LiF层作为空穴阻挡层的绿色OLED的光电性能研究

采用真空热蒸镀方法,制备了四种Delta掺杂结构OLED器件,其结构为：ITO/m-MTDATA（50nm）/LiF（xnm）/NPB（10nm）/Alq（5nm）/C545T（0.05nm）/Alq（55nm）/LiF（1nm）/Al,都获得了性能稳定的绿色OLED器件。从实验结果分析可知：绿色OLED器件的电流-电压（I-V）特性曲线、亮度-电压（L-V）曲线、亮度-电流（L-I）曲线及效率等光电性能随着LiF厚度的变化而随之改变。从其中总结规律,对OLED器件制作工艺有一定的指导作用。     

Transient electroluminescence determination of carrier mobility and charge trapping effects in heavily doped phosphorescent organic light-emitting diodes

Transient electroluminescence (EL) was used to measure the delay between the excitation pulse and onset of emission in OLEDs based on phosphorescent bis[3,5-bis(2-pyridyl)-1,2,4-triazolato] platinum(ΙΙ) doped into 4,4′-bis(carbazol-9-yl) triphenylamine (CBP), from which an electron mobility of 3.2 × 10⁻⁶ cm²/V s was approximated. Delayed recombination was observed after the drive pulse had been removed and based on its dependence on frequency and duty cycle, ascribed to trapping and de-trapping processes associated with disorder-induced carrier localization at the interface between the emissive layer and electron blocker. The data suggests that the exciton recombination zone is at, or close to the interface between the emissive layer and electron blocker. Despite the charge trapping effects, a peak power efficiency of 24 lm/W and peak external quantum efficiency of 10.64% were obtained. Mechanisms for the electroluminescence and delayed recombination are proposed.     

GaN发光二极管的老化数学模型及寿命测试方法

GaN发光二极管因其寿命、效率和环保等优点得到了广泛的应用。寿命问题一直是限制GaN发光二极管应用的核心问题。为了研究GaN发光二极管的老化过程,计算了GaN发光二极管物理参数,分析了GaN发光二极管的深能级缺陷和非辐射复合中心增加的老化原理,并且针对该原理的老化过程进行物理原理的分析推导,进而建立了老化数学模型。同时,利用一组实际的GaN发光二极管大应力老化实验的数据进行计算,提出了利用该数学模型的GaN发光二极管寿命的测试方法和数学计算方法,并计算出实验GaN发光二极管的寿命数值。提出的GaN发光二极管老化数学模型对比传统的阿伦纽斯模型具有针对性强、物理意义明显和寿命预测准等优点,具有很好的实际应用价值。     

白色磷光OLEDs的制备及性能研究

采用蓝色、黄色磷光混色的发光方式实现白光有机电致发光器件(OLEDS),其中黄色发光层由红色和绿色磷光材料混合而成,器件的结构为ITO/MoO3(30nm)/NPB(40nm)/mCP:FIrpic(8%)(50nm)/CBP:R-4B(1%):GIrl(14%)(xnm)/BCP(10nm)/AlQ(40nm)/LiF(1nm)/Al(100nm)(x=2,3,4,5,6nm)。对器件的效率、亮度等对比发现,当x=5nm时,器件的性能最佳,最大亮度为9 471cd/cm2,效率为23.5cd/A,色坐标(0.32,0.35)。实验表明,影响器件色稳定性和效率低的原因是电子和空穴迁移随驱动电压变化响应不一致引发激子复合区域的移动。     

基于空间电荷限制电流模型的FeCl3掺杂CBP的空穴迁移率研究

基于不同浓度FeCl3掺杂的4,4′-N,N′-二咔唑基联苯(CBP)设计制作了一系列的单空穴有机电致发光器件(OLED),采用空间电荷限制电流法估算了具有不同浓度FeCl3掺杂的CBP的空穴迁移率,并与OLED中常用的空穴传输材料N,N′-二苯基-N,N′-(1-萘基)-1,1′-联苯-4,4′-二胺(NPB)进行了比较研究。结果表明,FeCl3掺杂CBP可以极大地提高CBP薄膜的空穴迁移率,当FeCl3的浓度为12%时空穴迁移率最大,在电场强度为0.5MV/cm的条件下迁移率为4.5×10-5cm2/V·s,即使在零电场条件下迁移率依然高达2.2×10-5 cm2/V·s,近似为常用空穴传输材料NPB空穴迁移率的4倍。用CBP∶12%FeCl3做空穴传输层,制备了OLED器件,最大亮度为68468cd/m2,相对于采用NPB做空穴传输层的参比器件提高了97%,最大电流效率为31.28cd/A,比参比器件提高了23%。器件亮度和效率的提高归因于空穴传输性能的改善,使得器件中载流子的传输更为平衡,从而提高了激子形成的几率,且减少了激子-极化子之间的淬灭。     

