片式多层电容电阻复合元件的研制

采用低温共烧陶瓷(LTCC)技术将电容、电阻元件集成在多层陶瓷基板里,构成了一种新型的片式多层复合元件,并研究了其制造工艺性能和频率特性。结果表明,片式多层电容电阻复合元件制造工艺适合批量化生产,并为片式多层LC滤波器、LTCC基板及器件的研发提供了极好的参考价值。     

Study of hot bands in the B2Σ+u-X2Σ+g system of C-2 anion

Optical heterodyne magnetic rotation enhanced velocity modulation spectroscopy was employed to observe the visible absorption spectra of the B^2Σ^+_u-X^2Σ^+_g electronic transition of C^-_2. Four hot bands (0,1), (1,2), (2,3) and (3,4) have been observed and the band (3,4) is measured directly for the first time, so far as we know, by absorption. A rotational analysis was carried out to obtain molecular constants. With the Franck－Condon principle and the vibrational Boltzmann distribution, we have estimated the vibrational temperature of C^-_2 to be about 3000K.     

窄带中频数字接收机高速信号处理技术

窄带中频数字接收机在雷达对抗侦察中得到了广泛应用，其高速信号处理技术是目前研究的重点。本文详细介绍了数字雷达告警接收机高速信号处理技术的发展现状和关键技术，最后通过对该技术的全面分析指出了值得深入研究的领域。     

应变Si1-xGex层中p型杂质电离常温和低温特性

本文采用解析的方法计算了应变Si1-xGex层中p型杂质电离度与Ge组分x、温度T以及掺杂浓度N的关系.发现常温时,在同一Ge组分下,随着掺杂浓度的升高,杂质的电离度的先变小,而后又迅速上升到1.在同一掺杂浓度下,轻掺杂时,杂质的电离度随Ge组分的增加先变大,而后几乎不变;重掺杂时,杂质电离能变为0后,杂质电离度为1.低温下,轻掺杂时,载流子低温冻析效应较为明显,杂质的电离度普遍较小,当掺杂浓度大于Mott转换点时,载流子冻析效应不再明显,电离率迅速上升到1.在同一Ge组分下,随着掺杂浓度的升高,杂质的电离度先变小,后变大,而后又迅速上升到1.在同一掺杂浓度下,轻掺杂时,杂质的电离度随Ge组分的增加变大;重掺杂时,杂质电离能变为0后,杂质电离度为1.     

Gas solubility of carbon dioxide in poly(lactic acid) at high pressures: Thermal treatment effect

The sorption of carbon dioxide in glassy Poly(lactic acid) (PLA) films was studied by quartz crystal microbalance (QCM) at high pressures. Two thermal treatments, melted and quenched, were performed in PLA with two different L:D contents, 80:20 and 98:2, films and compared with a third thermal protocol, annealed, and used in a previous work. The results obtained show that for pressures higher than 2 MPa, the carbon dioxide solubility is larger in PLA 80:20 than in PLA 98:2, indicating that the L:D plays a dominant role on this property. The thermal treatments only affect the gas solubility in PLA 98:2. Sorption isotherms at temperatures 303, 313, and 323 K, below the glass transition temperature of the polymer, and pressures up to 5 MPa were measured and analyzed with three different models, the dual‐mode sorption model, the Flory–Huggins equation, and a modified dual‐mode sorption model where the Henry's law term was substituted by the Flory–Huggins equation. This last model performs especially well for CO₂ in PLA 80:20, due to the convex upward curvature of the solubility isotherms for that system. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 616–625, 2007     

Thermal Effects of Microwave Energy in Agricultural Soil Radiation

The thermal treatment by millimeter waves for the soil disinfection can be one possible alternative to chemical treatments. This physical method is based on incrementing the soil temperature and its pathogens irradiating with high frequency electromagnetic waves. So the previous knowledge of the temperature distribution in the irradiated soil is essential for achieving an effective bad microorganism and weed seeds elimination. This report analyse the heating kinetic and spatial distribution of the maximum temperatures reached by the soil. It is presented a mathematic model about how are distributed the reached temperatures in the depth of the irradiated soil. This model concludes that when an orchard soil is irradiated superficially by microwaves, the microwaves have a big attenuation due to the soil dielectric properties and the water located in the pores of the most superficial layer. This fact causes a shield effect blocking the waves penetration in few centimetres. The heating by radiation is reduced to the superficial layer. The heating propagation in the depth is occurred by conduction following the Fourier equations.     

中高温工质在蒸发器中的换热模拟分析

本文采用分布参数的方法,建立了水源热泵中普遍采用的壳管式蒸发器稳态数学模型.通过中高温水源热泵试验台的实验数据同模拟计算结果的对比,验证了数学模型的准确性。应用此数学模型对中高温工质HTR01、HTR02及R134a在蒸发器典型制热运行工况,进行了模拟计算。得出了三种工质制冷剂侧换热系数沿管长的变化关系并对三种工质的换热性能进行了对比分析,为采用中高温工质的水源热泵换热器设计提供了参考依据.     

Excitation of plant growth in dormant temperature by steady magnetic field

Experimental results of applying a steady magnetic field (20 and 30 mT) on agricultural plants reveal that their growth is more than that of control plants. Considering that these plants have ferritin cells, and each ferritin cell has 4500 Fe atoms, it is obvious that they have an outstanding role in the plants’ growth. As the last spin magnetic moment (SMM) of the Fe atom posed to an external magnetic field (EMF), the composition of SMM and EMF create an oscillator in the system. Then we have a moment of force on ferritin cells. This oscillator exerts its energy, then damps and finally locates in the field direction. The relaxed energy increased the internal temperature (i.e., the effective temperature of the magnetic spin system of plant) so that it is situated in a proper temperature for growing. This phenomenon (temperature increasing) occurs in the initial minutes of applying the magnetic field. So it depends on the number of times of locating the plant in magnetic field in a day (n). If this number (n) passes the critical value, the plant reaches a burning temperature and growth is perturbed. In this paper, the plant growth rate and critical temperature in a steady magnetic field were investigated and formulated theoretically. An innovative result in this research is as follows: if a plant's environment was in the dormant temperature, we could increase the internal temperature of the plant by applying a magnetic field n times in a day (for growth).     

碳化硅压腔和高压下的中子衍射

使用宝石级碳化硅晶体作为压砧材料，成功研制出了碳化硅压腔（MAC），并应用全景式MAC进行了高压下物质的中子衍射实验研究。结果表明，MAC是一种既能产生高的压力又具有大的高压样品室的装置，特别适合于高压下的中子衍射研究。     

Low sintering temperature MnZn-ferrites for power applications in the frequency region of 400 kHz

In this paper, the effect of cubic zinc metaborate Zn₄O(BO₂)₆ on the sintering of MnZn-ferrites for medium frequency power applications is investigated. Zinc metaborate is synthesized in the laboratory using zinc oxide and boric acid as metal precursors. As observed, when zinc metaborate is added to the MnZn-ferrites at an optimum amount of 0.02 wt%, it significantly enhances densification and therefore allows, for a given density, reduction of the firing temperature by almost 200 °C. MnZn-ferrites exhibiting power losses of 70 mW/cm³ (measured at a frequency of 400 kHz, magnetic field 50 mT and temperature of 90 °C) are synthesized from conventionally milled powders with average particle diameter 0.6 μm, compacted and fired at 1100 °C. Identical experiments conducted under the same conditions on specimens without zinc metaborate additions revealed power losses greater than 300 mW/cm³, because of insufficient densification.