固溶体结构对Ca_(2-x)Sr_xZn_4Ti_(15)O_(36)∶Pr~(3+)发光性质的影响

0引言在绿色和蓝色长余辉发光材料达到应用程度之后,耐候性红色长余辉发光材料成为人们研究的重点。Eu3 、Sm3 激活的硫氧化物[1￣3]、Eu2 铝锶复合硫氧化物[4]和Y2O3∶Eu3 [5]等耐热耐水性红色长余辉材料被相继发现。Pr3 离子掺杂的碱土金属钛酸盐(M TiO3∶Pr,M=M g,Ca,Sr,Ba)是一种新型的红色长余辉发光材料。这种发光材料在615nm附近有很好的单色性红光发射。碱土金属钛酸盐基质化学性能稳定,已开始应用于场发射显示器(FE D)[6,7]。碱土金属钛酸盐是A BO3型化合物,具有钙钛矿结构。B all[8]曾通过在CaTiO3中掺入不同量的Sr2 …     

制备方法对MoO_3／ZrO_2结构的影响及MoO_3／ZrO_2固体超强酸的结构特征 Ⅰ．ZrO_2的形态与样品比表面的研究

ＸＲＤ，ＤＴＡ，比表面测定等结果表明，制备方法对ＭｏＯ３／ＺｒＯ２结构有决定性影响．仲钼酸铵浸渍仅经干燥的Ｚｒ（ＯＨ）４再经高温焙烧所得团体超强酸ＭｏＯ３／ＺｒＯ２（Ⅰ）与浸渍晶态ＺｒＯ２所得部分氧化催化剂ＭｏＯ３／ＺｒＯ２（Ⅱ）的载体形态有明显不同．（１）ＭｏＯ３／ＺｒＯ２（Ⅰ）的比表面数倍于ＭｏＯ３／ＺｒＯ２（Ⅱ）；（２）ＭｏＯ３含量增加时，ＭｏＯ３／ＺｒＯ２（Ⅰ）的比表面逐步增大至一极大值再缓缓下降，而ＭｏＯ３／ＺｒＯ２（Ⅱ）的比表面随ＭｏＯ３含量增加而单调下降；（３）在ＭｏＯ３／ＺｒＯ２（Ⅰ）中，ＺｒＯ２以介稳四方相存在，而在ＭｏＯ３／ＺｒＯ２（Ⅱ）中则是稳定的单斜相．在此基础上研究了事先引入的活性组分在载体织构形成过程中的作用，包括延迟ＺｒＯ２晶化，阻碍晶粒长大及与之相关的相变等，并讨论了ＭｏＯ３／ＺｒＯ２（Ⅰ）中ＭｏＯ３最佳含量的科学含义．     

New Type High Efficient Quasi-Solid-State Ionic Liquid Electrolyte for Dye-Sensitized Solar Cells

For the fist time the preparation of a mostly solid-state high efficiem electro-conductive material comprising 1-methyl-3-propylimidazolium iodide （MPII）, benzimidazole （BI）, iodine and lithium iodide was reported. In this electrolyte, BI acts as not only additives but also gelators. With its significant electrochemical properties, an overall efficiency of 3.07% was achieved under AM 1.5 （100 mW/cm^2）.     

垃圾在流化床中焚烧NO排放特性研究

在Ф150 mm流化床上，研究了六类典型组分垃圾NO转化率与床温和过量空气系数(excess air简称EA)的关系。研究发现，纸渣与木块NO转化率最高，橡胶与塑料最低;织物、纸张、厨余、木块、塑料NO均具有中温生成特性，一般在800 ℃～850 ℃时即接近最大值，之后温度升高对NO的生成影响不大;橡胶与无烟煤由于含N化合物结构稳定，其NO转化率随床温升高而增大;由于挥发分析出的相互影响，较低的火焰温度，混合垃圾NO转化率一般低于单组分垃圾的线性叠加;少量水分不会对垃圾NO转化率造成很大影响，相反还会促进NO的转化，但过量水分会抑制NO的生成。     

Characterization of Heterogeneous Catalysts by use of Test Reactions

The following report gives an overview on work done in the Catalysis Laboratory of the Department of Chemistry, National University of Singapore over the last 15 years (1989–2004). Much of this work can be described as “characterization of catalytically active surfaces through test reactions”. The methods, systems studied and the reactions that we evaluated will be described. The review will mostly concentrate on work from the authors’ laboratory, but other relevant work will also be cited.     

熔融反应合成2,2′-联吡啶桥联二（4,4′-联吡啶）类哑铃型化合物

无溶剂反应;联吡啶;固相熔融;哑铃型化合物     

Nonisothermal Kinetics of Sub‐Solidus Phase Transitions in C10Zn,C16Zn and Their Binary System

Nonisothermal kinetics of the solid‐solid phase transition in (n‐C₁₀H₂₁NH₃)₂ZnCl₄(C₁₀Zn), (n‐C₁₆H₃₃NH₃)₂ZnCl₄(C₁₆Zn) and their binary system were determined by Kissinger and Ozawa methods from DSC measurements. The activation energy E_a of the binary system shows a waving dependence on W_C10Zn%, which is caused by not only an intermediate (C₁₀H₂₁NH₃)(n‐C₁₆H₃₃NH₃)ZnCl₄ but also three solid solution ranges (α, β, γ) in the phase diagram of C₁₀Zn‐C₁₆Zn. The variations of the layer d‐spacing are also convenient for the above result.     

Room Temperature Solid State Reaction Involving Structural Transformation of Covalent Oxide Network

An interesting structural transformation from a two dimensional (2d) covalent oxide network with a layered structure to a three-dimensional (3d) network with a tunnel structure was found at room temperature in the mixture of hydrated alkali-metal molybdenum bronze and amorphous alkali-metal molybdate. From various experimental results it was concluded that the transformation was due to a room temperature solid state reaction.     

From solution-phase to solid-phase enyne metathesis: crossover in the relative performance of two commonly used ruthenium pre-catalysts

A crossover in the ability of two distinct ruthenium-based metathesis pre-catalysts to effect the synthesis of dialkenylboronic esters in solution and on the solid-phase was observed. Specifically, while the Grubbs 2nd generation pre-catalyst 3 affords a greater degree of conversion to product than the Hoveyda-Grubbs pre-catalyst 2 in a solution-phase enyne-metathesis reaction, this trend is reversed in the solid-phase variant. Systematic investigation showed this trend to be general, regardless of variations in the homoallylic alcohol and alkynylboronic ester components of the reaction, as well as in the type of solid support employed. Experiments to determine a mechanistic hypothesis for this trend highlighted the significance of the ruthenium remaining bound to the substrate after metathetic rearrangement and found the presence of phosphine ligand to be detrimental to the success of the solid-phase reaction. Therefore, these results suggest an expanded role for phosphine-free pre-catalysts, such as 2, in challenging solid-phase metathesis reactions.     

Volumetric properties of the boldine + alcohol mixtures at atmospheric pressure from 283.15 to 333.15 K: A new method for the determination of the density of pure boldine

Densities of boldine + alcohol binary mixtures were measured over the whole accessible range of boldine compositions at temperatures from 283.15 to 333.15 K using an Anton-Paar digital vibrating glass tube densimeter. The binary systems studied include, as a solvent, seven normal alcohols from n-C₁ to n-C₆, n-C₈, and isopropanol. The density of these systems has been found an increasing function of the boldine composition. A new methodology based on density data of solutions of solid solutes with normal alcohols is described in order to determine solid molar volume of pure solutes. This methodology was validated with pure solid naphthalene molar volumes data at 298.15 K, with an average uncertainty of 6%.