聚合物共混物脆韧转变性能研究 Ⅲ.分散相形态参数之间的关系

为了研究形态（特别是分散状态）对聚合物共混物韧性的影响，建立了准网络形态模型，定义了分散相分布系数（ξ，０＜ξ１），并给出其物理意义，推导了基体层厚度的计算公式，研究了形态参数的变化对基体层厚度的影响．对于常见的无规形态，ξ≈１．对于准网络形态，ξ＜１，并且不是常数．计算结果表明，减小ξ和分散相粒径及其分布、增大其体积分数有利于减小基体层厚度．从理论上证明了准网络形态比无规形态更有利于减小基体层厚度．     

带电胶体离子扩散与交换动力学的比较

Taking soil colloid and hydrated silica (quartz sand) as the experimental material, the comparative study has been made on the kinetics of ion diffusion and ion exchange in charged colloid and charged coarse disperse systems. The results showed that ion exchange kinetics in the two systems conform to the kinetic law of ion diffusion. Besides, through this comparative study on the kinetics of ion exchange and ion diffusion, a method has been advanced theoretically to estimate the quantity of adsorbed ion that is located in the inner of the Helmholtz layer. As far as hydrated silica is concerned , there were about 33 per cent of the total adsorbed quantity of Mg2+that were located in the inner of the Helmholtz layer under the given experimental conditions, bu tfor soil colloid the percentage was only 7.5.     

Dispersion polymerization of methyl methacrylate: Mechanism of particle formation

The mechanism for the formation of micron-size polymer particles in the dispersion polymerization of methyl methacrylate was investigated by applying dynamic light scattering to monitor the evolution of the average particle size in the early stages of the polymerization. In addition, the contributions of physically adsorbed stabilizer and graft copolymer were evaluated by measuring the bound, unbound (adsorbed), and free stabilizer, and by determining the amount of added stabilizer required in seeded dispersion polymerizations. Twenty nanometer particles (termed nuclei) were the smallest particles detected and are considered to be formed by aggregation of growing polymer chains precipitating from solution as they exceed their critical chain length. Aggregation of these nuclei with themselves and their aggregates continues until mature and stable particles are formed. This occurs when sufficient stabilizer occupies the particle surface which includes both the polymeric stabilizer [poly(vinylpyrrolidone)] and its graft copolymer which is created in situ. The effects of process variables are discussed based on this mechanistic picture of the dispersion polymerization process. © 1994 John Wiley & Sons, Inc.     

带甲基侧基的环氧树脂增容剂对炭黑在丁苯橡胶中分散度的影响

用自制的带甲基侧基的环氧树脂(TMBP)作为界面增容剂, 从拉伸性能、键合胶含量、动态性能、扫描电镜和流变性能等方面, 研究了TMBP对炭黑在丁苯橡胶中分散度的影响, 并与市售通用双酚A型环氧树脂(E-51)和橡胶工业常用软化剂邻苯二甲酸二辛酯(DOP)进行了比较. 结果表明, 带甲基侧基的环氧树脂TMBP在提高炭黑分散性方面的效果远比E-51好， 其作用模式具有典型的增容特性.     

Comparison of the Diffusion of Aqueous Glycine Hydrochloride and Aqueous Glycine

A Taylor dispersion tube has been used to measure mutual diffusion in aqueous solutions of glycine hydrochloride at 25°C and concentrations from 0.0005 to 0.5 M. Analysis of the dispersion profiles shows that the diffusion of glycine hydrochloride (GlyHCl) produces a subtantial additional flow of hydrochloric acid that is liberated by the dissociation: GlyH⁺ + Cl^- Gly + H⁺ + Cl^-. Diffusion in this system is, therefore, a ternary process described by the equations J ₁(GlyHCl) = – D ₁₁C ₁ – D ₁₂C ₂ and J ₂(HCl) = –D ₂₁C ₁ – D ₂₂C ₂ for the coupled fluxes of total glycine hydrochloride (1) and hydrochloric acid (2) components. The ratio D ₂₁/D ₁₁ of measured diffusion coefficients indicates that up to two moles of HCl are cotransported per mole of GlyHCl. Although protonated glycine diffuses with relatively mobile Cl^– counterions, the main diffusion coefficient of glycine hydrochloride, D ₁₁, is lower than or nearly identical to the diffusion coefficient of aqueous glycine. A model for the diffusion of protonated solutes is developed to interpret this result and the large coupled flows of HCl. Diffusion coefficients are also reported for the aqueous hydrochlorides of 3- and 4-aminobenzoic acids.     

