Preparation of antimicrobial poly(vinyl alcohol) nanofibers containing silver nanoparticles

Polyvinyl alcohol (PVA) nanofibers containing Ag nanoparticles were prepared by electrospinning PVA/silver nitrate (AgNO₃) aqueous solutions, followed by short heat treatment, and their antimicrobial activity was investigated for wound dressing applications. Since PVA is a water soluble and biocompatible polymer, it is one of the best materials for the preparation of wound dressing nanofibers. After heat treatment at 155 °C for 3 min, the PVA/AgNO₃ nanofibers became insoluble, while the Ag⁺ ions therein were reduced so as to produce a large number of Ag nanoparticles situated preferentially on their surface. The residual Ag⁺ ions were reduced by subsequent UV irradiation for 3 h. The average diameter of the Ag nanoparticles after the heat treatment was 5.9 nm and this value increased slightly to 6.3 nm after UV irradiation. It was found that most of the Ag⁺ ions were reduced by the simple heat treatment. The PVA nanofibers containing Ag nanoparticles showed very strong antimicrobial activity. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 2468–2474, 2006     

The Effect of Boundary Conditions on Gas-phase Synthesised Silver Nanoparticles

We have prepared spherical non-agglomerated silver nanoparticles by an evaporation–condensation–dilution/cooling technique. Silver was evaporated from a crucible in a tubular flow reactor. A porous tube diluter was used to quench the carrier gas at the outlet of the reactor to enhance the formation of small particles and to suppress agglomeration and other particle growth mechanisms. The number size distribution of the prepared particles was measured with a differential mobility analyser–condensation nucleus counter combination and the size and the shape of the particles were analysed with transmission electron microscope. The system was modelled using a sectional aerosol dynamics computer code to estimate the importance of different aerosol processes. In all conditions the particles obtained were non-agglomerated and spherical. The mean particle diameter varied from 4 to 10-nm depending on boundary conditions. From the modelling studies it can be concluded that the nucleation rate is the most important parameter controlling the final particle size.     

用干涉方法测量薄膜应力

基于基片弯曲法和牛顿环的基本原理,使用He-Ne激光器、扩束镜、凸透镜和带分光镜的移测显微镜,搭建了薄膜应力测量装置.采用直流溅射法制备了厚度为30~144 nm的银薄膜,衬底采用厚度为0.15 mm、直径为18 mm的圆形玻璃片.实验发现,薄膜厚度对银薄膜的内应力有显著的影响,在薄膜厚度很小时,随着薄膜厚度的增加,应力迅速增大,达到最大值后,随着厚度的继续增加,薄膜应力下降较快并趋于稳定值.     

退火温度对Fe基纳米晶粉芯磁致频移特性影响的研究

研究了充有不同温度退火Fe基纳米晶粉芯LC回路的磁致频移特性（MFS），发现充有不同温度退火Fe基纳米晶粉芯LC回路的磁致频移不同，充有经600℃退火Fe基纳米晶粉芯LC回路的磁致频移最灵敏。     

改性壳聚精膜用于醇水混合液分离的研究──Ⅲ．超细粉末填充壳聚精膜

首次制备了用Ｓｉ３Ｎ４，ＳｉＯ２，ＴｉＨ４超细粉末填充的改性壳聚精膜，并将其用于乙醇／水混合液的分离中。实验表明壳聚糖膜经超细粉末填充后强度增大，溶胀度减小。用于乙醇／水混合液渗透蒸发分离时，分离因子和渗透通量都有提高，并在填充量为１６．７％附近出现极大值。随着料液中乙醇含量的增大，渗透通量减小，分离因子增大；随着料液温度的升高渗透通量显著增大，分离因子则稍有下降。并简单讨论了超细粉末在乙醇／水混合液分离中的作用。     

NiCuZn铁氧体和银内电极的共烧行为

NiCuZn铁氧体正作为磁介质广泛地应用于低烧多层片式电感，因此有必要对其与银内电极的共烧行为进行研究。该文主要介绍NiCuZn铁氧体／银内电极多层复合体共烧过程中的烧结收缩、界面反应、扩散对介质性能的影响。尖晶石结构中存在相当数量的空位，这为银离子提供了一定的溶解度，因此在共烧过程中银对铁氧体的相组成影响较小。银对铁氧体性能的影响体现在两个方面。一方面是由于银具有相对低的烧结温度，从而在烧结过程中起到助烧剂的作用，促进致密化过程，提高烧结体的密度和磁导率；另一方面，银促使铁氧体中的铜在晶界处析出，导致晶界处应力，使磁导率降低，晶粒生长也被一定程度地抑制。     

Surface-enhanced Raman scattering study of polymer on metals. III. Chemisorbed polybenzimidazole and its corrosion-inhibiting properties at high temperature

Chemisorption of polybenzimidazole on silver and copper etched with nitric acid has been observed by surface-enhanced Raman scattering (SERS). The polymer is found to react chemically with silver, forming a complexed film on the surface. The SERS spectra show that polybenzimidazole film inhibits oxidation of the metal at high temperature, unlike chemisorbed benzimidazole, benzotriazole, and poly(4-vinyl pyridine). © 1992 John Wiley & Sons, Inc.     

矿渣粉加固粉土的理论分析及路用性能研究

提出了矿渣粉加固粉土的相关理论。将矿渣粉在加固土中的作用归结为火山灰胶凝效应和微集料填充效应,而火山灰胶凝效应又可进一步归结为水化作用、激发作用和离子交换作用;认为微集料填充效应与矿渣粉细度极为相关;用框图归纳了矿渣粉加固土的两种作用效应。进行了矿渣粉、石灰粉加固土无侧限饱水抗压强度、水稳定性、冻稳定性、温度收缩和干燥收缩等路用性能试验,并进行比较。结果表明,矿渣粉加固土所测路用性能指标优于石灰粉加固土。为工程应用提供了试验依据。     

用于同步辐射光源的成像板粉末衍射系统

报道了我们研制的一套成像板粉末衍射装置,对其误差来源进行了详细的分析讨论,并与衍射仪进行了比较.该装置的半径为143.3mm,最大测量角度范围不160°，最大角度(2q )偏差小于0.03°,这些性能指标已被实验所证实,完全可应用于粉末衍射全谱的测量.     

Dimer of Bis[trans-5-methyl-2-[2-（4-methoxylphenyl） ethenyl]-benzoxazole]di-μ-nitratosilver（I）

1 INTRODUCTION We are presently involved in the synthesis and photodimerization of the analogues of trans-2-sty- rylbenzoxazole (BOEP), which have been widely reported as fluorescent whiteners and remedies[1]. Some structures of BOEP derivatives and thei…