聚四氟乙烯纤维辐照接枝制备弱酸性离子交换剂及其对Cu~(2+)的吸附

以聚四氟乙烯纤维为基体通过6 0 Co辐射引发与丙烯酸接枝制备弱酸性阳离子交换纤维 .产物功能基含量为 3 0 6mmol g,在pH =5时该纤维达到对Cu2 + 的最大动态吸附量为 10 7 4 8mg g.使用不同浓度HCl对饱和吸附铜的接枝纤维进行洗脱 ,证实该纤维对铜离子具有优异的解吸性能     

Classification of cultivation area of ginseng by near infrared spectroscopy and ICP-AES

A rapid and nondestructive near infrared (NIR) method using soft independent modeling of class analogy (SIMCA) for the classification of cultivation area (Korea and China) was evaluated and confirmed. Raw, first, and second derivative NIR spectra were compared to develop a robust classification rule. The chemical properties of ginseng samples were also investigated to find out the differences between Korean samples and Chinese samples. These differences make NIR spectroscopic method viable. The average value of each Korean and Chinese ginseng sample for crude fiber, crude protein, starch, and 10 inorganic constituents were measured and compared with F-test and t-test. The inorganic constituents were also measured by induced coupled plasma-atomic emission spectroscopy (ICP-AES). It could be found that the amount of starch and ten inorganic elements for example Na, Mg, P, K, Ca, Mn, Fe, Ni, Cu and Zn in ginseng samples are considerably different based on cultivation area. SIMCA has been applied to the inorganic data to investigate the possibility of ICP-AES as classification tool. However, it was observed that the result was not equal to than NIR spectra data. The overall results showed the availability of NIR method using SIMCA would be adequate for classification of cultivation of ginseng, since NIR spectra includes useful and various information on chemical properties in spite of broad and overlapped bands.     

FFC-1离子交换纤维物理化学性能的研究

利用扫描电镜、热失重-红外、元素分析、低温氮吸附等技术和化学手段对聚羧酸基FFC-1离子交换纤维的结构与性能特点等进行了系统研究．结果表明：FFC-1离子交换纤维为含适量酰肼类交联键的聚羧酸(钠)型离子交换材料，外比表面积大和传质距离短是其反应动力学性能优异的主要原因，FFC-1纤维具有良好的化学与热稳定性。在5mol/L硫酸、硝酸、盐酸和2mol／L氢氧化钠溶液中浸泡，交换容量未见明显降低。但过氧化氢溶液对其功能基有明显破坏，CO2为FFC-1纤维在高温区间(300℃～350℃)的主要分解产物。     

γ-射线辐照对尼龙6纤维结构的影响

<正> 过去的大多数研究表明,高能射线辐照会引起聚乙烯及聚丙烯等稀烃类聚合物分子链交联及降解,而且会导致结晶度下降。张利华等人最近的研究表明,对于尼龙1010塑料,仅当辐照剂量高到一定程度后,辐照才会破坏结晶。此外,Stowe等人曾经研究过近紫外线对尼龙66纤维结构的影响,结果表明,在空气气氛中的近紫外辐照主要导致尼龙66纤维降解,并使纤维结晶度提高。有关高能射线辐照对高度取向的合成纤维结构及性能的影响的研究尚不多见。本工作将讨论γ-射线对于尼龙6纤维结构的影响。     

FFC-1离子交换纤维对酸碱有害气体吸附性能的研究

系统考察了不同直径及反离子形式的FFC-1聚羧酸离子交换纤维对酸碱有害气体的穿透吸附,各种温、湿度条件下的吸水率,以及作为有害气体吸附滤除材料的重复使用与再生性能。研究表明:FFC-1纤维直径的减小有利于提高对有害气体的动态吸附容量。在体系温度、相对湿度分别为15℃、50%时,以3D腈纶为起始原料的钠型FFC-1离子交换纤维的吸水率≥350mg/g.纤维;对SO2的穿透吸附容量可达200mg/g.纤维。FFC-1离子交换纤维具有良好的重复使用与再生能力,经20次再生循环使用后,纤维交换容量未见明显变化。     

