表面引发原子转移自由基聚合方法合成Fe3O4/PMMA复合纳米微粒

采用表面引发原子转移自由基聚合方法合成了核壳结构的磁性高分子纳米微粒. 作为聚合反应引发剂的3-氯丙酸, 首先与油酸修饰的Fe3O4纳米微粒表面的部分油酸置换, 然后在Fe3O4纳米微粒表面引发甲基丙烯酸甲酯聚合, 合成的纳米复合材料用TEM, FTIR, XRD和DSC表征. 磁性测试结果表明, 所制备的磁性高分子纳米微粒仍具有超顺磁性, 但由于聚合物的存在, 其饱和磁化强度降低.     

Synthesis and characterization of novel poly(vinyl chloride)‐based grafts: Poly(vinyl chloride‐co‐2‐chloropropene) fitted with multiple high‐glass‐transition‐temperature polyolefin branches

The tertiary chlorine (Cl^t) content of vinyl chloride/2‐chloropropene copolymers [P(VC‐co‐2CP)] was determined by NMR spectroscopy. Copolymers containing 6.8–47.0 Cl^t's per P(VC‐co‐2CP) chain were used to initiate the cationic grafting of α‐methylstyrene, norbornadiene, indene, and norbornene with Et₂AlCl under various conditions. Grafting was demonstrated by selective solvent extraction, and the effect of the experimental conditions on the grafting efficiency was examined. Select rheological and thermal characteristics of P(VC‐co‐2CP) grafts, including the glass‐transition temperature, heat deflection temperature, and discoloration upon heating, were studied. P(VC‐co‐2CP) carrying 7–11 poly(α‐methylstyrene) or polynorbornadiene branches per chain raised the glass‐transition temperature to, or above, that of a blend control. P(VC‐co‐2CP)s fitted with polyindene or polynorbornene branches were less effective in raising the mechanical properties. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 3644–3651, 2002     

Laser-Initiated copolymerization of N-vinylpyrrolidone with maleic anhydride and maleimide

This article describes the laser-initiated copolymerization of N-vinylpyrrolidone with maleic anhydride and maleimide via charge transfer complexes. The dependence of copolymer yield on the molar ratios of the monomers in the feed and on the irradiation time is described. Based on the ultraviolet and infrared spectroscopy, and chemical analysis results, a tentative mechanism of polymerization is suggested. The rates of polymerization of several monomer systems are compared. The N-vinylpyrrolidone and maleimide system shows the highest rate of polymerization.     

Activation entropy of electron transfer reactions

We report microscopic calculations of free energies and entropies for intramolecular electron transfer reactions. The calculation algorithm combines the atomistic geometry and charge distribution of a molecular solute obtained from quantum calculations with the microscopic polarization response of a polar solvent expressed in terms of its polarization structure factors. The procedure is tested on a donor–acceptor complex in which ruthenium donor and cobalt acceptor sites are linked by a four-proline polypeptide. The reorganization energies and reaction energy gaps are calculated as a function of temperature by using structure factors obtained from our analytical procedure and from computer simulations. Good agreement between two procedures and with direct computer simulations of the reorganization energy is achieved. The microscopic algorithm is compared to the dielectric continuum calculations. We found that the strong dependence of the reorganization energy on the solvent refractive index predicted by continuum models is not supported by the microscopic theory. Also, the reorganization and overall solvation entropies are substantially larger in the microscopic theory compared to continuum models.     

Photophysics properties of 4-formacyl-triphenylamine and 4,4''''-bisformacyl-triphenylamine

The photophysical processes of 4-formacyl-triphenylamine (FTA) and 4,4'-bisformacyl-triphenyl-amine (BTA) have been studied. The fluorescences of FTA and BTA with donor (triamine) and acceptor (formacyl) moieties show the twisted intramolecular charge transfer (TICT) emission in polar solvents and photoinduced charge transfer (ICT) emission in nonpolar solvents. These could be supported by the solvent effect, temperature effect and the quenching process by strong electron-deficient compounds.     

Crosslinked poly(ethylene oxide) modified with tetraalkylammonium salts as phase transfer catalyst

Radiation crosslinked poly(ethylene oxide)s (PEO) modified with two tetraalkylammonium salts: allyldimethyldodecylammonium bromide and ethylmethacrylate dimethyldodecylammonium bromide were prepared. They have been characterized by elemental analysis, IR, ¹H-NMR spectra, and DSC measurements. Their activity as phase transfer catalysts (PTC) in the model displacement reaction of 1-bromooctane with aqueous sodium cyanide were studied. The reaction kinetics were followed under pseudo-first-order conditions. Small amounts of onium salt inserted into the PEO network gave rise to a five time increase in the rate constant. The recovered catalysts could be re-used without loss of activity. © 1995 John Wiley & Sons, Inc.     

