人血清中地尔硫高效液相色谱法测定及药代动力学参数

建立了反相高效液相色谱法监测人口服地尔硫艹卓缓释片后血药浓度。血样用正己烷－氯仿－异丙醇混合溶剂（６０４０５）提取后，以Ｃ１８化学键合硅胶为固定相，甲醇－水－三乙胺为流动相，安定为内标，在２３９ｎｍ波长处定量检测。血药浓度在１５～３００μｇ／Ｌ范围内线性关系良好，最低检测浓度为３μｇ／Ｌ。批内（ｎ＝７）及批间（ｎ＝５）测定相对标准偏差分别小于６．８％和８．４％，回收率为９１％～１０４％。监测了８名健康人口服盐酸地尔硫艹卓缓释片后的不同时间的血药浓度变化，计算了有关的药代动力学参数。     

Vapor pressure,speciation, and chemical activities in highly concentrated sodium borate solutions at 277 and 317°C

The system H₂O-B₂O₃-Na₂O has been studied experimentally at 277 and 317°C. The activities of water and boric acid have been determined at mole ratios Na/B from 0 to 1.5, and total dissolved solids 3 to 80 weight percent. The activity of boric acid has been fitted to within experimental error using a speciation model with eight complex species. This model is consistent with the model previously published by Mesmer et al. The electrolyte properties of the liquid are modeled using the Pitzer-Simonson model of very concentrated electrolyte solutions. The calculated values of water activity agree with experiment, and the activity of NaOH and pOH have also been calculated. The potassium borate system also was briefly studied at 317°C, and is adequately described by a model with five complex species. The potassium borate liquid is more alkaline at K/B= 1 than a sodium borate liquid at the same mole ratio, but pOH in the two systems is the same at lower mole ratios.     

烷基和烷基苯磺酸钠系列的反相高效液相色谱法

用移动相中含有磷酸二氢钠的反相高效液相色谱法分析了烷基磺酸钠和烷基苯磺酸钠。对前者用电导检测器直接进行检测(无抑制柱),后者用紫外检测器检测。对几种商品十二烷基苯磺酸钠的组分和微乳液中十二烷基磺酸钠的含量进行了测定。得到了满意的结果。     

Influence of channeling effects on ion distribution and damage profiles during high energy ion implantation in Si

Nitrogen implantation has been performed in silicon [001] crystals in carefully controlled alignment conditions. The channeling effects are clearly evident when implanting in [001] and [011] directions at energies ranging from 0.6 to 1.4 MeV. Both ion distribution and damage profiles are strongly influenced by channeling effects during ion implantation. The angular region around the [001] direction has been also investigated by implanting at small angles with respect to the axis. The same kind of study has been performed by implanting at different angles with respect to the planar (011) direction. The ion distributions (investigated by SIMS) show a strong dependence upon the alignment conditions. Moreover in high energy ion implantation, the lattice damage is located deep inside the crystal, leaving the surface layer almost unperturbed. The channeling effects on the damage production have been investigated by double crystal diffraction (DCD) in the low-dose regime and by RBS-channeling experiments (after implantation at doses greater than 1 × 10¹⁵ cm^–2) and for different ion alignment conditions.A big increase in the ion ranges and a strong reduction in the lattice damage is evident when implanting along major crystal axes. No saturatíon of the lattice damage and of the channelled component of the beam has been detected if the implantation is performed parallel to the [011] axis.     

反相高效液相色谱法的多波长同时测定预混合饲料中的脂溶性维生素A，α－E，D_3，K_3

反相高效液相色谱法的多波长同时测定预混合饲料中的脂溶性维生素Ａ，α－Ｅ，Ｄ＿３，Ｋ＿３李桂凤，李缙扬，郝征红，聂燕，孟兆宏，李学春（山东省农业科学院中心实验室济南２５０１００）１前言对脂溶性维生素的分析，被许多国内外分析专家认为是高难度的分析项目。本...     

蒿甲醚在模拟体内酸碱环境中的代谢动力学研究

 利用高效液相法对蒿甲醚进行了模拟体内酸碱环境的代谢动力学研究 ,测定了蒿甲醚及其代谢产物双氢青蒿素、蒿甲醚呋喃酯的代谢曲线。结果表明 ,蒿甲醚在模拟体内肠道和血液的弱碱性环境条件下半衰期为2 87 2min(计算值 ) ;在模拟体内胃液的酸性环境条件下半衰期为 74 6min ;在两种条件下的主要代谢产物均为双氢青蒿素和蒿甲醚呋喃酯。该方法克服了以往文献所报道方法的一些缺点 ,不仅简化了样品制备方法 ,也提高了检测结果的准确性。     

高效液相色谱法同时测定三元混配除草剂中的甲黄隆、苄嘧黄隆与乙草胺

用高效液相色谱法测定了三元混配除草剂“农家益”中甲黄隆、苄嘧黄隆、乙草胺的含量。甲黄隆、苄嘧黄隆及乙草胺的平均回收率分别为９８．８１％，９９．１０％，９９．７２％，线性关系良好。所建立的方法用于“农家益”的质量控制具有准确、快速、重现性好等优点。     

同时测定食用植物油中抗氧剂叔丁基对羟基茴香醚和2，6－二叔丁基对甲酚的方法

报道了用高效液用色谱法同时测定食用植物油中的抗氧剂叔丁基对羟基茴香醚（ＢＨＡ）和２，６－二叔丁基对甲酚（ＢＨＴ）的实验方法。采用ＺｏｒｂａｘＯＤＳＣ_（１８）色谱住，甲醇：水（９０：１０，Ｖ／Ｖ）作流动相，检测波长为２４５ｎｍ，流速为１ｍＬ／ｍｉｎ。检测下限分别为１５ｎｇ（ＢＨＡ），９０ｎｇ（ＢＨＴ），回收率分别是９６．８％±９．８％（ＢＨＡ），９９．０％±３．２％（ＢＨＴ）。方法快速、准确，灵敏度高。     

拟多维高效液相色谱法分离纯化双峰驼精清中的活性蛋白

利用一种新的高效液相色谱洗脱技术，建立了 ｐＨ缓冲液／离子对二元洗脱模式，对双峰驼精清的两种提取物的反相柱上进行了分离，得到了较纯的活性蛋白组分。该法操作简单、快速、比常规ＨＰＬＣ有更高的选择性及峰容量，并可减少活性蛋白的失活。     

制备高比表面积碳化硅的几种影响因素

采用溶胶凝胶法，以蔗糖和正硅酸乙酯(TEOS)为原料，草酸为TEOS水解的催化剂，制备均相碳化硅前驱体，在氩气氛和高温条件下(1 350～1 600 ℃)将碳化硅先驱体进行碳热还原，制备出高比表面积的SiC。考察了水/TEOS物质的量的比、碳/硅物质的量的比及镍盐等因素对碳化硅比表面积的影响。结果表明，当n_water/n_TEOS=7.5，n_C/n_Si=4时，适宜的镍催化剂(n_Ni/n_TEOS=0.005)，凝胶形成的时间最短，镍盐的加入可使碳热还原温度降低200 ℃。