INTROMISSION OF WATER-REPELLENT AND HYDROSCOPIC PROPERTIES SIMULTANEOUSLY TO PP BY PLASMA DISCHARGE METHOD

Plasma-induced surface graft copolymerization of acrylic acid on polypropylene non-woven fabric (PP-g-AA) and polypropylene membrane were reported. The extents of grafting were controlled by the plasma and polymerization condition. Hexadecyltrimethyl ammonium bromide was then coupled with the carboxyl group of PP-g-AA to obtain a polyion complex (PIC). At last, CF4 plasma was used to give PICs hydrophobic property. The moisture regain and water-repellency of the processed PICs was investigated. The surfaces were characterized using ATR FT-IR and XPS. The result indicates that the products have very high ability to adsorb moisture, even better than cotton fiber. At the same time, the products show excellent hydrophobic property, which can‘t be wetted by those reagents whose surface tensions were higher than 327mN/m.     

碳纤维微电极恒电位活化及测定金属离子的研究

碳纤维微电极已被广泛应用于电化学研究和分析测定,该电极尺寸极小,在分析性能上与常规电极有显著不同,在不镀汞的情况下,用碳纤维电极直接测定金属离子几乎没有明显的伏安响应,本文提出用+2.5 V恒电位预先活化碳纤维电极,使测定灵敏度大为提高,在双电极体系和静止溶液中,采用溶出伏安法可测定10~(-9)级金属离子,以同样的方法清洗电极,测定结果重现性良好,由于分析过程中不使用汞,该电极的测定范围大大增加,特别是用于氧化还原电位较正的金属离子测试,根据循环伏安法、扫描电镜和电子能谱的研究,发现碳纤维表面状况在处理前后有很大变化,并与测定灵敏度密切相关。     

Adsorption separation of terpene lactones from Ginkgo biloba L. extract using glass fiber membranes modified with octadecyltrichlorosilane

In this study porous glass fiber membranes were modified by reaction with octadecyl-trichlorosilane to form C18 hydrophobic membranes. The contact angle and the CH2 vibration bands at 2855 and 2920 cm(-1) found by FTIR measurements verified the successful immobilization of C18 groups on the glass fiber membranes. The resulting C18 hydrophobic membranes were used to adsorb terpene lactones from crude Ginkgo biloba L. extracts. In batch adsorption processes, the modified C18 membranes exhibited a better adsorption performance than commercial C18 solid phase extraction adsorbents. Different desorption solvents were tested and ethyl acetate was found to preferentially desorb terpene lactones from the modified C18 membranes. In flow adsorption experiments at 1 mL/min, terpene lactone contents higher than 6 wt% (the standardized content) could be achieved in the elution step using ethyl acetate.     

STUDIES ON THE PREPARATION OF ZINC-CONTAINING ACTIVATED CARBON FIBERS AND THEIR ANTIBACTERIAL ACTIVITY

1. INTRODUCTION Microbial pollution will bring about various problems in industry and other vital fields, such as causing decomposing of materials, harming people抯 health. In order to reduce these problems, new antibacterial materials have been demanded. Recently, much attention has been paid to inorganic materials including zinc oxide [1~4]. These inorganic antibacterial materials are now substituting for organic materials to avoid releasing noxious organic molecules harmful to humans;…     

MORPHOLOGIES AND GAS SEPARATION PROPERTIES OF MELT-SPUN ASYMMETRIC POLY(4-METHYL-1-PENTENE)HOLLOW FIBER MEMBRANES*

Poly(4-methyl-1-pentene) (PMP) hollow fiber membranes were prepared by the melt-spun and cold-stretch(MSCS) method. Scanning electronic microscopy (SEM) was used to characterize the section and surface structures of themembranes with special asymmetric structure. The preliminary results of gas permeation measurements indicated that the resultant hollow fiber membranes have the potential ability for oxygen/nitrogen separation.