A comparison of thermoreactive water-soluble poly-N,N-diethylacrylamide prepared by anionic and by group transfer polymerization

Several batches of poly-N,N-diethylacrylamide were synthesized by anionic and by group transfer polymerization (GTP). A radical poly-N,N-diethylacrylamide prepared from the same monomer was also included in the comparison. According to matrix-assisted laser desorption/ionization mass spectrometry (MALDI-MS) both types of living polymerization resulted in narrow molecular weight distributions with M_w/M_n values below 1.5. Average molecular weights (M_n) between 888 and 4678 g/mol were calculated in these cases. The radical polymer had an average molecular weight (M_n) of approximately 130,000 g/mol. The dry anionic and GTP polymers were investigated by differential scanning calorimetry (DSC) and x-ray diffraction spectrometry. Evidence for partial crystallinity in the solid state was found. The conformation of all polymers was examined by high resolution (600 MHz) NMR. According to these measurements, 75% of the ? CHR? groups of the anionic poly-N,N-diethylacrylamide were located in an isotactic triade. The remaining 25% had heterotactic structure, while no indication for the presence of syndiotactic protons was found. Poly-N,N-diethylacrylamide prepared by GTP, on the other hand, had mainly syndiotactic structure. The aqueous solutions of the polymers showed phase separation upon heating. Whereas the lower critical solution temperature (LCST) was approximately 30°C in the case of the poly-N,N-diethylacrylamide prepared by GTP and by radical polymerization, uncommonly high LCSTs of more than 40°C were observed for the anionic poly-N,N-diethylacrylamide. © 1994 John Wiley & Sons, Inc.     

De novo design, synthesis, and function of semiartificial myoglobin conjugated with coiled-coil two-alpha-helix peptides

The introduction of a flavin chromophore on the myoglobin (Mb) surface and an effective electron-transfer (ET) reaction through the flavin were successfully achieved by utilizing the self-assembly of heterostranded coiled-coil peptides. We have prepared a semiartificial Mb, named Mb-1alphaK, in which an amphiphilic and cationic alpha-helix peptide is conjugated at the heme propionate (Heme-1alphaK). Heme-1alphaK has a covalently bound iron-protoporphyrin IX (heme) at the N terminus of a 1alphaK peptide sequence. This sequence was designed to form a heterostranded coiled-coil in the presence of a counterpart amphiphilic and anionic 1alphaE peptide sequence in a parallel orientation. Two peptides, Fla(1)-1alphaE and Fla(31)-1alphaE, both incorporating a 10-methylisoalloxazine moiety as an artificial flavin molecule, were also prepared (Fla=2-[7-(10-methyl)isoalloxazinyl]-2-oxoethyl). Heme-1alphaK was successfully inserted into apomyoglobin to give Mb-1alphaK. Mb-1alphaK recognized the flavin-modified peptides and a two-alpha-helix structure was formed. In addition, an efficient ET from reduced nicotinamide adenine dinucleotide to the heme center through the flavin unit was observed. The ET rate was faster in the presence of Fla(1)-1alphaE than in the presence of Fla(31)-1alphaE or the equivalent molecule that has no peptide chain. These results demonstrate that the introduction of a functional chromophore on the Mb surface can be achieved by using specific peptide-peptide interactions. Moreover, the dependence of the ET rate on the position of the flavin indicated that the distance between the heme active site and the flavin chromophore was regulated by the three-dimensional structure of the designed polypeptide.     

Transport properties of separating membranes MF-4SK during alkaline electrolysis of water

The transport properties of separating membranes MF-4SK are studied during electrolysis of H₂O in solutions of KOH. The effective diffusion coefficients of molecules of KOH and H₂O and the transfer coefficients of ions K⁺ and OH^? and molecules of H₂O are measured at KOH concentrations reaching 11 M, currents reaching 0.31 A cm^?2, at ambient temperature and at 80°C. In contact with a KOH solution in the concentration interval 0.1 to 11 M, the membranes that initially swelled in H₂O lose a considerable fraction of water that was present in them and the overall volume of clusters and solution-filled channels in them noticeably decreases. The coefficients of transfer by current of ions K⁺ out of anodic compartment into cathodic and the OH^? ions in the reverse direction, respectively, happen to be equal to about 0.6 and 0.4 at ambient temperature and 0.8 and 0.2 at 80°C. The coefficients of transfer of water molecules out of the anodic volume into the cathodic volume in the process of electrolysis happen to be in the limits 1.6–1.9 at ambient temperature and in the limits 2.2–2.8 at 80°C. The effective diffusion coefficients of molecules of KOH and H₂O at moderate concentrations of KOH (5.6 M) amount to ～2.6 × 10^?7 and 30 × 10^?7 cm²s^?1 at ambient temperature and ～4 × 10^?7 and 61 × 10^?7 cm²s^?1 at 80°C, respectively. At a high concentration of KOH (～10 M) these quantities substantially diminish.     

Thermokinetic Studies of the Process for Electrorefining Silver

In this work some calorimetric measurements were also carried out on the electrorefining silver by using different current densities with a Calvet type microcalorimeter at room temperature. The ratio (R) of the measured heat (