Chemical Liquid Phase Deposition of Thin Aluminum Oxide Films

Introduction Inorganic oxide films have attracted a lot of interest in the last several decades. Among them, silicon dioxide films are widely used in modern microelectronics, optics and mechanics. This material has been grown by various methods including thermal oxidation, chemical vapor phase deposition, plasma-enhanced chemical vapor phase deposition, and so on.1,2 Recently, Nagayama et al.3 have reported that SiO2 thin films could be produced by a new chemical method of liquid phase depos…     

MoO3、NiO、ZnO在小表面金红石上的分散行为

Dispersion of MoO3, NiO, ZnO on rutile TiO2 with low specific surface area was studied with Mercury Porosimeter, SEM, XPS and Ammonia Extraction method. The dispersion thresholds of MoO3, NiO, ZnO on three rutile TiO2 carriers were obtained with XPS, and com-pared with those on anatase TiO2 with high specific surf are area. Ammonia Extraction method was used to identify the surface oxide species interarting with support surface in different strength and it was found that the proportions of oxides that can not be extracted by ammonia extraction are different for MoO3, NiO and ZnO which are supported on rutile TiO2.     

CuO/γ-Al2O3单分散催化剂的XAFS研究

采用XAFS方法研究浸渍法制备并于低温焙烧的CuO/γ-Al2O3催化剂的局域结构.对于CuO负载量小于单层分散阈值的CuO/γ-Al2O3(0.4 mmol/100 m2),结果表明,CuO物种是以层状分散的孤立原子簇存在于γ-Al2O3载体表面,其第一近邻Cu－O配位环境的结构与晶态CuO的相似,键长和配位数分别为0.195 nm和4.对于CuO负载量等于单层分散阈值的CuO/γ-Al2O3(0.8 mmol/100 m2),已有少量的CuO纳米颗粒生成.对于CuO负载量大于单层分散阈值的CuO/γ-Al2O3(1.2 mmol/100 m2),其结构与多晶CuO的相近.基于CuO在γ-Al2O3载体上的三种不同分散状态的结构特点,我们提出了CuO/γ-Al2O3催化剂的结构模型.     

金属酞菁化合物在TiO2表面的分散研究

Dispersion of copper(Ⅱ) phthalocyanine (CuPc), copper(Ⅱ) phthalocyaninesulfonate (CuPcS) and cobalt(Ⅱ)phthalocyaninetetrasulfonate (CoPcTS) on the surface of titanium dioxide was investigated by XRD, XPS, FT-IR and UV-Vis techniques. Results show that interaction between CuPc and TiO2 was very weak and CuPc was difficult to disperse on the surface of the support. While partly sulfurized CuPcS could be dispersed on the surface of support through sulfo-groups and its dispersion capacity was determined to be 0.085 g CuPcS/g TiO2. Completely sulfurlzed CoPcTS could also be dispersed on the surface of TiO2 as a monolayer and its dispersion capacity was 0.12 g CoPcTS/g TiO2. Interactions of the sulfo-groups as well as the electrons of CoPcTS with the surface of TiO2 could be evidenced by FT-IR characterization. Therefore, it was suggested that CoPcTS molecules be adsorbed on the surface of TiO2 in a flat-lying mode while CuPcS in a slanting one. UV-Vis spectra show that the dispersed CuPcS and CoPcTS molecules exist in both forms of monomers and dimers.     

Application of matrix solid-phase dispersion in the analysis of priority polycyclic aromatic hydrocarbons in fish samples

The performance of matrix solid-phase dispersion (MSPD) for the extraction of polycyclic aromatic hydrocarbons (PAHs) in fish tissue is described. The suitability of different solid supports was tested as well as the influence on the extraction efficiency of the natural fat content in samples. Under optimal conditions 0.6-0.8 g of tissue sample, are dispersed with 2 g of octadecylsiloxane (C18) and 0.5 g of anhydrous sodium sulphate and transferred to the top of a polyethylene solid-phase extraction cartridge which already contains 2 g of florisil and 1 g of C18. Cartridges were eluted with acetonitrile. The analysis of the extracts was carried out by high-performance liquid chromatography (HPLC) coupled with fluorescence detection. The proposed method provides detection limits between 0.04 and 0.32 ng/g for the different considered PAHs, below the maximum levels established by the some regulatory bodies for the six PAHs after recent oil spill episodes and European Union regulations. Recoveries over 80% were obtained for all compounds. Accuracy validation was carried out using the US National Institute of Standards and Technology (NIST) SRM 2977 reference material.