激光触发多级多通道开关研究

研究了200kV激光触发多级多通道开关的运行机理,该开关在直流电压下以四倍频Nd:YAG激光器为触发源进行的实验结果表明：开关触发延迟时间及其抖动随开关电压、激光能量和充气压力上升呈指数下降趋势,对混合气体则随气体密度上升而上升。随透镜焦距的增大延迟时间及其抖动呈上升趋势。该开关实现了多通道放电。     

利用“神光-Ⅱ”激光装置多路光束叠加直接驱动下的冲击波平面性及稳定性

利用“神光-Ⅱ”的3路基频光输出及小透镜列阵束匀滑技术,通过优化设计和合理地选择光路组合,实现了多路叠加斜入射的驱动激光, 在靶材料中产生一个650~750μm范围内平面性良好的冲击波,有效地提高了“神光-Ⅱ”输出光束的利用率。同时,利用斜面靶进行的冲击稳定性实验表明,在靶面功率密度分别为3.26×1014及2.56×1014W/cm2时,冲击波至少在28.38~55.82和22.13~35.07μm的Al样品厚度内是稳定传播的。     

DF/HF化学激光器HYLTE喷管的副喷管质量流量系数

对DF/HF化学激光器HYLTE喷管的副喷管质量流量进行了数值和理论计算,得出入口滞止压力在0.01~0.4MPa之间、喉道半高度在0.1~0.9mm之间的喷管的氘气,氢气和氦气质量流量系数,总结出质量流量系数随入口滞止压力和喉道高度的变化规律,并给出拟合公式,为副喷管的设计提供依据。     

X光Gabor波带片编码成像技术实验研究

基于星光II实验装置进行了Gabor波带片编码成像探索性实验研究。采用束匀滑光斑三倍频激光打靶,辐照专门设计的ＣＨ埋金属条靶（共两种）,产生了有明确形状、边缘清晰的等离子体。研制了专门的Gabor波带片编码相机,并利用该相机采用单张胶片对不同的靶目标在不同的深度层次上曝光的技术,获得了具有深度层次信息的三维激光等离子体编码像。利用数值重建技术对实验所获得的图像解码,最终获得了在不同深度层次上的激光等离子体信息。     

An Experimental Study of a Flux Modulated Solid State Metathesis Reaction

A solid state metathesis (SSM) reaction was investigated with respect to the formation of rare‐earth carbodiimides, the role of the co‐produced salt (LiCl), and the eutectic flux medium (LiCl/KCl). A SSM reaction is characterized by an exothermic reaction in which a salt (often LiCl) is coproduced. When the salt melts, it can serve as a useful medium for the crystallization of a desired product. An improved crystal growth can be observed by using an eutectic flux. However, the composition of an eutectic LiCl/KCl flux is altered when LiCl is produced during the reaction. The thermal effects concerning the endothermic melting of the flux and the exothermic ingnition of the SSM reaction may compensate each other, which is not necessarily a drawback for the reaction to proceed.     

脉冲镀金在半导体激光器中的应用及工艺优化

为提高半导体激光器芯片的焊接成功率以及器件的性能寿命,采用脉冲电镀技术在半导体激光器芯片 P 面沉积了厚金层,详细研究了镀金液 pH 值和电流通断比对镀金层组织形貌、表面粗糙度、内应力、沉积均匀性以及粘附力的影响规律。结果表明,表面粗糙度随 pH 值的升高或通断比的提高而增大。沉积均匀性随 pH 的增大先降低后升高,而随通断比的增大而变差。pH 较大（＞10．0）或较小（＜8．5）时,镀金层粘附性均不理想。而通断比对镀金层的粘附性影响不大。不同条件下,金膜内应力均为张应力,大小为29～88 MPa。     

Study of the effect of laser treatment on the initial oxidation behaviour of Al‐coated NiCrAlY bond‐coat

In this study, the initial oxidation behaviour of laser‐treated Al/NiCrAlY bond‐coat is investigated. Two approaches, (i) Al film sputtering on the surface of bond‐coat and (ii) laser treatment, have been taken to enhance the oxidation resistance of NiCrAlY bond‐coat. Experimental results showed that after laser treatment, the Al/NiCrAlY bond‐coat exhibited a columnar dendritic microstructure without cracks and voids. A dense and continuous α‐Al₂O₃/Cr₂O₃ multilayer was found to form on the bond‐coat surface. Results on the cyclic oxidation at 1200 °C (for time ≤ 204 h) revealed that the laser‐treated Al/NiCrAlY bond‐coat exhibited better oxidation resistance compared to as‐sprayed NiCrAlY, Al/NiCrAlY and laser‐remelted NiCrAlY bond‐coat. The formation of θ‐Al₂O₃, NiO, Cr₂O₃ and NiCr₂O₄ spinel oxides was observed to be suppressed due to the preformed α‐Al₂O₃ scale during initial oxidation on the surface of laser pre‐oxidized Al/NiCrAlY bond‐coat. Copyright © 2013 John Wiley & Sons, Ltd.     

Intense laser field effects on the electron Raman scattering in a strained InGaN/GaN quantum well

The differential cross-section for an intersubband electron Raman scattering process in a strained InGaN/GaN quantum well in the presence of an intense laser field is studied. In the effective-mass approximation, the electronic structure is calculated by taking into account the effects of spontaneous and piezoelectric polarization fields on the confinement potential. Effects of laser field strength, indium composition and the well width on the differential cross-section of the strained quantum well are investigated. Results show that the position and the magnitude of the peaks of emission spectra considerably depend on the laser field strength as well as structural parameters.     

Diels-Alder reaction mechanisms of substituted chiral anthracene: A theoretical study based on the reaction force and reaction electronic flux

Quantum chemical calculations were used to study the mechanism of Diels-Alder reactions involving chiral anthracenes as dienes and a series of dienophiles. The reaction force analysis was employed to obtain a detailed scrutiny of the reaction mechanisms, it has been found that thermodynamics and kinetics of the reactions are quite consistent: the lower the activation energy, the lower the reaction energy, thus following the Bell-Evans-Polanyi principle. It has been found that activation energies are mostly due to structural rearrangements that in most cases represented more than 70% of the activation energy. Electronic activity mostly due to changes in σ and π bonding were revealed by the reaction electronic flux (REF), this property helps identify whether changes on σ or π bonding drive the reaction. Additionally, new global indexes describing the behavior of the electronic activity were introduced and then used to classify the reactions in terms of the spontaneity of their electronic activity. Local natural bond order electronic population analysis was used to check consistency with global REF through the characterization of specific changes in the electronic density that might be responsible for the activity already detected by the REF. Results show that reactions involving acetoxy lactones are driven by spontaneous electronic activity coming from bond forming/strengthening processes; in the case of maleic anhydrides and maleimides it appears that both spontaneous and non-spontaneous electronic activity are quite active in driving the reactions.     

Synthesis of Supported Heterogeneous Catalysts by Laser Ablation of Metallic Palladium in Supercritical Carbon Dioxide Medium

To obtain a supported heterogeneous catalyst, laser ablation of metallic palladium in supercritical carbon dioxide was performed in the presence of a carrier, microparticles of γ-alumina. The influence of the ablation process conditions—including supercritical fluid density, ablation, mixing time of the mixture, and laser wavelength—on the completeness and efficiency of the deposition of palladium particles on the surface of the carrier was studied. The obtained composites were investigated by scanning and transmission electron microscopy using energy dispersive spectroscopy. We found that palladium particles were nanosized and had a narrow size distribution (2–8 nm). The synthesized composites revealed high activity as catalysts in the liquid-phase hydrogenation of diphenylacetylene.