Preparation and partial characterization of a soluble site-to-site directed enzyme complex composed of alcohol dehydrogenase and lactate dehydrogenase

A soluble, bifunctional enzyme complex has been prepared by crosslinking lactate dehydrogenase and alcohol dehydrogenase with glutaraldehyde. The crosslinking was performed on a solid phase while the active sites of alcohol dehydrogenase and lactate dehydrogenase were held adjacent to one another with the aid of a bis-NAD analog. Subsequently, the enzyme complex was released from the solid phase. The soluble enzyme complex was then purified by using NAD-Sepharose as an affinity adsorbent. Based on gel filtration experiments, the complex was estimated to consist of one of each dehydrogenase. By using a third enzyme, lipoamide dehydrogenase, which competes with lactate dehydrogenase for NADH produced by alcohol dehydrogenase, the effect of site-to-site orientation was studied. It was found that about 83% of the NADH produced by alcohol dehydrogenase was oxidized by site-to-site oriented lactate dehydrogenase compared to a figure of only about 61% obtained in an identical system of separate enzymes. This indicates that given two alternative routes, the preference for the one to lactate dehydrogenase over the one to lipoamide dehydrogenase is enhanced when lactate dehydrogenase and alcohol dehydrogenase are site-to-site oriented.     

往复挤压准晶增强快速凝固Mg92.5Zn6.4Y1.1合金

采用往复挤压工艺将快速凝固Mg92.5Zn6.4Y1.1合金薄带在330℃挤压2道次和4道次,然后正挤压制成Φ10 mm的棒材。用OM,TEM,XRD及DTA研究了往复挤压过程中准晶相I-Mg3YZn6弥散析出及对力学性能的影响。研究表明,往复挤压有利于快速凝固Mg92.5Zn6.4Y1.1合金薄带的焊合,获得组织致密、均匀、高强韧合金。往复挤压2道次,相组成为-αMg和准晶I-Mg3YZn6,脱溶析出纳米准晶相较少;4道次相组成为-αMg和准晶I-Mg3YZn6及MgZn相,脱溶弥散析出的纳米I-Mg3YZn6准晶相及MgZn相较多。往复挤压提高材料的拉伸性能,其主要原因是细晶强化和析出强化。     

低钴AB5型稀土系贮氢电极合金的研究

为了进一步降低AB5型混合稀土系贮氢合金的成本,采用Cr,Si,Cu替代Co和调节化学计量比的方法制备低钴AB5型贮氢合金。结果表明:3种取代元素在寿命方面的效果依次为Si>Cr>Cu,在放电容量和活化性能方面依次是Cu>Cr>Si。Cr,Cu,Si只有少量的替代才可能发挥其有利影响;通过非化学计量比的调节,低钴混合稀土系贮氢电极合金的放电容量、活化性能及倍率放电能力都能较好地达到实用要求,但是循环寿命有待提高。     

铜(Ⅱ)-铬天青S-过氧化氢体系催化光度法测定痕量铜

本文研究了在氨水介质中,痕量铜对过氧化氢氧化铬天青S褪色反应的催化作用,建立了一个催化光度法测定痕量铜的新方法。线性范围为0～20ng/mL,检出限为5.59×10~(-11)g/mL,并用于铝合金标准样品,环境标准样品和自来水中痕量铜的测定。     

Differential scanning calorimetry and the advanced solidification processing of metals and alloys

This paper describes some examples of the use of differential scanning calorimetry (DSC) in providing information for advanced solidification processing of metals and alloys. Spray forming, squeeze casting, grain refinement and crystallization of amorphous alloys are all discussed. DSC measurements are shown to be valuable for testing kinetic theories of nucleation and growth, and validating solidification process models.     

