Low-threshold, high-efficiency, high-repetition-rate optical parametric generator based on periodically poled LiNbO3

We report a high-repetition-rate optical parametric generator (OPG) with a periodically poled lithium niobate (PPLN) crystal pumped by an acousto-optically Q-switched CW-diode-end-pumped Nd:YVO_4 laser. For the maximum 1064nm pump power of 970mW, the maximum conversion efficiency is 32.9% under the conditions of 250℃, 1064nm pulse repetition rate of 22.6kHz and pulse width of 12ns, and the PPLN OPG threshold in the collinear case is less than 23.7μJ. The output power increases with the increase of the crystal temperature. The 1485－1553nm signal wave and 3383－3754nm idler wave are obtained by changing the temperature and the angle of the PPLN crystal.     

Inorganic Sol-Gel Preparation of Medium Sized Microparticles of Li2TiO3 from TiCl4 as Tritium Breeding Material for Fusion Reactors

Microspheres of Li₂TiO₃ were fabricated by a classical, inorganic sol-gel process from commercially available TiCl₄. Elaborated process consists of the following main steps: (1) dissolving of TiCl₄ in concentrated aqueous HCl and addition of LiOH; (2) formation of sol emulsion in 2-ethylhexanol-1 containing the surfactant SPAN-80 (EH); (3) gelation of emulsion drops by extraction of water with partially dehydrated EH; (4) impregnation of gel to Li:Ti molar ratio MR = 2; (5) thermal treatment at 1200°C in order to receive chloride free product. This temperature can be significantly lowered (to 750°C) by dechlorination starting solution TiCl₄ by chemical treatment of the with nitric acid to form of nitrate-stabilized titania sols. Tritium release from sol-gel made Li₂TiO₃ microspheres were found very close to that observed for other traditional materials, however for the first sample process starts slightly earlier.     

基于电压陡降的VRLA容量预测新思路

重点介绍了蓄电池电压陡降与容量之间的关系及各操作因素对电压陡降的影响。由此引出一种新的蓄电池容量预测思路,并就如何实现它进行了初步探讨,最后对该思路进行了简要的展望。     

三硼酸锂晶体的生长形态

用自由生长系统研究了三硼酸锂ＬｉＢ_３Ｏ_５（ＬＢＯ）晶体的实际生长形态。实验表明，它的各晶面簇的重要性的顺序为：｛１１０｝＞｛０１１｝＞｛２０１｝＞｛１１１｝。讨论了ＬＢＯ晶体的生长习性与内部结构之间的关系并应用负离子配位多面体理论模型解释了ＬＢＯ晶体的生长形态。     

LiCoO2中锂离子固相扩散系数随循环次数的变化

The solid diffusion coefficient of lithium-ion in LiCoO₂ cathode material has been investigated by the capacity intermittent titration technique (CITT) at different voltages and at different charge/discharge cycles. By SEM, XRD and FTIR techniques, the structure of LiCoO₂ was studied before and after charge-discharge cycles, and the relationship between solid diffusion coefficient and crystal structure was further discussed. CITT results show that the value of Li⁺ solid diffusion coefficient of LiCoO₂ is about 10^-12 cm²·s^-1. During the whole charge-discharge cycles, the Li⁺ solid diffusion coefficient decreased within the voltage of 4.0～4.3 V, which is attributed to the change of the structure of LiCoO₂.     

Donor-acceptor properties, catalytic activity, and negative charge exoemission from the alumina surface modified with lithium cations

Donor-acceptor properties of alumina modified with lithium cations were studied by ESR of paramagnetic complexes of adsorbed anthraquinone. The results were compared with the data on negative ion emission (exoemission) accompanying the decomposition of isopropyl alcohol in the adsorption layer. The data on the activity measured by the pulse microcatalytic technique in isopropyl alcohol decomposition are discussed. Small additives of lithium were found to promote catalytic activity of the samples. The role of acid and basic sites in isopropyl alcohol decomposition was discussed. Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 4, pp. 616–621, April, 2006.     

熔融浸渍法制备锂离子电池正极材料LiMn2O4的研究

采用LiNO3和MnO2为原料,在650℃下制备了尖晶石型的LiMn2O4.通过X射线衍射、扫描电子显微镜、热重分析和电化学性能测试,发现该化合物具有很高的放电比容量和较好的循环性能,首次放电比容量可达到122 mA·h/g.并对循环性能衰减的各种因素进行了讨论.     

尖晶石锂锰氧化物锂离子嵌脱过程的交流阻抗谱研究

用粉末微电极研究了尖晶石锂锰氧化物在不同嵌锂状态下嵌脱锂过程的交流阻 抗图谱，提出了新的等效电路模型。描述锂离子在固体中扩散的Warburg阻抗与累 积或消耗的嵌入电容在Lix MnO4中的x≤0．5时串联，0．5＜x≤1时并联。用提出 的等效电路模型分阶段拟合了实验所得的交流阻抗谱，拟合值与实验值相当吻合， 由拟合结果得到不同电位下锂离子在表面膜中的迁移电阻和电容，界面电荷传递电 阻，双层电容，锂离子在固体中扩散系数和累积或消耗的嵌入电容。     

泡沫铅对VRLA电池负极活性物质结构及性能影响

0引言随着36V/42V汽车电源系统的提出,新一轮汽车用电池的竞争不断加剧。从目前情况看,铅酸电池由于具有成本低廉,使用可靠,原材料来源丰富,铅回收率可高达98%等优点,因此成为电动车电源最实际的选择之一[1]。但作为电动车用电池,需要克服其比能量低、充电接受能力差和负极硫酸盐化等缺点。为此各国科学家开展了大量的研究工作。最近报道用铸造多孔体作为敞口铅酸电池的集流体,它的比表面积为14cm2·cm-3,正极活性物质利用率上升到50%,远高于传统的铸造板栅[2]。在铅酸电池集流体研究领域里另一个重大进步,就是以R V C(R etic-ulated V i…