新型Al/Mo底电极的顶发射有机发光二极管性能研究

提出了一种新型底电极结构,使用铝钼双层薄膜作为顶发射有机发光二极管的底电极。同时分别从底电极结构、顶电极结构、空穴注入以及出射光谱等方面对器件性能进行分析和优化,最终得到的器件电流效率达到6Cd/A以上,比优化前的器件效率提高了5倍以上,加强了对TEOLED器件的性能影响因素的理解。同时也比Mo作为底电极时的器件性能实现了提高,展示了此电极结构在顶发射OLED中的应用潜力,为下一步在硅基OLED显示器件中的应用打下基础。     

Efficiency enhancement in tandem organic light-emitting devices with a hybrid charge generation layer composed of BEDT-TTF-doped TPBi/mCP/HAT-CN

Tandem organic light-emitting devices (OLEDs) were fabricated with a hybrid organic charge generation layer (CGL) composed of bis(ethylenedithio)-tetrathiafulvalene (BEDT-TTF) doped 1,3,5-tris(N-phenylbenzimiazole-2-yl)benzene (TPBi), 1,3-bis(cabazol-9-yl)benzene (mCP), and 1,4,5,8,9,11-hexaazatriphenylene hexacarbonitrile (HAT-CN) in an attempt to enhance their current efficiency. While the operating voltage of the tandem OLEDs with a hybrid structure composed of BEDT-TTF-doped TPBi, mCP, and a HAT-CN CGL at 10 mA/cm² was 1 V lower than that of the tandem OLEDs with a typical CGL composed of BEDT-TTF-doped TPBi and a HAT-CN, the corresponding the current efficiency of the tandem OLEDs with a hybrid CGL at 10 mA/cm² was 2.9 cd/A higher than that of the tandem OLEDs with a typical CGL. The increase in the current efficiency and the decrease in the operating voltage of the tandem OLEDs with the hybrid CGL were attributed to enhanced electron injection due to the insertion of the mCP layer into the hybrid CGL.     

Fluorene derivatives for highly efficient non-doped single-layer blue organic light-emitting diodes

Diphenylamino- and triazole-endcapped fluorene derivatives which show a wide energy band gap, a high fluorescence quantum yield and high stability have been synthesized and characterized. Single-layer electroluminescent devices of these fluorene derivatives exhibited efficient deep blue to greenish blue emission at low driving voltage. The single-layer OLED of PhN-OF(1)-TAZ shows a maximum current efficiency of 1.54 cd/A at 20 mA cm⁻² with external quantum efficiency (EQE) of 2.0% and CIE coordinates of (0.153, 0.088) in deep blue region, while the single-layer device of oligothienylfluorene PhN-OFOT-TAZ shows a maximum brightness of 7524 cd/m² and a maximum current efficiency of 2.9 cd/A with CIE coordinates of (0.20, 0.40) in greenish blue.     

Straight forward synthesis of conjugated polymers for deep red to NIR PLED containing chlorine atoms on the backbone

High molecular weight and non-crosslinking conjugated donor–acceptor copolymers with chlorine on the backbones were straight forward synthesized for the first time under Stille condensation reaction by using the different reaction activities between chlorine and bromine atoms. The chlorine-bearing polymers exhibited much lower LUMO, larger Stokes shift and lower self-absorption compared with the non-chloride analogue, for the electron affinity and large steric hindrance of chlorine atoms. Deep red to NIR emission centered at 698 nm was obtained with brightness about 1500 cd/m² and centered at 708 nm was obtained with brightness over 400 cd/m² based on dopant/host system.     

Flexible top-emitting warm-white organic light-emitting diodes with highly luminous performances and extremely stable chromaticity

The flexible top-emitting white organic light-emitting diode (FTEWOLED) with a very high efficiency but a significant color alteration is achieved with a blue/red/blue sandwiched tri-emission-layer. The voltage-dependent recombination region alternation and the emission mechanism are systematically investigated through a delta-doping method and the time-resolved transient photoluminescence lifetime measurement. By locating the main exciton recombination region at the 4,4′,4″-Tris(carbazol-9-yl)-triphenylamine (TCTA) and 9,9-spirobifluoren-2-yl-diphenyl-phosphine oxide (SPPO1) interface, replacing the carrier-trapping red dopant guest with an orange guest that utilizes energy transfer mechanism, and using a P–I–N structure together with the FIrpic blue guest dopant to balance the electron and hole carriers, an extremely color stable and a very high efficient FTEWOLED is fabricated, with the resulting high current and power efficiencies of 22.7 cd/A and 14.27 lm/W, and a warm white illumination with a small chromaticity variation of (−0.0087, +0.0015) over a broad luminance range of more than four orders of magnitude. In addition, the performances can be further improved to 23,340 cd/m², 24.49 cd/A and 15.39 lm/W with a slight concentration alteration of the orange emitter.