Printed plastic electronics and paperlike displays

Plastic electronic materials and high‐resolution printing methods may be important technologies for new classes of consumer electronic devices that are lightweight, mechanically flexible and bendable, and that can cover large areas at low cost. This article summarizes some of our recent work in this area. It focuses on the materials and patterning techniques that we used to produce plastic active‐matrix backplane circuits for a type of paperlike display. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 3327–3334, 2002     

Corrosion-stable nickel- and cobalt-based alloys for dental applications

In a comparative study the in vitro corrosion behavior of a selection of nickel- and cobalt-based alloys for application in dentistry containing no noble metals was studied with slow scan cyclic voltammetry. The obtained breakthrough potentials, the repassivation behavior and further typical features of the cyclic voltamograms are correlated with the chemical composition as measured with electron beam microanalysis. Surface inhomogenities detected with the latter method are discussed with respect to the electrochemical behavior. For all alloys stabilities in terms of breakthrough potential superior to previously reported data for nickel-base alloys are found.     

W／O型微乳液中超氧化物阴离子的产生——微环境中SOD酶活性测定方法 …

分别在水溶液中和W／O型CTAB／正戊醇／异辛烷／水微乳液体系中研究了测定SOD酶活性的邻苯三酚法,发现在反向微乳液中,"小水池"的低介电常数和pH抑制了底物超氧化物阴离子O2-·的产生．只有提高外加缓冲液的pH或"小水池"的水化度,才能得到所需浓度的O2-·,从而初步解决了在微乳液中SOD作用底物的产生问题,为在微乳液中准确测定SOD酶活性创造了条件．     

Characterization of the Converging Jet Region in a Triple Torch Plasma Reactor

Enthalpy probe measurements were taken of the converging plasma plume in a triple torch plasma reactor and related to substrate heat flux measurements. Results show excellent entrainment of process gases injected into the converging plasma plume by way of the central injection probe. At lower pressures (40 kPa), the plasma volume is equivalent to at least a 3 cm diameter, 4 cm long cylinder, with relatively uniform temperature, velocity, and substrate heat flux profiles when compared to a typical dc arc jet. Converging plasma plume size, substrate heat flux, and enthalpy profiles are also shown to be a strong function of applied system power. Substrate heat flux measurements show smaller radial gradients than enthalpy probe measurements, because of the high radial velocity component of gases above the substrate boundary layer. Enthalpy probe measurements were also conducted for diamond deposition conditions and approximate temperature and velocity profiles obtained. Problems with the uniform gas mixture assumption prohibited more accurate measurements. Reproducibility of enthalpy measurement results was shown with an average standard deviation of 11.8% for the velocity and 7.6% for the temperature measurements.     

Determination of trace silver by solid substrate room temperature phosphorescence quenching method based on lead carboxymethyl cellulose particles (Pb(CMC)2) containing luminescent salicyl fluorenes molecules

Luminescent particles of lead carboxymethyl cellulose (Pb(CMC)2) containing salicyl fluorones (THBF), Pb(CMC)2-THBF were synthesized by the sol-gel method, using sodium carboxymethyl cellulose (NaCMC) as precursor and Pb2+ as precipitant. Pb(CMC)2-THBF can emit the intense and stable solid substrate room temperature phosphorescence (SS-RTP) on filter paper. And EDTA can chelate Pb2+ in Pb(CMC)2-THBF, causing it to decompose into aqueous soluble components PbY2-, CMC- and THBF, which can react with Ag+ to form Ag(CMC)2-THBF, causing the decrease of phosphorescence intensity. Based on the facts above, a new method for the determination of trace silver by SS-RTP quenching method was established. The linear range of this method is 8.0-40.0 fg spot(-1) (20.0-100.0 pg ml(-1)), with a detection limit (LD) of 2.2 fg spot(-1) (corresponding to a concentration range of 5.5 x 10(-13) g ml(-1)), and the regression equation of working curve is DeltaI(p) = 12.56 + 0.5527C(Ag+) (fg spot(-1), 0.4 microl spot(-1)), n = 8, r = 0.9992. This method has been applied to the determination of trace silver in human hair and tea sample with satisfactory results. The mechanism of SS-RTP emission is also discussed.