位.沿直线加速器速调管长廊铺设相位稳定同轴线提供相位参考.现在已经完成了关键部件,如PAD单元、IfA 单元的开发.搭建了相控最小系统对系统进行了验证.