Simulation and fabrication of carbon nanotubes field emission pressure sensors

A novel field emission pressure sensor has been achieved utilizing carbon nanotubes (CNTs) as the electron source. The sensor consists of the anode sensing film fabricated by wet etching process and multi-wall carbon nanotubes (MWNTs) cathode in the micro-vacuum chamber. MWNTs on the silicon substrate were grown by thermal CVD. The prototype pressure sensor has a measured sensitivity of about 0.17-0.77 nA/Pa (101-550 KPa). The work shows the potential use of CNTs-based field-emitter in microsensors, such as accelerometers and tactile sensors.     

天光一号预放大器中的放大自发辐射效应

 在三维放大自发辐射（ASE）的模拟计算中，计入了侧壁反射效应以及KrF自发辐射的谱线形状（高斯型、洛伦兹型及平顶型）的影响，并对空间网点的影响进行了考察。经过综合分析，给出了ASE对预放大器放大特性影响的上、下限范围。当计入平顶型频谱分布，壁反射系数为 0 .2时，与不计入ASE的情形对比，天光一号预放大器的提取效率下降为35%。     

Effects of trapped electrons on the line shape in emission Mössbauer spectra

To explain line broadening in emission Mössbauer spectra as compared to the corresponding absorber measurements, the model of trapped electrons has been proposed. Auger electrons (emitted, e.g. after electron capture by ⁵⁷Co or after the converted isomeric transition of ^119mSn), as well as secondary electrons, may be trapped in the proximity to the nucleogenic ion. Electrons captured by lattice traps at different distances from the daughter ion induce an asymmetric distribution of quadrupole splitting in the resulting emission spectra, as shown in a few examples. This model is supported by estimates of quadrupole splitting values which may be caused by such trapped electrons located at specified distances from the nucleogenic atom.     

双光束相干控制产生多次谐波的实验验证

利用两束相干度可改变的飞秒脉冲光对产生的五次谐波的强度特性进行了研究，发现谐波信号的强度随相干程度的增大而增加，谐波信号的最大值相对于相干零点(双光束相干度最大处)是非对称的，从而证明了合成的激光脉冲波形变化对谐波信号的影响.同时对谐波的受激放大理论进行了初步的实验探索和展望. 关键词： 五次谐波 波形变化 相干 受激放大     

Luminescence enhancement by hydrogenation of Si:Er,O

Erbium (Er)- and oxygen (O)-doped Cz–Si was additionally doped with hydrogen, using plasma enhanced chemical vapour deposition. Photoluminescence (PL) spectra show a large enhancement especially for samples treated with solid phase epitaxy before hydrogenation and annealing at 900°C later. Secondary ion mass spectroscopy measurements give evidence for an enhanced diffusion of O and Er at this temperature towards the surface. Etching shows that the PL does not stem from the heavily doped surface layer but from a deeper region with lower Er concentration. This conclusion is supported by the appearance of the so-called “cubic” centre with low solubility. Comparing the PL yield of the hydrogenated samples to that of samples with similar Er volume concentration but without hydrogenation still gives a large enhancement. We thus conclude that hydrogen can enhance the solubility of the cubic centre in Si:Er,O.     

Decay distribution of spontaneous emission from atoms in one-dimensional photonic crystal

Spontaneous emission behavior from atoms (or molecules) in one-dimensional photonic crystal with a defect is investigated. Taken all the TE and TM modes into account, the normalized spontaneous emission rate of the atom is calculated as a function of the position of the atom in the crystal. Results for both nonabsorbing dielectric structure and absorbing dielectric structure are presented. With the increase of the thickness of the defect in which the atoms are embedded, the oscillations of the spontaneous emission rate versus the position of the atom become dense and the lifetime distribution becomes narrow and sharp. The PC effect may lead to the coexistence of both accelerated and inhibited decay processes.     

原子的吸收光谱和发射光谱的演示

介绍了利用光学多道分析仪和投影仪在课堂上实时演示原子的吸收光谱和发射光谱的实验方法。     

Dislocation unpinning model of acoustic emission from alkali halide crystals

The present paper reports the dislocation unpinning model of acoustic emission (AE) from alkali halide crystals. Equations are derived for the strain dependence of the transient AE pulse rate, peak value of the AE pulse rate and the total number of AE pulse emitted. It is found that the AE pulse rate should be maximum for a particular strain of the crystals. The peak value of the AE pulse rate should depend on the volume and strain rate of the crystals, and also on the pinning time of dislocations. Since the pinning time of dislocations decreases with increasing strain rate, the AE pulse rate should be weakly dependent on the strain rate of the crystals. The total number of AE should increase linearly with deformation and then it should attain a saturation value for the large deformation. By measuring the strain dependence of the AE pulse rate at a fixed strain rate, the time constantτ _s for surface annihilation of dislocations and the pinning timeτ _p of the dislocations can be determined. A good agreement is found between the theoretical and experimental results related to the AE from alkali halide crystals.     

Simulation of Vacuum Microelectronic Triode Made of Single Carbon Nanotube

Vacuum microelectronic triode performance, based upon a unit cell with a nanotube field emitter, gate, and anode, was evaluated via computer simulation. Electron emission was calculated from the modified Fowler-Nordheim equation. The dependence of emitted current, upon geometrical factors, e.g., nanotube radius, nanotube height, and gate's hole radius, is shown. The device design parameters of trans-conductance, and cutoff frequency have been calculated, which show that this structure can be used as a microwave and millimeter wave amplifier. Electron current flux is shown for time-dependent 1–Thz sinusoidal variation frequency input.     

绿色荧光粉YAGG∶Tb,Gd用于FED的尝试

FED器件的发展迫切需要具有化学和热稳定性 ,高亮度 ,长寿命的新型荧光材料。本文合成了Gd3 +离子共掺杂的YAGG∶Tb获得了YAGG∶Tb ,Gd ,并将其用于 0～ 30 0 0V低压范围 ,对其在不同电压和电流密度下的发光特性进行了测试。结果表明 ,该种材料特性优于ZnO∶Zn并且不存在电压与电流饱和